Campbell Hausfeld PW1346, PW1375, PW1345, PW1376 User Manual
Garden Hose Connection
GARDEN HOSE CONNECTION
INSTRUCTIONS
1. Attach nipple adapter to inlet fitting on the unit (this may already be
attached to the pump).
2. Attach quick connect fitting to
garden hose.
3. Pull side “A” of quick connect fitting toward garden hose and push
onto nipple adapter.
4. Push side “A” of quick connect fitting towards nipple adapter and
release.
Figure 2 - Garden Hose Connection
Quick Connect Fitting
Garden Hose
Nipple
Adapter
Electric Pressure
Washer
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.
IN456800AV 10/99
© 1999 Campbell Hausfeld
Specifications
Max Pressure with Effective Pressure Maximum Motor Power Maximum Inlet Unit
Model Standard Lance w/Turbo Lance Capacity (Single Phase) Voltage Water Temperature Weight
Assembly Instructions
Assembly Instructions and Parts List PW1345, PW1346, PW1350 , PW1375, and PW1376
! IMPORTANT !
This pressure washer maybe
equipped with a microswitch sensitive to water flow. This Instant
Start/Stop switch (ISS) senses water
flow in the pump. When the trigger
is released, water stops flowing
through the pump. The ISS then
automatically turns the motor off to
protect pump from overheating.
OPERATION
1. Turn the “ON/OFF” switch to
“ON”.
2. Pull trigger on gun to begin
spraying water.
3. Release trigger. The pressure
washer motor will stop running.
4. To spray again, pull trigger and
motor and pump will restart.
Note: Occasionally the motor may
run for a short time to bring fresh,
cool water into the pump even if
trigger is released. This is part of
normal operation and will not damage the unit.
Always turn the
“ON/OFF” switch
to “OFF” then trigger gun to release
hose pressure before unplugging
power cord.
Risk of Injection.
Unit will start
spraying when trigger is squeezed if
on/off switch is in “ON” position.
Always point gun in safe direction.
Call 1-800-330-0712
for Technical Service
NOTE: REFER TO PRODUCT MANUAL FOR
ALL SAFETY INSTRUCTIONS
For parts, product & service information
visit www.campbellhausfeld.com
Notas
Instrucciones de montaje y lista de piezas PW1345, PW1346, PW1350, PW1375, y PW1376
Approved
#7P64
No. de Número del
Ref. Descripción Repuesto Ctd.
Para ordenar repuestos, sírvase llamer al 1-800-330-0712 (En
los Estados Unidos, o llame a su distribuidor local)
Sírvase proporcionar la siguiente información:
-Número de modelo
-Número de serie (si lo hubiera)
-Descripción y número del repuesto, según se indica en la lista de repuestos.
Dirija su correspondencia sobre repuestos a:
The Campbell Group / Parts Dept.
100 Production Drive
Harrison, OH 45030 U.S.A.
1 Lanza regulable PM035101AV 1
*2
Lanza turbo PM022621AV 1
3
Manguera PM012902AV 1
4
Pistola PM037201AV 1
5
Niple adaptador PM022100AV 1
6
Conector rápido PM020600SV 1
7
Limpiador de puntas PM008500AV 1
8 Aplicador de detergente PM014700SV 1
* 9 Juego de ruedas (2) PM014100SJ 1
*10 Mango PM014200SV 1
*11 Tapa de la caja de herramientas HV601500SV 1
*12 Caja de herramientas HV601600SV 1
* Equipo opcional, tal vez no se suministre con todos los modelos.
Figure 1
PW1345 1300 psi — 1.8 GPM 13 Amps 120V 100˚F 25 lbs.
PW1346 1300 psi — 1.8 GPM 13 Amps 120V 100˚F 25 lbs.
PW1350 1300 psi — 1.8 GPM 13 Amps 120V 100˚F 25 lbs.
PW1375 1300 psi 1750 psi 1.8 GPM 13 Amps 120V 100˚F 25 lbs.
PW1376 1300 psi 1750 psi 1.8 GPM 13 Amps 120V 100˚F 25 lbs.
