Denver TCU-106 User Manual

English

LOCATION OF CONTROL

English

-2

1. CD DOOR

2. AUX IN JACK

3. STEREO HEADPHONE JACK

4. LCD DISPLAY

5. LEFT SPEAKER

6. RIGHT SPEAKER

7. CD/SD/USB BUTTON

8. FOLDER BUTTON

9. SKIP /SEARCH BACKWARD BUTTON 

10. SKIP /SEARCH FORWARD BUTTON 

11. CD STOP BUTTON

13. PROGRAM BUTTON

14. MODE BUTTON

15. FM ANTENNA

16. BAND SWITCH (FM/FM ST.)

17. TUNING KNOB

18. BASS BOOST SWITCH (ON/OFF)

19. FUNCTION SWITCH (RADIO/OFF/CD/AUX)

20. VOLUME CONTROL KNOB

21. AC SOCKET

22. BATTERY DOOR

23. USB PORT

24. SD/MMC CARD SLOT

12. PLAY/PAUSE BUTTON

AC OPERATION

Before operation please ensure voltage on the set corresponds to voltage of your local area. Unravel AC Line Cord; insert one end into AC socket on the set while the other end into a standard AC outlet.

Remarks: 1) In case of malfunction due to electrostatic discharge (ESD), reset the unit

by reconnecting AC cord again to resume to normal operation.

2) When not in use – Unplug AC power cord completely from AC power socket. Warning: The power cable/disconnect device shall remain easy to operate/disconnect. When you are not going to use the unit for a long period of time, disconnect the AC power cord. Where the mains plug or an appliance coupler is used as disconnecting device, the disconnecting device shall remain operable.

BATTERY OPERATION

Disconnect AC cord set completely. Open the BATTERY DOOR and insert UM-2/ “C” size x 8 batteries (not supplied) making sure the indicated battery polarity is observed. When not in use – Remove all batteries if the unit will not be used for several months or more.

RADIO OPERATION

Slide the FUNCTION SWITCH to “RADIO” position. Slide the BAND SWITCH to FM or FM ST. waveband. Turn the TUNING KNOB to your desired radio station. Adjust the sound level by turning VOLUME CONTROL KNOB. To turn off the radio, slide FUNCTION SWITCH to “OFF” position. Note: Radio frequency is shown on LCD DISPLAY.

English

- 3

FM STEREO INDICATOR

When tune to a FM stereo broadcast, FM ST. indicator will light up. In some weak signal area where FM Stereo signal may not be strong enough and can cause excessive background noise, in this case slide the BAND switch to “FM” position.

ANTENNAS

For best reception, fully extend FM ANTENNA to receive FM stations.

BASS BOOST

To increase bass at all volume levels, slide BASS BOOST SWITCH to “ON” position to boost the low frequency tone for an emphasized bass sound. To release super bass simply slide the switch to “OFF” position.

AUXILIARY (AUX) MODE

1. Slide the FUNCTION SWITCH to “AUX” position; “AUX”

indicator will be shown on LCD DISPLAY.

2. Connect the earphone socket from an Auxiliary unit

(e.g. MP3 player or MD player) into AUX-IN jack on this product via an Audio line cord (3.5mm plug on both ends; not supplied).

3. Play the Auxiliary unit. Music from Auxiliary unit can be listened through

the speaker of this product.

STEREO HEADPHONE JACK

For private listening, insert the plug of a Stereo Headphone into STEREO HEADPHONE JACK and adjust VOLUME CONTROL KNOB accordingly. During the use of headphone, speakers are automatically disconnected.

Warning on sound pressure:

The excessive sound pressure from earphones/headphones (not supplied) can cause hearing loss/damage.

CD OPERATION Playing compact disc (CD-R/RW playback compatible) Note: Should skipping of track occur during CD playing, try reduce the

volume. When CD is playing do not open CD DOOR.

1. Pull up the CD DOOR. Put a CD disc into CD Compartment and close the

door. Set the FUNCTION SWITCH to “CD” position. Note: Ensure CD DOOR is closed properly and locked in place.

+ 7 hidden pages