Canon K30218 Manual BT

PIXUS80iにキヤノンBluetoothユニット BU-10を取り付けると、 Bluetooth規格に対応したコンピュータからワイヤレスで印刷が可能になります。 Bluetoothユニットの取り扱いかた、Bluetoothユニットを使った印刷のしかたについては、プリンタに付属のCD-ROMに入っている『Bluetooth ユニット BU-10ユーザーズガイド』を参照してください。

お買い上げの国や地域以外では、本製品を使用しないでください。国や地域によっては電波使用制限があるため、本製品を使用した場合罰せられることがあります。

■

この機器の使用上の注意

この機器の使用周波数帯は2.4GHz帯（2.400GHz〜2.4835GHz）です。この周波数帯では、電子レンジ等の産業・科学・医療用機器や、ほかの同種無線局、工場の製造ライン等で使用されている免許を要する移動体識別用構内無線局、免許を要しない特定の小電力無線局、アマチュア無線局等（以下「ほかの無線局」と略す）が運用されています。

1. この機器を使用する前に、近くで「ほかの無線局」が運用されていな

いことを確認してください。

2. 万一、この機器と「ほかの無線局」との間に電波干渉が発生した場合

には、速やかにこの機器の使用場所を変えるか、または機器の運用を停止（電波の発射を停止）してください。

3. 不明点が生じたり、お困りの場合には、xxxxxxxx までお問い合わせ

ください。

この無線機器は2.4GHz帯を使用します。変調方式としてFH-SS変調方式を採用し、与干渉距離は20m以下です。

Attaching the Canon Bluetooth Unit BU-10 to the i80 printer enables the printer to print under wireless control of a computer conforming to the Bluetooth standards. For using and printing with the Bluetooth Unit BU-10, refer to the "Bluetooth Unit BU-10 User's Guide" in the CD-ROM coming with the printer.

Use this product only in the country or region of purchase. Otherwise, you may be punished for violation of radio regulations in the country or region.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

●

Reorient or relocate the receiving antenna.

●

Increase the separation between the equipment and receiver.

●

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

●

Consult the dealer or an experienced radio/TV technician for help. Use of a shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC Rules. Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or modifications should be made, you could be required to stop operation of the equipment. Canon U.S.A., Inc. One Canon Plaza Lake Success, NY 11042 1-516-328-5600

Canadian Radio Interference Regulations

This digital apparatus does not exceed Class B limits for radio noise emissions from a digital apparatus as set out in the interference-causing equipment standard entitled "Digital Apparatus", ICES-003 of the Industry Canada. Cet appareil numérique respecte les limites de bruits radio éléctiques applicables aux appareils numériques de Classe B prescrites dans la norme sur le matériel brouilleur: "Appareils Numériques", NMB-003 édictée par l'Industrie Canada.

FCC WARNING

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Japanese English