Delonghi ESAM03.126.S Instruction manuals

De’Longhi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.com

5713226081_01_0317

ESAM03.12X

BEAN TO CUP ESPRESSO

AND CAPPUCCINO

MACHINE

Instruction for Use

EN

page 6

ELECTRICAL REQUIREMENTS

Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply
contact your local electricity company.
The exible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity.
Should this plug not t the socket outlets in your home, it should be cut o and replaced with a suitable plug, following the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of and not left where children might nd it and plug it into a supply
socket - with the obvious consequent danger.

N.B. We recommend the use of good quality plugs and wall sockets that can be switched o when the machine is not in use.
IMPORTANT: the wires in the mains lead tted to this appliance are coloured in accordance with the following code:

Green and Yellow to Earth

GREEN AND YELLOW EARTH
BLUE NEUTRAL
BROWN LIVE

Blue to
neutral

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as
follows:

- The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or
coloured green or green and yellow.

- The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

- The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains lead clamp on the plug. If your electricity
supply point has only two pin socket outlets, or if you are in doubt, consult a qualied electrician.
Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualied electrician and should only be replaced with a exible
cord of the same size.
After replacement of a fuse in the plug, the fuse cover must be retted. If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. The
colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. Always state this colour when ordering
a replacement fuse cover.
Only 13amp replacement fuses which are asta approved to B.S. 1362 should be tted.
This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference.

Warning - this appliance must be earthed

2

A22

A2

A1

A3

A4

A5

A6

A7

A8

A21

A20

A19

A18

A17

A23

B3 B5

B1

B2

B4

B8 B9

A16

B6

B7

A9

A13

A14

A15

A10

A11

A12

B11

B12

B13

B15

B14

B16

B10

B17

3

123

567

81

4

9

0

11

1312 15

4

14

16

1817 19

24

20

2221 23

5