ARISTON NM10 723 SS EX Daily Reference Guide

Quick Guide

THANK YOU FOR PURCHASING A ARISTON PRODUCT.

To receive more comprehensive assistance, register the appliance on

www.aristonchannel.com/register

GB

Before using the appliance carefully read the Health and Safety guide.

Before using the machine, it is imperative that the transport bolts are removed. For more detailed instructions on how to remove them, see the Installation Guide.

CONTROL PANEL

1.	STEAM HYGIENE button	1	2	3

2.RAPID / KEY LOCK button

3.ON/OFF button

4.START/PAUSE button

5. FINAL CARE button

6. START DELAY button

7. SPIN button

8. TEMPERATURE button

9. WASH CYCLE SELECTOR KNOB

9

8

7

6

5

4

WASH CYCLE TABLE

Maximum load 7 kg
Power input in off mode 0.5 W / in left-on mode 8 W											Add
					Temperature		Max.	Max.	Duration	Gar-
										ments
		Wash cycle					spin speed	load	(min-
										(	)
							(rpm)	(kg)	utes)
					Default	Range
1		Mixed			40°C	- 40°C	1200	7	90
2		Eco Cotton		(1)	60°C	60°C	1200	7	160
						40°C	1200	7	220
3		Cotton (2)			40°C	- 60°C	1200	7	220
4		Synthetics (3)			40°C	- 60°C	1200	4	155
5		Delicates			40°C	- 40°C	1000	3,5	90
6		Wool			40°C	- 40°C	800	1,5	75
7		Anti Allergy			60°C	40°C - 60°C	1200	3,5	175
8		Anti Stain 40°			40°C	- 40°C	1000	3,5	60
9		White			40°C	- 90°C	1200	7	100
10		Steam Refresh			–	–	–	1	20		–
11		Rapid 30 min			30°C	- 30°C	800	3,5	30
12		Bed & Bath			60°C	- 60°C	1200	7	120
13		Shirts			40°C	- 40°C	800	1,5	75
14		Spin & Drain *			–	–	1200	7	10		–
15		Rinse & Spin			–	–	1200	7	50		–
Required dosage			Optional dosage

Detergents and				Recommended
	Additives			detergent
Pre-		Wash	Fabric
wash			softener	Powder	Liquid
1		2	3
–				–
–
–
–
–
–				–
–				–
–
–
(90°)
–		–	–	–	–
–				–
–
–				–
–		–	–	–	–
–		–		–	–

Residual dampness %	Energy consumption kWh	Total water l
–	–	–
53	0,94	52,5
53	0,97	75
53	0,97	75
53	0,86	60
–	–	–
–	–	–
–	–	–
–	–	–
–	–	–
–	–	–
–	–	–
–	–	–
–	–	–
–	–	–
–	–	–

The cycle duration indicated on the display or instruction manual is an estimate based on standard conditions. The actual duration may vary in relation to several factors, such as the temperature and pressure of the incoming water, ambient temperature, amount of detergent, load quantity and type, load balancing and any additional options selected.

1) Test wash cycle in compliance with regulation 1061/2010:

This cycle is designed for normally soiled cotton loads and is the most efficient in terms of both electricity and water consumption; it should be used for garments washable at 60°C or at 40°C. The actual washing temperature may differ from the indicated value.

For all testing institutes:

2)Long cotton cycle: set wash cycle 3 with a temperature of 40°C.

3)Long synthetics cycle: set wash cycle 4 with a temperature of 40°C.

* By selecting the 14 cycle and excluding the spin cycle, the washing machine will drain only.

PRODUCT DESCRIPTION

1.Top

2.Detergent dispenser drawer

3.Control panel

4.Handle

5.Porthole door

6.Drain pump (behind the plinth)

7.Plinth (removable)

8.Adjustable feet (2)

	1.
2.	3.
	4.
	5.
	6.
7.
	8.

DETERGENT DISPENSER DRAWER

compartment 1: Pre-wash detergent	B		A
(powder)
compartment 2: Detergent for the wash
cycle (powder or liquid)
If liquid detergent is used, it is recommended			1
that the removable plastic partition A
		3	2
(supplied) be used for proper dosage.
If powder detergent is used, place the partition
into slot B.
compartment 3: Additives (fabric softeners,
etc.)
The fabric softener should not overflow the grid.

!Use powder detergent for white cotton garments, for pre-washing, and for washing at temperatures over 60°C.

!Follow the instructions given on the detergent packaging.

WASH CYCLES

Follow the instructions on the symbols of the garment’s wash care label. The value indicated in the symbol is the maximum

recommended temperature for washing the garment.

Mixed

For washing lightly to normally soiled resilient garments in cotton, linen, synthetic fibres and mixed fibres.

Eco Cotton

60°/40°

Suitable for washing moderately soiled cotton garments. At 40°C and 60°C it is the standard cycle for washing cotton garments, and is the most

efficient in terms of combined water and electricity consumption.

Cotton

Normally to heavily soiled and robust cottons .

Synthetics

Suitable for washing moderately soiled garments made of synthetic fibres

(e.g. polyester, polyacrylic, viscose, etc.) or mixed synthetic-cotton fibres.

