Denver TCM-108 User Manual

Location of controls

(1) FUNCTION SWITCH

CD/POWER OFF/RADIO
(2) BAND SWITCH
(3) FM ANTENNA
(4) CD DOOR
(5) TUNING KNOB
(6) BASS BOOST BUTTON
(7) CD SKIP/SEARCH/FOLDER

FORWARD BUTTON
(8) CD SKIP/SEARCH/FOLDER

BACKWARD BUTTON
(9) CD PROGRAM BUTTON

(10) CD REPEAT BUTTON
(11) CD STOP BUTTON
(12) CD PLAY/PAUSE BUTTON
(13) CD LCD DISPLAY
(14) STEREO HEADPHONE JACK
(15) VOLUME CONTROL KNOB
(16) AC SOCKET
(17) BATTERY DOOR
(18) FM STEREO LED INDICATOR
(19) SPEAKER LEFT
(20) SPEAKER RIGHT

English - 1

AC OPERATION

Before operation please be sure that the VOLTAGE on the set corresponds to
the VOLTAGE of your local area. Unravel the AC Line Cord, insert one end
into the AC jack on the set, and the other end into a standard AC outlet.

BATTERY OPERATION

Disconnect the AC Cord Set completely. Open the BATTERY COMPARTMENT
DOOR and insert UM-2/ “C” size x 8 batteries (not supplied) making sure that
the indicated battery polarity is observed.

RADIO OPERATION

Slide the FUNCTION switch to the “RADIO” position. Slide the BAND switch to
the desired waveband. Turn the TUNING KNOB to your desired radio station.
Adjust the sound level by rotating the VOLUME CONTROL KNOB. To turn off
the radio, simply slide the FUNCTION SWITCH to “POWER OFF” position.

NOTE : Radio frequency is shown on the tuning knob.
FM STEREO INDICATOR

When tuned to a FM stereo broadcast the “FM ST.” LED indicator will light up.
In weak signal areas the FM Stereo signal may not be strong enough and can
cause excessive background noise. In this case, switch to the “FM” position.

ANTENNAS

For best reception, fully extend the FM Antenna to receive FM stations. For
AM reception, the unit has a built-in antenna, turn the whole unit for best
reception.

BASS BOOST

For increased bass at all volume levels, slide the BASS BOOST BUTTON to
“ON” position to boost the low frequency tone for an emphasized bass sound.
To release the super bass, simply slide to “OFF” position.

STEREO HEADPHONE JACK

For private listening, insert the plug of a STEREO Headphone into the
STEREO HEADPHONE JACK and adjust the VOLUME CONTROL KNOB
accordingly. During the use of a headphone, the Speakers are automatically
disconnected.

English - 2

CD OPERATION
PLAYING COMPACT DISC (CD-R/RW PLAYBACK COMPATIBLE)
GETTING STARTED
NOTE: Should skipping of tracks occur during CD playing, try turning the

volume down.
When CD is playing, do not open the CD Door.

1. Open the CD DOOR by pull up the CD DOOR. Put a CD disc into the CD
COMPARTMENT and close the CD DOOR. Set the FUNCTION SWITCH to
“CD” position.
NOTE : Ensure the CD Door is closed properly and locked in place.

2. When the CD DOOR is closed with a CD
inside, total number of tracks of the
disc will be shown on the CD LCD
DISPLAY and will go to stop mode. (ex.
Total 17 tracks inside the disc).

3. If the CD DOOR is not closed or there
is no disc inside, the DISPLAY will show

“

” and go to stop mode.

PLAY/PAUSE MODE

1. When the PLAY/PAUSE BUTTON is

pressed during CD stop mode, the first
track will be played. The PLAY
INDICATOR “

” will be shown on the

LCD DISPLAY. The CD LCD DISPLAY will
show the specific number of track being
played.

2. For interruption while the CD is playing,

press the CD PLAY/PAUSE BUTTON
once. The PAUSE INDICATOR “

” will

be shown on the LCD DISPLAY.

3. Though the sound stops, the disc will

continue to spin. To re-start playing,
press the CD PLAY/PAUSE BUTTON once again. The music will start from
the exact position where it was interrupted.

4. To stop the CD, press the CD STOP BUTTON once whether the CD is in

Play or Pause mode.

5. To turn off the unit, slide the FUNCTION SWITCH to “POWER OFF”

position.

English - 3