REMOTE DISPLAY
USER GUIDE
This wireless device complies with international standards:
FCC
1. FCC Caution:
“Changes or modications not expressly approved by the part responsible
for compliance could void the user’s authority to operate the equipment.”
2. FCC Statement:
“This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.”
IC
RSS-Gen & RSS-247 statement:
“This device complies with Industry Canada licence-exempt RSS
standard(s).
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.”
RSS-247 Statement:
“This equipment complies with Industry Canada radiation exposure limits
set forth for an uncontrolled environment.
Cet équipement est conforme à l’exposition aux rayonnements Industry
Canada limites établies pour un environnement non contrôlé.”
Revision: 001 12/16
This innovative and compact remote display enables you to monitor up to two ARB fridges from the driving position of your vehicle.
The ARB remote display has the ability to receive information from two separate ARB fridges and display the data one fridge at a
time.
Additionally, to ensure that the signal is uninterrupted there are four separate channels to transmit the signal. A special
self-adhesive, swivel mounting bracket is included to enable you to adhere the display in a preferred location within your vehicle.
Your ARB Fridge must be compatible
with the remote display. To conrm
compatibility, there will be a ‘T’ shaped
receptacle on the back of the fridge
near the DC socket to mount the
wireless transmitter (as shown).
CONTENTS
1x Remote Display 1 x Mounting bracket 1 x Aerial 1 x Alcohol Swab
1 x DC power lead 1.8m fused 1 x Sender unit 2 x screws
SPECIFICATIONS
ARB part number - 10900026
Input Voltage - 12/24 VDC (min 9V, max 31.5V)
Power Consumption - 25mA (38mA with backlight)
Signal Range - 15 metres (semi-enclosed environment e.g.
camper trailer)
DC plug - Fuse: 1A F4L 240V (M205)
LCD display - Blue backlight during power-up or as selected.
Duration 10 seconds
FUNCTION
POWER LED:
Displays the status of the fridge
compressor.
Green = compressor ON,
Orange = compressor in standby
mode.
CHECK LED:
Displays the status of the ARB
fridge.
No light - Fridge is operating
correctly
Red ashing light - Fridge requires
checking. Refer to owners
manual for diagnostic check
Wireless signal transmission
channel
1
CH.1
Maximum screw torque 0.9 Nm/0.7ftlb
Number of ARB fridge temperatures to monitor = 2
Number of ARB fridge voltage readings to monitor = 2
Number of wireless signal transmission channel frequencies to
select = 4
The remote display and sender unit are not waterproof; keep
these parts in a dry location away from water.
Weight - 82g/2.9oz
MODE Button:
Allows the selection of functions
within the display.
Display readout for Fridge 1
º
4 C
Temperature readout of Fridge 1
V
.
1 2 8
Voltage display of Fridge 1