ALTANA Micro-Gloss Short Instructions

Additives & Instruments
A member of
Measure what you see.
micro-gloss Operation
operate
Main menu
Mode } Geometry/Sensor }
Memory }
Difference } Calibration } Setup *}
mode wheel:
Switch on press
Show menu press
Select function scroll
Activate function press
operate-button:
Measure
Navigation Symbols:
¢
Back to previous menu
¢
} Got to sub-menu
3 Function activated
* Guide to language menu
How to calibrate?
Gloss
Turn on the unit in holder
Autodiagnosis
Please clean standard
Confirm ¢ [mode]
Cancel ¢ [operate]
Thickness (only micro-TRI-gloss μ)
Main menu
Calibration }
Calibrate }
Thickness Fe }
Thickness NFe }
*It is advisable, to perform the zero calibration on the uncoated metal of the sample to be tested.
Autodiagnosis checks standard
and calibration
If requested, clean the standard
and start calibration by pressing the mode wheel
Select the desired sensor
(Fe or NFe)
Put the unit on the zero
standard or original substrate*
Press operate button
Hold the unit free in air and
press operate
BYK-Gardner GmbH · Lausitzer Strasse 8 · 82538 Geretsried · Germany · Tel. +49-8171-3493-0 · Fax +49-8171-3493-140 · www.byk.com/instruments
269 020 584 E 0806
Please note the detailed operating instructions in English on CD.
Measure what you see.
Additives & Instruments
A member of
How to measure?
Main menu
Mode
Sample mode
Statistics
Continuous
Basic mode
Advanced mode
Select the desired measuring mode:
Measurement without statistical evaluation
Multiple measurement with statistics
Continuous measuring with adjustable interval
Measuring without statistics/saving/difference
Reactivates all menus and functions when Basic mode was activated
How to measure differences?
Main menu
Difference
Difference
Measure standard
Select standard
Create standard
Delete standard
Change standard
How to save?
Main menu
Geometry/Sensor
Display example:
MEMORY 001 STANDARD 2
x stdev diff 20° 49.6 2.1 -8.9 60° 78.3 1.3 -3.5
Select geometry and thickness
sensor where appropriate
Measure with operate button
SAMPLE 012
n = 02/03
If Memory on: Memory name Sample name
If Difference on: Standard name
If Statistics on: Number of measurements
Main menu
Memory
Memory
Select memory
Create memory
Delete memory
Display memory
Following functions can be used together:
Difference with Sample mode, Statistics
Memory with Sample mode, Statistics, Continuous
How to change settings?
Main menu
Setup
BYK-Gardner USA · 9104 Guiford Road · Columbia · MD 21046 · USA · Phone +1-301-483-6500 · Fax +1-301-483-6555 · www.byk.com/instruments
Select Difference and activate
the desired function:
Turn difference measurement on/off
Measure a standard (target value)
Select a standard from list (if saved)
Enter up to 50 standards
Delete individual standards
Define target and limits for Pass/Fail
Select Memory and activate
the desired function:
Turn saving on/off
Select a memory from list
Enter up to 50 memories
Delete memory content or memory name
Recall memory content (use scrollwheel)
Select menu Setup to change:
Language, Switch-off time, Clock, Beeper and Bluetooth connection on/off
260 020 740 E 0812
Loading...