Canon G9 X Mark II User Manual

Getting Started
ENGLISH
CEL-SW8BA210
Package Contents
Before use, make sure the following items are included in the package. If anything is missing, contact your camera retailer.
Camera Battery Pack
Battery Charger
Wrist Strap
CB-2LHE
* Do not peel off the adhesive covering from a battery pack.
Printed matter is also included.
A memory card is not included.
Compatible Memory Cards
No memory card is included. Purchase one of the following kinds of card as needed. These memory cards can be used, regardless of capacity. For details on the number of shots and recording time per memory card, see “Specifi cations” in the downloadable Camera User Guide.
SD memory cards*
SDHC memory cards*1*
SDXC memory cards*1*
*1 Cards conforming to SD standards. However, not all memory cards have been
verifi ed to work with the camera.
*2 UHS-I memory cards are also supported.
1
2
2
2
Manuals and Software
You can download the manuals and software from the following URL.
http://www.canon.com/icpd/
With a computer connected to the Internet, access the above URL.
Access the site for your country or region.
Adobe Reader is required to view the manuals.
For instructions on downloading and installing the software, refer to the
Camera User Guide available for download.
You may be requested to enter the serial
number (body number) when downloading the manuals or software. In this case, enter the number printed on the bottom of the camera.
Initial Preparations
Attach the strap.
1
 Attach the included strap to the camera
(1)
(2)
(1)
(2)
as shown.
 The strap can also be attached to the left
side of the camera.
Insert the battery pack.
2
 After aligning the marks on the battery
pack and charger, insert the battery pack by pushing it in (1) and down (2).
3
Initial Preparations
(1)
(3)
(1)
(2)
(2)
Charge the battery pack.
3
 Plug the power cord into the charger,
then plug the other end into a power outlet.
 The charging lamp turns orange, and
charging begins.
 When charging is fi nished, the lamp turns
green. Remove the battery pack.
 For details on charging time and the
number of shots or recording time available with a fully charged battery pack, refer to “Specifi cations” in the downloadable Camera User Guide.
Open the cover.
4
 Slide the switch (1) and open the cover
(2).
Insert the battery pack.
5
 Holding the battery pack with the
terminals in the position shown (1), hold the battery lock toward (2) and insert the battery pack toward (3) until the lock clicks shut.
 If you insert the battery pack facing the
wrong way, it cannot be locked into the correct position. Always confi rm that the battery pack is facing the right way and locks when inserted.
 To remove the battery pack, press the
battery lock in the direction of the arrow.
4
Loading...
+ 7 hidden pages