Denver TCP-38 MK2 Instruction Manual

INSTRUCTION MANUAL TCP-38 MK2

www.denver-electronics.com

LOCATION OF CONTROL

3

13

14

15

17
18

19

1

2

5
6
7
8

9

10
11
12

16

4

Power Requirement: AC 220-240V~50Hz
Power Consumption: In Use(Max): 10W/ HOUR
In Standby/Off: <0.5W/ HOUR

GB

1.

2.

3.

4.

5.

6.

7.

8.

9.

LOCATION OF CONTROL

FUNCTION SELECTOR
VOLUME CONTROL
FM ANTENNA

PAUSE, STOP / EJECT,
FAST FORWARD, REWIND,
PLAY
TUNING CONTROL
CD DOOR
BAND SELECTOR
OPEN / CLOSE
DIAL POINTER

10.

11.

12.

13.

14.

15.

16.

17.

18.

19.

SKIP+
SKIP­REPEAT
POWER INDICATOR
LED DISPLAY
FM STEREO INDICATOR
CASSETTE DOOR
PLAY / PAUSE
STOP
PROGRAM

Electric and electronic equipment contains materials, components and substances that can
be hazardous to your health and the environment, if the waste material (discarded electric
and electronic equipment) is not handled correctly.
Electric and electronic equipment is marked with the crossed out trash can symbol, seen
below. This symbol signifies that electric and electronic equipment should not be disposed
of with other household waste, but should be disposed of separately.
All cities have established collection points, where electric and electronic equipment can
either be submitted free of charge at recycling stations and other collection sites, or be
collected from the households. Additional information is available at the technical
department of your city.

ALL RIGHTS RESERVED, COPYRIGHT
DENVER ELECTRONICS A/S

Up to 20 tracks can be programmed for disc play in any order.
Be sure to press the “STOP” button before use.

1. Press the “PROGRAM” button, the display will show “01” and flash.

2. Select desired track by using the “SKIP +” or “SKIP -” button.

3. Press the “PROGRAM” button again to confirm desired track into the program memory.

4. Repeat step 2 and 3 to enter additional tracks into the program memory.

5. When all the desired tracks have been programmed. Press the “PLAY / PAUSE” button to play the
disc in the order you have programmed and the program indicator flashes.

PROGRAM

CD OPERATION

Imported by:
DENVER ELECTRONICS A/S
Stavneagervej 22
DK-8250 Egaa
Denmark
www.facebook.com/denverelectronics

Press the “REPEAT” button before or during playing CD, a single track or all the tracks can be repeated.
Each press switches the repeat mode as follows:
1 - REPEAT 1 ( The repeat indicator is flashing. )
2 - REPEAT ALL ( The repeat indicator is steadily on. )
3 - NORMAL PLAYBACK

REPEAT

6. Press the “STOP” button twice to terminate programmed play and the program indicator will turn off.

REPEAT 1

REPEAT ALL

NORMAL

PLAYBACK

www.facebook.com/denverelectronics