1. EVAPORATOR:
The heart of the refrigerator.
It evaporates the refrigerant fluid and thereby absorbs heat from the
surrounding, Made of pure aluminum.
2. DRAIN PAN: (Use of Defrost Only)
Discards the water that drips of the evaporator when defrosting.
3. CONTROL BOX:
Regulates the operation of the motor and controls the inside
temperature of the refrigerator.
4. PLASTIC COATED SHELF has full width and can slide out.
5. RACK for butter, eggs, and small size goods.
6. MAGNETIC DOOR SEAL:
Keeps the refrigerator virtually airtight all along the edge, but is nevertheless easy to open.
7. ICE CUBE TRAY:
Ice cubes are easy to remove from the tray.
8. USABLE RACK for cans or jars.
9. BOTTLE RACK for bottles, cans or jars.
10. CRISPER for vegetables and fruits.
11. SLIDE OUT CRISPER COVER.
1. Clean the refrigerator thoroughly. Wipe the outside with a soft dry cloth, the
inside with a damp cloth.
2. Keep the door open and insert the power supply cord into the socket.
3. Turn the thermostat dial to “7” Close the door and let the refrigerator
operate for 15-20 minutes.
The freezer should then show some traces of frost.
HOW TO OPERATE
Starting your new Refrigerator
You can control the inside temperature by
turning the thermostat dial. Higher numbers
mean greater cooling power, smaller
numbers mean less cooling power, To make
ice cubes in the freezer compartment, set
the dial to “7”. The dial does not have to be
set exactly on the numbers, but can be any
place in between.
Cleaners: The cleaners noted below are available. Never use harsh,
abrasive cleaners, heavy-duty cleaners, or solvents on any surface.
Exterior: Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains
and for periodic waxing, use silicon wax.
Evaporator: When refrigerator needs defrosting turn thermostat dial to
“OFF”. Do not use sharp instruments.
Refrigeration Section: Wash shelves and other removable parts in warm
sudsy water, rinse and dry. Wash interior with baking soda solution (3
table spoons to one quart of water) or warm sudsy water, rinse and dry.
Magnetic Door Seals: Wash with warm sudsy water.
The Finishing Touch: Replace all parts and return thermostat dial to
desired setting.
HOW TO INSTALL
Install refrigerator in a convenient location away from extreme heat and
cold. Allow sufficient clearance between the refrigerator and side wall so
the door will open for a fully usable interior. Refrigerator is not designed
for recessed installation.
Select a place with strong level floor.
Allow 5 inches of space between the refrigerator’s side and the wall.
T emperature control
Defrost the refrigerator when the frost accumulated on the evaporator is
about 5mm(1/5inch) thick.
Set the thermostat dial to “OFF”. Remove frozen or perishable foods.
Keep drip tray in place. Defrosting usually takes a few hours. To defrost
quickly remove all foods from the refrigerator and leave door open. Never
use a knife or other metal instrument to remove ice/frost from the
evaporator. After defrosting empty water from drip tray, return the
thermostat dial to the desired position to start refrigerating again.
How to defrost