Broan Nutone PM25 Instructions Manual

uT

MODEL PM25

FOR DOMESTIC COOKING ONLY

TO REDUCE THE R_SK OF FIRE, ELECTRIC SHOCK, OR iNJURY
TO PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer. If
you have questions, contact the manufacturer at the address or
telephone number Iisted in the warranty.

2. Before servicing or cleaning unit, switch power off at service panet
and Iock the service disconnecting means to prevent power from
being switched on accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent warning

device, such as a tag, to the service panel.

3. Installation work and electrical wiring must be done by a qualified
person(s) in accordance with alI applicable codes and standards,
including fire-rated construction codes and standards.

4. Sufficient air is needed for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment to pre-
vent backdrafting. Fotlow the heating equipment manufacturer's
guideline and safety standards such as those published by the

National Fire Protection Association (NFPA), and the American
Society of Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.

5. When cutting or drilling into walI or ceiling, do not damage electri-
cal wiring and other hidden utiiities.

6. To reduce the risk of fire or electric shock, do not use this range
hood with an additional speed control device.

7. Ducted fans must always be vented to the outdoors.

8. To reduce the risk of fire, use only metal ductwork.

9. Use with approved cord-connection kit only.

10. This unit must be grounded.

TO REDUCE THE RiSK OF A RANGE TOP GREASE FIRE:

1. Never leave surface units unattended at high settings. Boilovers
cause smoking and greasy spillovers that may ignite. Heat oils

s!owly on low or medium settings.

2. Always turn hood ON when cooking at high heat or when cooking
flaming foods.

3. Clean ventilating fans frequently. Grease should not be allowed to
accumulate on fan or filter.

4. Use proper pan size. Always use cookware appropriate for the
size of the surface element.

TO REDUCE THE RiSK OF iNJURY TO PERSONS iN THE EVENT
OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*

1_SMOTHER FLAMES with aclose-fitting lid, cookie sheet, or metal

tray,then turn offthe burner. BE CAREFUL TO PREVENT BU RNS.

Ifthe flames do not go out immediately, EVACUATE AND CALL

THE FIRE DEPARTMENT.

2. NEVER PICK UPA FLAMING PAN -- You may be burne&

3. DO NOT USE WATE R, including wet dishcloths or towels -violent
steam explosion will resuiL

4_ Use an extinguisher ONLY if:

A. You know you have a Class ABC extinguisher and you al-

ready know how to operate it.

B. The fire is small and contained in the area where it starte&
C. The fire department is being called.

D. You can fight the fire with your back to an exit.

* Based on "Kitchen Fire Safety Tips" published by NFPA.

1. For generaI ventilating use only. Do not use to exhaust hazard-
ous or explosive materials and vapors.

2. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywaII spray, construction dust, etc. off power

unit.

3. For best capture of cooking impurities, your range hood shouid
be mounted so that the top of the hood is 24-30" above the cook-

ing surface.

4. Please read specification label on product for further informa-
tion and requirements.

Installer: Leave this manua with the homeowner.

Homeowner: Operating and C eaning information on page 2.

1. Lift exhaust unit into position and mark location for duct and wir-
ing cutout. Cut hobs allowing at least 1/4" clearance. Note: Make

sure switches are accessible.

2. Cut out additional openings in cabinet and roof as required.

3. Remove junction box cover from exhaust unit.

4. Pull wiring through cutout in cabinet. Lift unit into position, feed
wiring through access hob, and secure unit to cabinet with four
(4) screws provided.

5. install and align duct. The duct, round damper and roof cap are
not included with your exhaust unit. These items can be pur-

chased from your dealer.

6. Make ebctrical connections according to the latest National Elec-
trical Code and applicable IocaI ordinances.

CLEANING INFORMATION

FILTER
For greatest efficiency, the permanent type aluminum foil filter

should be removed and cleaned periodically.
To clean, the filter should be soaked in hot water and detergent

then thoroughIy rinsed.
EXTERIOR SURFACE

Your Exhaust Unit is a beautifully finished addition to your kitchen.
Clean with a mild detergent to preserve its lasting beauty.

NOTE:

ROUND DAMPER tS NOT INCLUDED,

ROOF CAP

CEILING

VERTICAL OR
TOP VENTING

CABINET

ELECTRICAL GROUNDING

Permanently ground this unit in accordance with the latest National
Electrical code and applicable local codes and ordinances.

it is recommended that a permanent ground connection be made
to the unit using a conductor of appropriate size from a grounded

continuous metallic cold water pipe, a grounded lead in the service
panel, or a properly driven and electrically grounded ground rod.

Do not ground to a gas supply pipe.

REPLACEMENT PARTS LIST

Part No. Description
R730090 MotodFan Blade

R111447 Light Socket
R610027 Aluminum Filter

99030316 Motor Switch - White
99030315 Motor Switch - Black

99030311 Light Switch - White
99030310 Light Switch - Black

BROAN-NUTONE ONE YEAR LIMITED WARRANTY

Broan-NuTonewarrantstotheoriginal consumer purchaserof itsproductsthatsuch
productswillbefree from defects inmaterialsorworkmanshipfor a periodofoneyear
from the date of original purchase. THERE ARE NO OTHER WARRANTIES,

EXPRESSORIMPLIED,INCLUDING,BUTNOTLIMITEDTO,IMPLIEDWARRAN-

TIES OF MERCHANTABILITYOR FITNESSFORA PARTICULAR PURPOSE.

Duringthis one-year period, Broan NuTone will, at its option, repair or replace,

without charge, any productor part which is foundtobedefective undernormal use
and service.

THIS WARRANTY DOES NOT EXTENDTO FLUORESCENT LAMPSTARTERS
AND TUBES.This warrantydoes not cover (a)normal maintenance andservice or

(b) anyproducts or parts which havebeensubject to misuse,negligence,accident,
improper maintenanceor repair(other thanby Broan NuTone),faulty installation or
installation contrary to recommended installation instructions.

The durationofanyimpliedwarrantyis limitedtotheone-yearperiod asspecified for
the express warranty. Some states do notallow limitation on how long an implied
warranty lasts, so the above limitation may not apply to you.
BROAN-NUTONE'S OBLIGATION TO REPAIR OR REPLACE, AT BROAN-
NUTONE'S OPTION, SHALL BE THE PURCHASER'S SOLE AND EXCLUSIVE

REMEDYUNDERTHIS WARRANTY.BROAN-NUTONE SHALLNOT BE LIABLE
FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGESARISING OUT

OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some
statesdonotallow the exclusionodimitation ofincidentalor consequentialdamages,

so the above limitationor exclusion may not apply to you.
This warranty gives you specific bgal rights, and you may also have other rights,

which vary from state to state. This warranty supersedes all prior warranties.
To qualify for warranty service, you must(a) notify Broan-NuToneatthe addressor

phone number below, (b) give the model number and part identification and (c)
describe the nature of any defect in the product or part. At the time of requesting
warranty service, you must present evidenceof the original purchase date.

Inthe United States, contact:
BroamNuTone LLC, NaTone, Inc,

928 West State Street 4828 Red Bank Road

Hartford,W153027 Cincinnati,Ohio 45227

(18006371453) (1800543-8687)

InCanada, contact:
BroamNuTone Canada, Inc.

1140Tristar Drive

Mississauga, Ontario, L5T 1H9
(1 888 882-7626)

626846E

2