The information presented in this manual is not
warranted by APC by Schneider Electric to be
authoritative, error free, or complete. This publication
is not meant to be a substitute for a detailed
operational and site specific development plan.
Therefore, APC by Schneider Electric assumes no
liability for damages, violations of codes, improper
installation, system failures, or any other problems
that could arise based on the use of this Publication.
The information contained in this Publication is
provided as is and has been prepared solely for the
purpose of evaluating data center design and
construction. This Publication has been compiled in
good faith by APC by Schneider Electric. However, no
representation is made or warranty given, either
express or implied, as to the completeness or
accuracy of the information this Publication contains.
IN NO EVENT SHALL APC BY SCHNEIDER
ELECTRIC, OR ANY PARENT, AFFILIATE OR
SUBSIDIARY COMPANY OF APC BY SCHNEIDER
ELECTRIC OR THEIR RESPECTIVE OFFICERS,
DIRECTORS, OR EMPLOYEES BE LIABLE FOR
ANY DIRECT, INDIRECT, CONSEQUENTIAL,
PUNITIVE, SPECIAL, OR INCIDENTAL DAMAGES
(INCLUDING, WITHOUT LIMITATION, DAMAGES
FOR LOSS OF BUSINESS, CONTRACT,
REVENUE, DATA, INFORMATION, OR BUSINESS
INTERRUPTION) RESULTING FROM, ARISING
OUT, OR IN CONNECTION WITH THE USE OF, OR
INABILITY TO USE THIS PUBLICATION OR THE
CONTENT, EVEN IF APC BY SCHNEIDER
ELECTRIC HAS BEEN EXPRESSLY ADVISED OF
THE POSSIBILITY OF SUCH DAMAGES. APC BY
SCHNEIDER ELECTRIC RESERVES THE RIGHT
TO MAKE CHANGES OR UPDATES WITH
RESPECT TO OR IN THE CONTENT OF THE
PUBLICATION OR THE FORMAT THEREOF AT
ANY TIME WITHOUT NOTICE.
Copyright, intellectual, and all other proprietary rights
in the content (including but not limited to software,
audio, video, text, and photographs) rests with APC
by Schneider Electric or its licensors. All rights in the
content not expressly granted herein are reserved. No
rights of any kind are licensed or assigned or shall
otherwise pass to persons accessing this
information.This Publication shall not be for resale in
whole or in part.
Read the following information before installing
or operating your APC by Schneider Electric Rack
Power Distribution Unit (PDU).
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR
ARC FLASH
• The device is intended to be installed and operated
by a skilled person in a controlled location with
restricted access.
• This PDU is intended for indoor use only.
• Do not install this PDU where excessive moisture or
heat is present.
• Never install any wiring, equipment, or PDUs during
a lightning storm.
• Plug this PDU into a three-wire, grounded power
outlet only. The power outlet must be connected to
appropriate branch circuit/mains protection (fuse or
circuit breaker). Connection to any other type of
power outlet may result in a shock hazard.
• Use only the supplied brackets for mounting.
• Do not use extension cords or adapters with this
PDU.
• Do not work alone under hazardous conditions.
• Check that the power cord, plug, and socket are in
good condition.
• To reduce the risk of electric shock when grounding
cannot be verified, disconnect the PDU from the
power outlet before installing or connecting
equipment. Reconnect to the power outlet only after
making all connections.
• Equipment must have a protective earth connector
which carries the leakage current from the load
devices (computer equipment). Do not exceed a
total leakage current
of 3.5 mA.
Failure to follow these instructions will result in
death or serious injury.
NOTICE
EQUIPMENT DAMAGE HAZARD
The ambient operating temperature of a closed or
multi-unit rack environment may be greater than the
ambient temperature of the room. Ensure the ambient
operating temperature of your rack environment does
not exceed the rated ambient operating temperature
for the device.
Failure to follow these instructions can result in
equipment damage.
Basic Rack Power Distribution Unit
1
Page 6
Overview
The APC by Schneider Electric AP9560 is a 30
A rack-mount Power Distribution Unit (PDU) that
provides 100-120 VAC power to
rack-mount equipment.
