Page 1
Regulatory: DellTM Rackmount Flat Panel Color Monitor User’s Guide
Energy Efficiency
Federal Communications Commission (FCC) Notice (U.S. Only)
WARNING: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
The proper operation of the function requires a computer with VESA DPMS power
management capabilities. When used with a computer equipped with VESA DPMS,
the monitor is ENERGY STAR compliant.
As an ENERGY STAR Partner, Dell Computer Corporation has determined that
this product meets the ENERGY STAR guidelines for energy efficiency.
l Reorient or relocate receiving antenna.
l Increase the separation between the equipment and receiver
l Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
l
Consult the dealer of an experienced radio/TV technician for help.
l This device may not cause harmful interference
l This device must accept any interference received including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
FCC Declaration of Conformity
According to 47 CFR, Part 15 of the FCC Rules
*For the following named produce:
LCD MONITOR (Category Name)
14
Page 2
at this device complies with Part 15 of the
LCD MONITOR (category name)
Rackmount / DELL
(Model No / Brand Name)
*Manufactured at:
*FCC Rules: Tested to comply with FCC part 15, class B
*Test site at:
*Responsible Party for Produce:
Compliance:
*Manufacturer Information: Compal Electronics, Inc. Safety
CHC7229 (Basic Model)
Compal Electronics, Inc.
We hereby declare th
FCC Rules.
Operation is subject to the following two conditions:
l
This device may not cause harmful interference, and
l This device must accept any interference received,
including interference that may cause undesired
operation.
Compal Electronics, Inc.
NO.581,Juikuang Rd.
Neihu ,Taipei, Taiwan, R.O.C. 114
Tel)+(886)-2-8797-8588
Fax)+(886)-2-2658-3168
Dept.
NO.581,Juikuang Rd.
Neihu ,Taipei, Taiwan, R.O.C. 114
EU Declaration of Conformity (LVD,EMC)
For the following product:
Rackmount (model name)
Safety Dept.
Manager
Supplier signature
Win Chen
Manufactured at: Compal Electronics, Inc.
8, Nan -Tung Rd., Pin-Cheng City Taoyuan Hsien, Taiwan
R.O.C.
We hereby declare, that all major safety requirements, concerning to CE-Mark
Directive(93/68/EEC) and Low Voltage Directive (73/23/EEC), Electromagnetic
Compatibility Directives (89/336/EEC, 92/31/EEC) are fulfilled, as laid out in the
guidelines set down by the member states of the EEC Commission. This
declaration is valid for all samples that are part of this declaration, which are
manufactured according to the production charts appendix. The standards
relevant for the evaluation of electrical safety & EMC requirements are as follows:
LVD:EN60950:1992 +A1+A2+A3+A4
EMC:EN50082-1:1997, EN55022:1995, EN61000-3-2 & 3:1995
1. Certificate of conformity /Test report issued by:
LVD:TÜV
2. Technical documentation kept at:
Compal Electronics, Inc.
Which will be made available upon request.(Manufacturer)
Compal Electronics, Inc.
NO.581,Juikuang Rd.
Neihu ,Taipei, Taiwan, R.O.C. 114
Safety Dept.
Manager
Win Chen
15
Page 3
Canadian Regulatory Information (Canada Only)
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of
Communications.
Note that Canadian Department of Communications (DOC) regulations provide, that changes or
modifications not expressly approved by Dell Computer Corporati on could void your authority to
operate this equipment.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le
matériel brouilleur du Canada.
EN 55022 Compliance (Czech Republic Only)
VCCI Class 2 Notice (Japan Only)
This equipment complies with the limits for a Class 2 digital device (devices used in or adjacent to
a residential environment) and conforms to the standards for information technology equipment
that are set by the Voluntary Control Council for Interference for preventing radio frequency
interference in residential areas.
Class B ITE
MOC Notice (South Korea Only)
Class B Device
Please note that this device has been approved for nonbusiness purposes and may be used in
any environment, including residential areas.
16
Page 4
Polish Center for Testing and Certification Notice
The equipment should draw power from a socket with an attached protection circuit (a
three- prong socket). All equipment that works together (computer, monitor, printer, and
so on) should have the same power supply source.