"A"
U
L
4. Conecte la manguera de jardín
según se explica en Instrucciones de
conexión de la manguera de jardín.
5. Conecte el cordón eléctrico a un
tomacorriente de 120 V conectado
a tierra, y protegido por un interruptor de circuito por fuga a tierra
(GFCI en inglés).
6. Abra la llave del agua.
7. Oprima el gatillo y manténgalo presionado por 1 minuto para liberar la
3. Hale el extremo "A" del conector
rápido hacia la manguera de jardín
y conéctelo al niple.
4. Presione el extremo "A" del conector rápido hacia el niple, y suéltelo.
1. Inserte la lanza en la pistola y gírela
en el sentido de las agujas del reloj
hasta que llegue a su tope, como se
muestra en la figura 3.
2. Verifique que el interruptor esté en
la posición "OFF" ("APAGADO").
3. Conecte la manguera de alta presión y el ensamblaje de la pistola en
la unidad.
7Sp
Instrucciones de montaje y lista de piezas
PW1345, PW1346, PW1350, PW1375, y PW1376
System Connection
Figura 3 - Conexión de la pistola y
lanza
Lista de Repuestos
presión y liberar el aire atrapado en
el sistema.
8. Coloque el interruptor "ON/OFF"
(“ENCENDIDO/APAGADO”) en la
posición "ON" ("ENCENDIDO").
NOTA: LAS INSTRUCCIONES DE
FUNCIONAMIENTO SE ENUMERAN
EN EL MANUAL DEL PRODUCTO.
Conexión de la
Manugera de Jardín
Assembly Instructions and Parts List PW1345, PW1346, PW1350, PW1375, and PW1376
1. Insert lance into the gun and turn
clockwise to positive stop as shown
in Figure 3.
2. Ensure that the power switch is in
the “OFF” position.
3. Attach the high pressure hose and
gun assembly to the unit.
4. Connect garden hose as explained
under Garden Hose Connection
Instructions.
5. Plug the power cord into a grounded 120V outlet protected by a
ground fault circuit interrupter
(GFCI).
6. Turn water on.
7. Depress and hold the trigger on the
gun for one minute to release pres-
sure and remove any air trapped in
the system.
8. Turn the “ON/OFF” switch to the
“ON” position.
NOTE: REFER TO PRODUCT MANUAL
FOR OPERATING INSTRUCTIONS
System Connection
Figure 3 - Gun/Lance Connection
Ref. Part
No. Description Number Qty.
For Replacement Parts,
Call 1-800-330-0712
Replacement Parts List
Please provide following information:
-Model number
-Serial number (if any)
-Part description and number as shown in parts list
Address parts correspondence to:
The Campbell Group / Parts Dept.
100 Production Drive
Harrison, OH 45030 U.S.A.
1 Adjustable Lance PM035101AV 1
* 2 Turbo Lance PM022621AV 1
3 Hose PM012902AV 1
4 Gun PM037201AV 1
5 Nipple Adapter PM022100AV 1
6 Quick Connect Fitting PM020600SV 1
7 Tip Cleaner PM008500AV 1
8 Detergent Applicator PM014700SV 1
Ref. Part
No. Description Number Qty.
* 9 Wheel Kit (2) PM014100SJ 1
*10 Handle PM014200SV 1
*11 Tool Box Lid HV601500SV 1
*12 Tool Box Tub HV601600SV 1
1
4
2*
3
5
6
7
www.campbellhausfeld.com
2
Para ordenar repuestos, sírvase llamer al 1-800-330-0712 (En
los Estados Unidos, o llame a su distribuidor local)
8
9*
10*
11*
12*
1
4
2*
3
5
6
7
8
9*
10*
11*
12*
Figure 4
GFCI Outlet
Power Switch
Gun
Inlet
High
Pressure
Hose
Outlet
Figura 4
Interruptor
Pistola
Entrada
Manguera de
alta presión
Salida
* Optional equipment, may not be supplied with all models.
Tomacorrientes con
dispositivo de
conexión a tierra
contra cortocircuitos
Loading...