ANALOG DEVICES AD1884 Service Manual

High Definition Audio
a
FEATURES
FOUR 192 kHz DACs/ADCs
48, 88.2, 96, 176.4, and 192 kHz sample rates 16, 20, and 24-bit resolution Selectable stereo mixer on outputs
S/PDIF OUTPUT
Supports 44.1, 48, 88.2, 96, 176.4, and 192 kHz sample rates 16, 20, and 24-bit data; PCM, and AC3 formats Digital PCM gain control
DEDICATED AUXILIARY PINS
Stereo CD/auxiliary I/O port w/GND sense Stereo auxiliary/dock I/O port Mono out pin for internal speakers or telephony
SoundMAX
®
ENHANCED FEATURES
Two stereo headphone amplifiers Microsoft Vista premium logo for notebook
90 dB audio outputs, 85 dB audio inputs Internal 32-bit arithmetic for greater accuracy Impedance and presence detection on all jacks Three independent microphone bias pins Digital and analog PCBeep Three general-purpose digital I/O (GPIO) pins
3.3 V analog and digital supply voltages Advanced power management modes 48-lead, Pb-free LFCSP_VQ package
Codec
AD1884
H D
A U D
I
O
I N T E R F A C E
Rev. 0
Information furnished by Analog Devices is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other rights of third parties that may result from its use. Specifications subject to change without notice. No license is granted by implication or otherwise under any patent or patent rights of Analog Devices. Trademarks and registered trademarks are the property of their respective owners.
DAC1
DAC0
S/PDIF OUT
DIGITAL PCBEEP
ADC0
ADC1
Figure 1. Functional Block Diagram
AD1884
HP
HP
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106 U.S.A. Tel: 781.329.4700 www.analog.com Fax: 781.461.3113 ©2007 Analog Devices, Inc. All rights reserved.
PORT A
PORT D
MONO OUT
PORT E
PORT F
PCBEEP
PORT C
PORT B
AD1884

CONTENTS

General Description ................................................. 3
Additional Information ......................................... 3
Jack Configurations .............................................. 3
AD1884 Specifications .............................................. 4
Test Conditions ................................................... 4
Performance ........................................................ 4
General Specifications ............................................ 4
HD–Audio Link Specification .................................. 6
Power Down States ............................................... 7
Absolute Maximum Ratings ....................................... 8
ESD Sensitivity ..................................................... 8
Environmental Conditions ...................................... 8
Pin Configuration and Function Descriptions ................. 9
HD Audio Widgets ................................................ 12
AD1884 HD Audio Parameters ................................. 13
Outline Dimensions ............................................... 15
Ordering Guide ..................................................... 15

REVISION HISTORY

1/07–Rev 0: Initial version
Rev. 0 | Page 2 of 16 | January 2007

GENERAL DESCRIPTION

The AD1884 family of audio codecs and SoundMAX® software provides superior high definition audio quality that exceeds Vista Premium for notebook performance. The AD1884 has four 192 kHz DACs, four 192 kHz ADCs, S/PDIF output, Digi­tal Beep and analog PCBeep. These features make the AD1884 the right choice for notebook PCs that meet the Microsoft Vista premium performance specifications as well as desktop PCs that meet the Microsoft Vista Basic performance specifications.
The AD1884 is available in a 48-lead, Pb-free frame chip scale package in both reels and trays. See Ordering Guide on Page 15.

ADDITIONAL INFORMATION

This data sheet provides a general overview of the AD1884 SoundMAX codec’s architecture and functionality. Additional information on the AD1884 is available in the AD1884 Pro­grammers Reference Manual. Please contact your local ADI sales representative for more information. For information on SoundMAX codecs and software see Analog Devices website at
http://www.analog.com/soundMAX.

JACK CONFIGURATIONS

The guideline shown in Table 1 should be used when selecting ports for particular functions. The symbols used in this table are defined as: LI = Line Level Input, LO = Line Level Output, HP = Output capable of driving headphone load, MIC = Input supports microphones with MIC bias and boost amplifier.
AD1884
Table 1. Port Assignments
Port HP MIC LO LI
Port A Port B Port C Port D Port E Port F MONO_OUT
x
x x
x
x
x
x x x x
x x
x x
Rev. 0 | Page 3 of 16 | January 2007
AD1884

AD1884 SPECIFICATIONS

TEST CONDITIONS

Parameter Test Condition
Tem pe ra tu re 25°C Digital Supply 3.3 V Analog Supply 3.3 V MIC_BIAS_IN (via Low-Pass Filter) 5.0 V Sample Rate f
S
Input Signal (Frequency Sine Wave)
Amplitude for THD + N Analog Output Pass Band DAC
ADC

