Dell PowerEdge T610 Installation Manual
FILE LOCATION: C:\Windchill Projects\Sneetch\TS\Casters\A00\EN\Source\casters.fm
Template Last Updated -8/26/2008
About Warning
WARNING: A WARNING indicates a potential for property damage, personal injury,
or death.
Installing the Optional Casters on your System
The optional casters for your system come preinstalled in two stabilizer feet (two
casters per foot), which attach to the bottom of your system.
1
Turn off the system, including any attached peripherals, and disconnect the
system from the electrical outlet.
2
Rotate the four system feet inward.
WARNING: Whenever you need to lift the system, get others to assist you. To avoid
injury, do not attempt to lift the system by yourself.
3
Lay the system on its side on a flat work surface with the bottom of the system
overhanging the surface edge as shown in Figure 1.
4
Remove the four system feet by removing the Phillips screws securing the feet
(one screw per foot).
5
Install the stabilizer feet:
a
Holding the stabilizer foot at an angle, slide the two front metal tabs on
the foot into the tab slots in the bottom of the system. See Figure 1.
b
Rotate the foot towards the system, inserting the back metal tab into the
tab slot on the chassis. See Figure 1.
c
Secure the foot to the system using the Phillips captive screw.
d
Repeat step a through step c to install the remaining stabilizer foot.
6
Carefully place the system upright and on its feet on a flat, stable surface.
7
Reattach any peripherals, then connect the system to the electrical outlet.
8
Turn on the system and attached peripherals.
December 2008 Rev. A00
DELL CONFIDENTIAL – PRELIMINARY 12/17/08 – FOR PROOF ONLY
FILE LOCATION: C:\Windchill Projects\Sneetch\TS\Casters\A00\EN\Source\casters.fm
1
2
3
5
4
6
Figure 1. Installing the Optional Casters on your System
1 tab slot (6) 2 front metal tab (2 per foot)
3 back metal tab (1 per foot) 4 caster (4)
5 captive screw (1 per foot) 6 stabilizer foot (2)
____________________
Information in this document is subject to change without notice.
© 2008 Dell Inc. All rights reserved. Printed in the U.S.A.
Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is
strictly forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the
marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade
names other than its own.
DELL CONFIDENTIAL – PRELIMINARY 12/17/08 – FOR PROOF ONLY
Loading...