AP9560
20 A circuit breakers (2)
NEMA 5-20 outlets (10)
12-ft NEMA L5-30 power cord
pdu0072a
2
Basic Rack Power Distribution Unit
Page 7
Installation
PDUs can be mounted in any standard
EIA-310 rack or enclosure.
Horizontal mounting
1. Attach the horizontal mounting brackets
(provided) to the PDU. Use only the supplied
screws
2. Install the PDU using the screws and
caged nuts included with your rack or
enclosure. The PDU will occupy
1 U-space.
pdu0085a
Basic Rack Power Distribution Unit
pdu0080a
3
Page 8
Vertical mounting
1. Attach the vertical-mounting brackets to
the PDU.
pdu0090a
2. Install the PDU on a vertical mounting rail
in your rack or enclosure.
pdu0083a
4
Basic Rack Power Distribution Unit
Page 9
Specifications
Electrical
Input voltage rangeAP9560: 100–120 V
Max current drawAP9560: 24 A
Physical
Dimensions
(H × W × D)
Shipping dimensions
(H × W × D)
Weight2.5 kg (5.5 lb)
Shipping weight3.6 kg (8.0 lb)
4.45 × 44.70 × 5.72 cm
(1.75 × 17.60 × 2.25 in)
15.20 × 48.60 × 17.65 cm
(6.00 × 19.12 × 6.95 in)
Environmental
Elevation (above MSL)
Operating
Storage
Temperature
Operating
Storage
Humidity
Operating
Storage
Compliance
Safety cULus
3 000 m (10, 000 ft)
15 000 m (50,000 ft)
– 5 to 45°C (23 to 113°F)
– 25 to 65°C (– 13 to 149°F)
5–95%, non-condensing
5–95%, non-condensing
Life-Support Policy
General policy
APC by Schneider Electric does not recommend the
use of any of its products in the following situations:
• In life-support applications where failure or
malfunction of the APC by Schneider Electric
product can be reasonably expected to cause
failure of the life-support device or to affect
significantly its safety or effectiveness.
• In direct patient care.
APC by Schneider Electric will not knowingly sell its
products for use in such applications unless it
receives in writing assurances satisfactory to
Schneider Electric
damage have been minimized, (b) the customer
assumes all such risks, and (c) the liability of
American Power Conversion is adequately protected
under the circumstances.
Basic Rack Power Distribution Unit
that (a) the risks of injury or
APC by
5
Page 10
Examples of life-support devices
The term life-support device includes but is not limited
to neonatal oxygen analyzers, nerve stimulators
(whether used for anesthesia, pain relief, or other
purposes), autotransfusion devices, blood pumps,
defibrillators, arrhythmia detectors and alarms,
pacemakers, hemodialysis systems, peritoneal
dialysis systems, neonatal ventilator incubators,
ventilators (for adults and infants), anesthesia
ventilators, infusion pumps, and any other devices
designated as “critical” by the
Hospital-grade wiring devices and leakage current
protection may be ordered as options on many
UPS
systems. APC does not claim that units with
these modifications are certified or listed as hospitalgrade by
these units do not meet the requirements for use in
direct patient care.
APC or any other organization. Therefore
U.S. FDA.
Factory Warranty
This warranty applies only to the products you
purchase for your use in accordance with this manual.
Terms of warranty
APC by Schneider Electric warrants its products to be
free from defects in materials and workmanship for a
period of two years from the date of purchase. APC
by Schneider Electric will repair or replace defective
products covered by this warranty. This warranty does
not apply to equipment that has been damaged by
accident, negligence or misapplication or has been
altered or modified in any way. Repair or replacement
of a defective product or part thereof does not extend
the original warranty period. Any parts furnished
under this warranty may be new or
factory-remanufactured.
APC
Non-transferable warranty
This warranty extends only to the original purchaser
who must have properly registered the product. The
product may be registered at the APC by Schneider
Electric website, www.apc.com.
Exclusions
APC by Schneider Electric shall not be liable under
the warranty if its testing and examination disclose
that the alleged defect in the product does not exist or
was caused by end user’s or any third person’s
misuse, negligence, improper installation or testing.
