CENTRAL BRASS 0289 Installation Manual

Bar Faucet

2.2 GPM Aerator

Gooseneck Spout

Compression Stems with

Replaceable Seats

Cast Brass

0289 Series Double Bar Faucet

Faucets with lever, wrist or elbow
handles and compression or ceramic
stem cartridges are ADA compliant.

Certified to
ANSI/NSF 61 Section9

CENTRAL BRASS MFG CO

2950 East 55th Street, Cleveland, Ohio 44127

Phone: [phone] Fax: [phone] Email: sales @CentralBrass.com

030103 I-0289

www.CentralBrass.com

CENTRAL BRASS

INSTALLATION INSTRUCTIONS

1. Assemble hot & cold supply tubes to faucet body .
Tighten tubes with open end wrench.

2. Apply a thin coat of plumber's putty on the bottom
edge of the faucet body and place the faucet shank
through the hole in the sink.

3. Install the washers and locknut on the faucet shank.
Position the faucet and tighten the locknut.

4. The body should be positioned with the cold indexed
handle on the right. Then install the spout, tighten
spout nut to body (if necessary).

5. Connect the supply tubes to the hot (left) and cold
(right) supply lines. Do not kink supply tubes when
bending to connect with supply lines.

6. T urn on supply lines. Check all connections for
leakage. Turn on hot and cold water for one
minute to flush out dirt and sediment that might
have accumulated during installation. Turn of f
water and assemble aerator. Check under sink
connections for leakage.

CENTRAL BRASS MFG CO

2950 East 55th Street, Cleveland, Ohio 44127

Phone: [phone] Fax: [phone] Email: sales @CentralBrass.com

030103 I-0289

www.CentralBrass.com