Delicates

For washing very delicate garments. It is advisable to turn the garments inside out before washing them. For best results, use liquid detergent on

delicate garments.

Wool - Woolmark Apparel Care - Green:

The “Wool” wash cycle is approved by the Woolmark Company for washing wool garments classified as “hand-washable”, provided that the wash complies with the instructions appearing on the garment’s label and with those provided by the manufacturer of this washing machine. (M1126)

Anti Allergy

Suitable for removing major allergens such as pollen, mites and cat or dog hair.

Anti Stain 40°

The programme is suitable to heavily-soiled garments with resistant colours. It ensures a washing class that is higher than the standard class (A class). When running the programme, do not mix garments of different colours. We recommend the use of powder detergent. Pre-treatment with

special additives is recommended if there are obstinate stains.

White

For washing normally to heavily soiled towels, underwear, table and bed linen, etc in resilient cotton and linen. Only when the temperature is selected at 90°C the cycle is provided with a prewash phase before main washing phase. In this case it is recommended to add detergent both, in

the prewash and main wash section.

Steam Refresh

The garments will be damp once the cycle is completed, so we recommend hanging them to dry (1 kg, roughly 3 items). This programme refreshes

garments by removing bad odours and relaxing the fibres. Insert dry items only (that are not dirty) and select programme “Steam Refresh”. Garments

will be a little damp at the end of the cycle and can be worn after a few minutes. The “Steam Refresh” programme makes ironing easier.

!Do not add softeners or detergents.

!Not recommended for wool or silk garments.

Rapid 30 min

For washing lightly soiled garments quickly. This cycle lasts only 30

minutes, saving time and energy.

Bed & Bath

For washing home linen in a single cycle. It optimises the use of fabric softener and allows for saving time and electricity. We recommend the

use of powder detergent.

Shirts

Use the special wash cycle to wash shirts in different fabrics and colours

to guarantee they receive the best possible care.

Spin & Drain

Spins the load then empties the water. For resilient garments. If you

exclude the spin cycle, the machine will drain only

Rinse & Spin

Rinses and then spins. For resilient garments.

WASH CYCLE PHASE INDICATOR LIGHTS

Once the desired wash cycle has been selected and has begun, the indicator lights switch on one-by-one to indicate which phase of the cycle is currently in progress.

Wash

Rinse

Spin & Drain

End of Wash Cycle

DISPLAY INDICATORS

Failure: Call Service

Refer to Troubleshooting section

Failure: Water filter clogged

Water cannot be drained; water filter might be blocked

Failure: No water

No or not sufficient inlet water.

In the event of any failure, refer to the “Troubleshooting” section.

Key Lock

to activate the control panel lock, press and hold the button for approximately 3 seconds. The lit symbol signals that the control panel is locked. This prevents wash cycles from being modified accidentally (except for the ON/OFF

button), especially if there are children in the home. To deactivate the

control panel lock, press and hold the button for approximately 3 seconds.

Locked door indicator

When lit, the symbol indicates that the door is locked. To prevent any damage, wait until the symbol turns off before opening the door.

To open the door while a cycle is in progress, press the START/PAUSE

button

; if the symbol is off, the door can be opened.

FIRST-TIME USE

Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, using the wash cycle 9 (60°).

DAILY USE

Prepare the laundry by following the suggestions appearing under the “TIPS AND SUGGESTIONS” section.

-Press the ON/OFF button .

-Open the door. Load the laundry while making sure not to exceed the maximum load quantity indicated in the wash cycle table.

-Pull out the detergent dispenser drawer and pour the detergent into the relevant compartments, as described in the “DETERGENT DISPENSER DRAWER” section.

-Close the door.

-Modify the temperature and/or spin.

-Select the desired wash cycle.

-Select the desired options.

- Press the START/PAUSE button to start the wash cycle; the relative

indicator light will light up steady and the door will lock ( symbol on).

PAUSING A CYCLE

To pause the wash cycle, press the START/PAUSE		button again. To start
the wash cycle from the point at which it was interrupted, press the
START/PAUSE	button again.

OPENING THE DOOR, IF NECESSARY

Once a cycle starts, the symbol turns on to signal that the door cannot be opened. While a wash cycle is running, the door remains locked. To open the door while a cycle is under way, for example, to add or remove

garments, press the START/PAUSE	button to pause the cycle. If the
symbol is not lit, the door may be opened. Press the START/PAUSE
button again to continue the cycle.

ADDING GARMENTS

An icon on the display will signal when additional garments can be introduced into the washing machine, without decreasing the washing performance. To add garments, first stop the washing machine by pressing

the START/PAUSE	button then open the door and insert them.
Press the START/PAUSE		button again to restart the wash cycle from

the point at which it was interrupted.

CHANGING A RUNNING WASH CYCLE

To change a wash cycle while it is in progress, pause the washing machine

using the START/PAUSE		button, then select the desired cycle and press
the START/PAUSE	button again.

! To cancel a cycle that has already begun, press and hold the ON/OFF button. The cycle will be stopped and the machine will switch off.