Delonghi Pacan140hpec Owner's Manual
5715110901/02.12
made in China -
Instructions for use.
Keep these instructions
Register this product online and receive a
free trial issue of Cook's Illustrated.
Visit www.delonghiregistration.com
Visit www.delonghi.com for a list of
service centers near you.
PORTABLE AIR CONDITIONER
PAC AN140HPEC
Electrical Specifications
115 V~ 60 Hz 10,8 A
Description
ACCESSORIES
1
5
8
4
7
3
9
2
6
10
11
18
12 13 14 15
16 17 19 20
4
Important safeguards
• Use this appliance only as described in this instruction manual.
As with any electrical appliance, the instructions aim to cover as many situations as
possible. Caution and common sense should be used when operating and installing
this air conditioner.
• This appliance has been manufactured to cool and dehumidify domestic environments and must not be used for other purposes.
• It is dangerous to alter or modify the unit's characteristics in any way.
• The appliance must be installed in accordance with the relevant national legislation.
• Should repairs be necessary, contact the nearest authorized Repair Service Center.
Unauthorized servicing can be dangerous.
• The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
• In the case that the power cord becomes damaged, this must be repaired only by specialized personnel authorized by the manufacturer in order to protect against fire.
• Always ensure the appliance is plugged into a grounded 3-prong outlet. If you have any
doubts check with a qualified electrician.
• We strongly discourage the use of an extension cord due to potential safety hazards.
• Before cleaning or maintenance operations, always unplug the unit from the outlet.
• Do not pull on or place strain on the power cord when moving the appliance.
• The appliance should not be installed where the atmosphere may contain combustible gases, oil or sulphur, or near heat sources.
• Do not rest hot or heavy objects on the appliance.
• Clean the filters at least once a week.
• Avoid using heaters near the unit.
• The unit should be transported in a vertical position. If this is not possible secure the
unit at an angle, do not lie it horizontally.
• Before transporting the unit, drain the unit. After transportation, wait at least 6 hours before switching
the unit on.
• The packaging materials can be recycled. You are therefore recommended to
place them in the special containers for differentiated waste collection.
• This appliance is fitted with a special safety device. When the compressor switches
off, this device prevents it from switching on again for at least 3 minutes.
• WARNING: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
SAVE THESE INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD ONLY
5
The instructions below will enable you to prepare your air conditioner for operation as efficiently
as possible.
Before use, make sure the air intake and outlet grilles are unobstructed.
AIR-CONDITIONING WITHOUT INSTALLATION
Just a few simple steps and your comfort is
ensured with your air conditioner:
• Screw the hose adaptor to the hose’s
end .
• Fit the air exhaust hose in the housing at
the back of the appliance. Insert it as
shown in figure A. Be sure it is properly
fixed (check by pulling lightly the hose).
12
13
Preparing for use
ELECTRICAL CONNECTIONS
Before plugging the appliance into the mains socket, check that:
• The outlet’s power supply corresponds to the value indicated on the rating label on the back
of the appliance;
• The outlet and electrical circuit are adequate for the appliance;
• The outlet is a 3-hole grounded outlet . If this is not the case, you must choose another outlet.
Failure to follow these important safety instructions absolves the manufacturer of all liability.
The power cable must be replaced by a qualified professional only.
DESCRIPTION
1 air outlet grille
2 control panel
3 handles
4 castors
5 filter
6 evaporator air intake grille
7 air exhaust hose housing
8 condenser air intake grille
9 power cable
10 drainage hose with 2 caps
11 wall flange with cap
12 air exhaust hose
13 hose adaptor
14 accessory for wall mounting
15 window bracket with pins
16 additional window bracket
17 window outlet
18 remote control
19
end of season dust cover
20 end of season accessories bag
• Screw the window outlet to the other
end of the exhaust hose. (see fig. B).
17
1
2
B
Sash window
• Open the window.
• Place the window bracket in the window, extending it to fit the width of the
window
(fig. C).
• Place the air conditioner near the window. Insert the assembled exhaust hose
into the window bracket hole
.
•
Make sure the air exhaust hose is unobstructed.
• If you have a very large window, in order
to cover your window aperture, use the
additional window bracket without holes
extending it to the desired dimension,
15
12
15
A
Loading...