The phasing conductor of the room's electrical installation should have a reserve short circuit protection device in the form of a fuse with a nominal value no larger than 16
amperes (A).
To completely switch off the equipment, the power supply cable must be removed from
the power supply socket, which should be located near the equipment and easily
accessible.
A protection mark "B" confirms that the equipment is in compliance with the protection
usage requirements of standards PN-93/T-42107 and PN-89/E-06251.
NOM Information (Mexico Only)
The following information is provided on the device(s) described in this document in compliance
with the requirements of the official Mexican standards (NOM)
Dell Computer Corporation
Exporter:
One Dell Way
Round Rock, TX 78682
Dell Computer de México,
Importer:
S.A. de C.V. Rio Lerma No. 302 -4° Piso
Col. Cuauhtemoc 16500 México, D.F.
S.A. de C.B. al Cuidado de Kudhne & Nagel
Ship to:
de México S. de R.I., Avenida Soles No.55
Col. Peñon de los Baños, 15520 México, D.F.
Supply voltage:
Current consumption:
12VDC,
2A
17
Page 5
Under the requirements of German ergonomics standard ISO09241-3/-7/-8, graphics or
Um den Anforderungen der deutschen Ergonomie-Norm ISO9241-3/-7/-8 zu
Información para NOM (Únicamente para México)
La información siguiente se proporciona en el despositivo o en los dispositivos descritos en este
documento, en cumplimiento con los requisitos de la Norma Oficial Mexicana (NOM):
Exporter:
Importador:
Embarcar a:
Ten sión alimentación:
Consumo de corriente:
BCIQ Notice (Taiwan Only)
Ergonomics Notice (Germany Only)
characters:
l Blue graphics or characters in dark background are not recommended. (This
combination may increase eye fatigue due to poor visibility caused by low
contrast.)
Dell Computer Corporation
One Dell Way
Round Rock, TX 78682
Dell Computer de México,
S.A. de C.V. Rio Lerma No. 302 -4° Piso
Col. Cuauhtemoc 16500 México, D.F.
S.A. de C.B. al Cuidado de Kudhne & Nagel
de México S. de R.I., Avenida Soles No.55
Col. Peñon de los Baños, 15520 México, D.F.
12VDC,
2A
l Graphics controller and monitor are recommended to be used in the following
conditions:
¡ Vertical frequency: 56Hz or higher.
¡ Display mode :Dark characters in bright abckground.
Ergonomie Hinweis (nur Deutschland)
antsprechen.
l
Wird empfahlen, die Grunfarbe Blau nicht auf dunklem Hintergrund zu
verwenden (schiechte Erkennbarkeit. Augenbelastung bei zu geringem
Zeicheenkontrast).
l Wird folgende Einstellung des Grafik-Comtrlooers und Monitors empfohlen.
¡ Vertikalfrequenz: 56Hz oder hoher.
¡ Ohne Zellensprung.
18
Page 6
Rapid technological advances lead to a high turnover in computer products, as
increasing rate. To address the
te disposal of unwanted products, and in
anticipation of future legislation, Dell gas instituted a disposal program, called Green
l return and disposal service for Dell
customers, covering computer products sold by Dell under the environmental label
plans. The returned products are reused, recycled, or disposed or as appropriate,
OTE: The Green Away program is designed to dispose of unwanted or
unusable products under the environmental label plans. For returned material
discount on recent purchases, or for recycling of equipment neither sold by Dell
label plans, contact your local Dell Asset
Dell Computer Corporation’s Environmental Program
Design for Recyclability
Your Dell equipment complies with the following principles of recclable design:
l
Avoidance of nonseparable connections, such as gluing and welding, between
different materials
l Avoidance of coatings and composite struncture materials
l Use of as few dirrerent materials as possible
l Designed for ease of disassembly:
¡ Subassemblies, cables, and components easily detachable by one person
working alone
¡ Minimal use of screws
¡ Most disassembly can be done by hand or with the aid of a standard 6-
millimeter (1/4-inch) nut driver only
Dell’s Blue Angel Disposal Program
customers upgrade their systems at an evermounting problem regarding the indiscrimina
Away, for the collection and disposal of these products.