PERFORMANCE

Parameter Min Typ Max Unit
Line Out Drive (10 kΩ loads—DAC to Pin)
Total Harmonic Distortion (THD + N) –84 dB
Dynamic Range (–60 dB in ref to fS A-Weighted) 90 dB
Signal-to-Noise Ratio 90 dB Headphone Drive (32 Ω loads—DAC to Pin)
Total Harmonic Distortion (THD + N)
Dynamic Range (–60 dB in ref to f
Signal-to-Noise Ratio 90 dB Microphone/Line In (Pin to ADC, Mic Boost = 0 dB)
Total Harmonic Distortion (THD + N)
Dynamic Range (–60 dB in ref to f
Signal-to-Noise Ratio 85 dB
48 kHz 1008 Hz –3.0 dB Full Scale 20 Hz to 20 kHz 10 kΩ Output Load: Line Out Tests 32 Ω Output Load: Headphone Tests 0 dB Gain
–74 dB
A-Weighted) 90 dB
S
–78 dB
A-Weighted) 85 dB
S

GENERAL SPECIFICATIONS

Parameter Min Typ Max Unit
DIGITAL DECIMATION AND INTERPOLATION FILTERS
Pass Band – fS (kHz) = 8 ~ 192 Pass-Band Ripple– f Stop Band – f Stop-Band Rejection – f Group Delay – f
(kHz) = 8 ~ 192
S
(kHz) = 8 ~ 192
S
(kHz) = 8 ~ 192
S
(kHz) = 8 ~ 192
S
Group Delay Variation Over Pass Band
ANALOG TO DIGITAL CONVERTERS
Resolution Gain Error Interchannel Gain Mismatch (Difference of Gain Errors) ADC Offset Error ADC Crosstalk
2
(Full-Scale Span Relative to Nominal Input Voltage)
1
1
Line Inputs (Input L, Ground R, Read R; Input R, Ground L, Read L) Line_In to Other
1
0
0.6 f
S
20 0
24
±0.2
–85 –100
0.4 f
S
±0.005
–100
±10 ±0.5 ±5
–80
Hz dB Hz dB 1/f μs
Bits % dB mV
dB dB
S
Rev. 0 | Page 4 of 16 | January 2007
AD1884
Parameter Min Typ Max Unit
DIGITAL TO ANALOG CONVERTERS
Resolution Gain Error1 (Full Scale Span Relative to Nominal Input Voltage) Interchannel Gain Mismatch (Difference of Gain Errors) Total Audible Out-of-Band Energy1 (Measured from 0.6 × fS to 20 kHz) DAC Crosstalk
1
(Input L, Zero R, Measure R_OUT; Input R, Zero L, Measure L_OUT)
DAC VOLUMES
Step Size (DAC-0, DAC-1) Output Gain/Attenuation Range Mute Attenuation of 0 dB Fundamental
1
ADC VOLUMES
Step Size (ADCSEL-0, ADCSEL-1) PGA Gain/Attenuation Range –58.5
ANALOG MIXER
Signal-to-Noise Ratio Input to Output – Ports B, C, or F, to Port D Output Step Size: All Mixer Inputs Input Gain/Attenuation Range: All Mixer Inputs –34.5
ANALOG LINE LEVEL OUTPUTS
Full-Scale Output Voltage: Line Out Drive Enabled Ports A, D, E, F, and Mono Out
Output Impedance External Load Impedance Output Capacitance
1
1
1
External Load Capacitance
ANALOG HP DRIVE OUTPUTS
Full-Scale Output Voltage: Line Out Drive Enabled Ports A and D (when HP Drive is Enabled)
Output Impedance External Load Impedance Output Capacitance External Load Capacitance
1
1
1
1
ANALOG INPUTS
Input Voltages—Port B, C, or E
Mic Boost = 0 dB
Input Voltages—Microphone Boost Amplifier, Ports B, C, or E
Mic Boost = +10 dB
Mic Boost = +20 dB
Mic Boost = +30 dB
Input Impedance
PCBEEP Ports B, C, E (Mic Boost = 0 dB) Port F
Input Capacitance
1
–58.5
1.0
2.83
10
1.0
2.83
32
24
±10 ±0.5
–85 –95
1.5 0
–80
1.5 +22.5
90
–1.5
+12.0
Bits % dB dB dB
dB dB dB
dB dB
dB dB dB
V rms V p-p
190
Ω
kΩ
15
1000
pF pF
V rms V p-p
0.5
Ω Ω
15
1000
1
2.83
0.316
0.894
0.1
0.283
0.032
0.089
23 150 45 5 7.5
pF pF
V rms V p-p
V rms V p-p V rms V p-p V rms V p-p
kΩ kΩ kΩ pF
3
Rev. 0 | Page 5 of 16 | January 2007
Loading...
+ 11 hidden pages