Dell PowerEdge M1000e Chassis
Management Controller Firmware
Version 4.5
Single Click Auto Update Firmware for
Multiple Blade Servers Using Dell
Repository Manager
An automated, simple-to-use solution for
firmware update on blades in the chassis
Extended Power Performance (EPP)
and 3000W Power Supply Units (PSUs)
Availability of Additional Power with EPP
feature and 3000W PSUs
Configurable QuickDeploy Address
Range
Avoid iDRAC IP Address Conflict
Key Benefits:
• Firmware update of all the components
for multiple blade servers using custom
repository instead of individual updates
• Quicker and more accurate process of
updating blades on multiple chassis
• Consistent method of firmware update
from a remote console.
• Installation, configuration, and
deployment of high-volumes of servers
through an intuitive, comprehensive
console, using either scripting or imaging
technology.
Key Benefits:
• Enables drawing additional power using
3000w PSUs than the three PSUs in a
redundant grid configuration.
• Blades are not powered off in the event of
an AC grid failure or a PSU failure , as
power allocated to servers is automatically
reduced
• More power, up to 2700W available, for
higher-end and more memory
configurations of blades
• Enhanced server performance with the
additional power.
Key Benefits:
• Prevents assigning an iDRAC address
outside the specified range
• Avoids IP address conflicts in datacenters
where 16 QuickDeploy addresses were
allocated through CMC Version 4.0 or
earlier
• Limits assignment of QuickDeploy
addresses to 16 to match the addresses
already allocated in the data center
© 2013 Dell Inc. All rights reserved. Dell, the DELL logo, the DELL badge, and PowerEdge are trademarks of Dell Inc. Dell disclaims proprietary
interest in the marks and names of others. This document is for informational purposes only. Dell reserves the right to make changes
without further notice to any products herein. The content provided is as is and without express or implied warranties of any kind.
www.delltechcenter.com/cmc