Dell’s Green Away Program
Dell’s Green Away program is a free materia
in accordance with local environmental guidelines.
N
nor covered by the environmental
Management specialist.
In carrying out this proguam, Dell’s general responsibilities include the following:
l Organizing the reuse/recycling/disposal of the equipment
l Ensuring that all disposal/recycling practices meet local environmental
regulations
l Monitoring the process to ensure compliance and facilitate process
improvement
19
Page 7
How the Green Away Program Works
When you have one or more items of equipment that you would like to dispose of,
Dell customer service department to request instructions. The returns
coordinator processes the request and advised you on the return of your material. Refer
to “Green Away Collection Sites” found later in this document for the telephone number
Note:”Shells” (equipment from which integral components, such as
chips and power supplies, have been removed) are not accepted as part of this
free program. If a shell is discovered in your shipment, you will be asked to
on the items are not allowed in hazardous waste incinerators, the Dell Green
pare parts (or reasonable alternatives) for a period of five
for example, the base
to reduce the impact on the environment of obsolete item disposal and in
compliance with guidelines in many geographical locations, all Dell documentation supplied with
waste
The table lists the country specific customer service telephone number along with the address for
telephone number is
NOTE: Locations marked with an asterisk (*) are facilities approved for battery
disposal. As Dell expands the network of Green Away centers, additional addresses will
Europe. Contact your local Dell customer service department for
contact your local
and collection point in your area.
either collect the system or pay for its disposal.
The equipment is transported to Dell’s Green Away partner, where it is assessed and
disposed of as follows:
l
If judged resell able, the Dell label is removed and the equipment is tested,
repaired, and resold.
l
If judged beyond repair, the equipment is dismantled, and usable pares are
offered for sale.
Unable parts are dispose of as follows:
l Metal cases are sold to metals recyclers.
l Printed circuit boards and cases are sent to refiners.
l Plastic parts are sent to plastic recyclers.
l Unusable packaging is sent to paper recycles.
Monitors are sent to recycling companies to be disposed of as follows:
l
The tubes are washed and the luminescent powder is recovered, some
elements are extracted for reuse, and the remainder is disposed of via
controlled incineration.
l Glass is sorted and sent to the lead smelter or recycled for glass works.
l The planar mask and the iron are sent for reuse to metals recyclers.
l Items that are not reusable are mainly incinerated. Howeve r, if certain residues
Away partner transports the items to a secured (bundled) hazardous waste
Spare Parts Policy
Dell commits to retaining stocks of s
years from the termination of production of the Dell system componentsystem, the keyboard, or the monitor.
Use of chlorine-free paper (Europe Only)
As part of Dell’s policy
Dell equipment is printed on paper (fresh fiber from sustainable resources or recycled
paper) bleached without the use of chlorine.
Green Away Collection Points
the Green Away collection site. For Germany, the Green Away collection site
listed rather than the customer service number.
be available across
information about the availability of Green Away services in your location.
landfill.
20
Page 8
Country: Telephone Address
R Frazier Ltd.
Belgium 02 481 91 00
Plantijnweg 15
4104 BC Culemgorg, Netherland
WMI Sellbergs AB
Den mark +46-8-5900 5151
Box 1294
S-171 25 Solna, Sweden
WMI Selbergs AB
Finland +46-8-5900 5181
Box 1294
S-171 25 Solna, Sweden
Germany:
Bockmann/Ohlig
Northern Germany* 0130-86 12 51
Tersteegenstrasse 21a
42653 Solingen
Knab
Southern Germany* 0130-86 12 51
Carl Benz Strasse 8-10
35440 Linden
Netherlands 02 481 91 00
Norway +46-8-5900 5179
Sweden +46-8-5900 5169
United Kingdom* 0800 783-3124
R Frazier Europe
Plantijnweg 15
4104 BC Culemborg, Netherland
WMI Sellbergs AB
Box 1294
S-171 25 Solna, Sweden
WMI Sellbergs AB
Box 1294
S-171 25 Solna, Sweden
R Frazier Ltd.
Irongray Business Park
Lochside Industrial Estate
Dumfries
DG2 0NR
21
Loading...