Further, APC by Schneider Electric shall not be liable
under the warranty for unauthorized attempts to repair
or modify wrong or inadequate electrical voltage or
connection, inappropriate on-site operation
conditions, corrosive atmosphere, repair, installation,
exposure to the elements, Acts of God, fire, theft, or
installation contrary to APC by Schneider Electric
recommendations or specifications or in any event if
the APC by Schneider Electric serial number has
been altered, defaced, or removed, or any other
cause beyond the range of the intended use.
6
Basic Rack Power Distribution Unit
Page 11
THERE ARE NO WARRANTIES, EXPRESS OR
IMPLIED, BY OPERATION OF LAW OR
OTHERWISE, OF PRODUCTS SOLD, SERVICED
OR FURNISHED UNDER THIS AGREEMENT OR IN
CONNECTION HEREWITH. APC BY SCHNEIDER
ELECTRIC DISCLAIMS ALL IMPLIED
WARRANTIES OF MERCHANTABILITY,
SATISFACTION AND FITNESS FOR A
PARTICULAR PURPOSE. APC BY SCHNEIDER
ELECTRIC EXPRESS WARRANTIES WILL NOT BE
ENLARGED, DIMINISHED, OR AFFECTED BY AND
NO OBLIGATION OR LIABILITY WILL ARISE OUT
OF, APC BY SCHNEIDER ELECTRIC RENDERING
OF TECHNICAL OR OTHER ADVICE OR SERVICE
IN CONNECTION WITH THE PRODUCTS. THE
FOREGOING WARRANTIES AND REMEDIES ARE
EXCLUSIVE AND IN LIEU OF ALL OTHER
WARRANTIES AND REMEDIES. THE
WARRANTIES SET FORTH ABOVE CONSTITUTE
APC BY SCHNEIDER ELECTRIC’S SOLE
LIABILITY AND PURCHASER’S EXCLUSIVE
REMEDY FOR ANY BREACH OF SUCH
WARRANTIES. APC WARRANTIES EXTEND ONLY
TO PURCHASER AND ARE NOT EXTENDED TO
ANY THIRD PARTIES.
IN NO EVENT SHALL APC BY SCHNEIDER
ELECTRIC, ITS OFFICERS, DIRECTORS,
AFFILIATES OR EMPLOYEES BE LIABLE FOR
ANY FORM OF INDIRECT, SPECIAL,
CONSEQUENTIAL OR PUNITIVE DAMAGES,
ARISING OUT OF THE USE, SERVICE OR
INSTALLATION, OF THE PRODUCTS, WHETHER
SUCH DAMAGES ARISE IN CONTRACT OR TORT,
IRRESPECTIVE OF FAULT, NEGLIGENCE OR
STRICT LIABILITY OR WHETHER APC BY
SCHNEIDER ELECTRIC HAS BEEN ADVISED IN
ADVANCE OF THE POSSIBILITY OF SUCH
DAMAGES. SPECIFICALLY, APC BY SCHNEIDER
ELECTRIC IS NOT LIABLE FOR ANY COSTS,
SUCH AS LOST PROFITS OR REVENUE, LOSS OF
EQUIPMENT, LOSS OF USE OF EQUIPMENT,
LOSS OF SOFTWARE, LOSS OF DATA, COSTS OF
SUBSTITUTES, CLAIMS BY THIRD PARTIES, OR
OTHERWISE.
NO SALESMAN, EMPLOYEE OR AGENT OF APC
BY SCHNEIDER ELECTRIC IS AUTHORIZED TO
ADD TO OR VARY THE TERMS OF THIS
WARRANTY. WARRANTY TERMS MAY BE
MODIFIED, IF AT ALL, ONLY IN WRITING SIGNED
BY AN APC BY SCHNEIDER ELECTRIC OFFICER
AND LEGAL DEPARTMENT.
Warranty claims
Customers with warranty claims issues may access
the APC by Schneider Electric customer support
network through the Support page of the APC by
Schneider Electric website, www.apc.com/support.
Select your country from the country selection pulldown menu at the top of the Web page. Select the
Support tab to obtain contact information for customer
support in your region.