Starter Guide
Please read this guide before operating this equipment.
After you finish reading this guide, store it in a safe place for future reference.
ENG
Set Up the Machine
Do You Have Everything?
● Machine ● Cartridge ● Power Cord ● Telephone Cable
● Handset ● Plugs with Pins● Handset Cradle
● Destination Labels
● Starter Guide
● Basic Guide
● User Software CD
Before Setting Up the Machine Manuals for the Machine
● Remove all shipping tape on the machine.
● Always hold the bottom when you lift the
machine.
● The machine illustration may differ slightly from
your machine.
● Starter Guide (This Document): Machine set-up and software installation
● Basic Guide: Basic features
● Advanced Guide (in User Software CD): Advanced fax features, status monitor, and reports and
lists
● Software Guide (in User Software CD): Driver set-up and printing from a computer
Assistance:
If you have a problem with your machine and you cannot solve it by referring to the manuals listed
above, please contact our Canon Authorized Service Facilities or the Canon Customer Care Center
at 1-800-828-4040 between the hours of 8:00 A.M. to 8:00 P.M. EST Monday through Friday and
10:00 A.M. to 8:00 P.M. on Saturday.
● Limited Warranty Notice
● Cartridge Warranty Notice
1 2
Install Cartridge
1
Remove the cartridge from the bag.
Keep the bag for future use.
4
A
CAUTION
Do not open the drum protective shutter (A).
5
A
2
Gently rock the cartridge several times to distribute
toner inside.
6
A
3
Pull out the seal completely.
NOTE
Do not pull out the seal at an angle.
7
A
Open the document feeder tray.
8
Push down the cartridge to make sure it is properly
set in the machine.
Open the cartridge cover by the notch (A).
9
Close the cartridge cover.
NOTE
Be careful not to get your fingers caught.
Hold the cartridge by its handle (A).
10
BA
Open the paper delivery tray (A) and the extension
(B).
Insert the cartridge in the machine as far as it will
go. The arrow (A) on the cartridge should be facing
away from you and pointing down.
3
4
Load Paper
A5 B5
EXEC LTR
LGL
A4
Load Paper
1
Lift the paper stack cover and pull it out completely.
NOTE
Make sure the back end of the cover does not catch the
front paper guide.
5
A
2
Pinch and slide the side paper guides to the size of
paper.
6
3
Pull out the paper guide rail as far as it will go.
4
Fan the paper stack and even the edges.
7
A
Insert the paper stack print side up.
NOTE
Make sure the stack height does not exceed the limit
mark (A).
8
BA
Pull out the document delivery tray (A) and the
extension (B).
Do not open or close the document delivery tray
extension without extending the document delivery
tray first.
Push back the paper guide rail to the front edge of
paper.
A
NOTE
– If loading paper shorter than Letter, pinch and slide the
front paper guide (A) to match the paper size.
– If loading paper other than Letter, make sure to set the
correct paper size in the machine. (See Chapter 3,
“Print Media,” in the Basic Guide.)
Insert the paper stack cover.
NOTE
Make sure the back end of the cover does not catch and
lower the scanning platform (A).
5
6
Loading...