This symbol means important
instructions.
Failure to heed them can result in serious
injury or death.
DO NOT WATCH VIDEO WHILE DRIVING.
Watching the video may distract the driver from looking
ahead of the vehicle and cause an accident.
DO NOT OPERATE ANY FUNCTION THAT TAKES
YOUR ATTENTION AWAY FROM SAFELY DRIVING
YOUR VEHICLE.
Any function that requires your prolonged attention should
only be performed after coming to a complete stop. Always
stop the vehicle in a safe location before performing these
functions. Failure to do so may result in an accident.
KEEP THE VOLUME AT A LEVEL WHERE YOU CAN
STILL HEAR OUTSIDE NOISE WHILE DRIVING.
Failure to do so may result in an accident.
INSTALL THE PRODUCT CORRECTLY SO THAT THE
DRIVER CANNOT WATCH TV/VIDEO UNLESS THE
VEHICLE IS STOPPED AND THE EMERGENCY BRAKE
IS APPLIED.
It is dangerous (and illegal in many states) for the
driver to watch the TV/Video while driving the vehicle.
The driver may be distracted from looking ahead and
an accident could occur. If the product is not installed
correctly, the driver will be able to watch the TV/Video
while driving the vehicle and may be distracted from
looking ahead causing an accident. The driver or other
people could be severely injured.
MINIMIZE DISPLAY VIEWING WHILE DRIVING.
Viewing the display may distract the driver from looking
ahead of the vehicle and cause an accident.
DO NOT DISASSEMBLE OR ALTER.
Doing so may result in an accident, fi re or electric shock.
USE THIS PRODUCT FOR MOBILE 12V APPLICATIONS.
Use for other than its designed application may result in
fi re, electric shock or other injury.
KEEP SMALL OBJECTS SUCH AS BATTERIES OUT OF
THE REACH OF CHILDREN.
Swallowing them may result in serious injury. If
swallowed, consult a physician immediately.
DO NOT PLACE HANDS, FINGERS OR FOREIGN
OBJECTS IN INSERTION SLOTS OR GAPS.
Doing so may result in personal injury or damage to the
product.
USE THE CORRECT AMPERE RATING WHEN
REPLACING FUSES.
Failure to do so may result in fi re or electric shock.
DO NOT BLOCK VENTS OR RADIATOR PANELS.
Doing so may cause heat to build up inside and may result
in fi re.
This symbol means important
instructions.
Failure to heed them can result in injury
or material property damage.
HALT USE IMMEDIATELY IF A PROBLEM APPEARS.
Failure to do so may cause personal injury or damage to the
product. Return it to your authorized ALPINE dealer or the
nearest ALPINE Service Center for repairing.
KEEP FINGERS OR ANY OBJECT AWAY WHEN CLOSING THE
MONITOR.
Failure to do so may result in personal injury or damage to the
product.
DO NOT MIX NEW BATTERIES WITH OLD BATTERIES. INSERT
WITH THE CORRECT BATTERY POLARITY.
When inserting the batteries, be sure to observe proper polarity (+
and –) as instructed.
Rupture or chemical leakage from the battery may cause fi re or
personal injury.
Temperature
Be sure the temperature inside the vehicle is between
+60°C (+140°F) and -10°C (+14°F) before turning your unit on.
Fuse Replacement
When replacing the fuse(s), the replacement must be of the same
amperage as shown on the fuse holder. If the fuse(s) blows more
than once, carefully check all electrical connections for shorted
circuitry. Also have your vehicle’s voltage regulator checked.
Maintenance
If you have problems, do not attempt to repair the unit yourself.
Return it to your ALPINE dealer or the nearest ALPINE Service
Station for servicing.
Installation Location
Make sure the TMX-R1000P will not be exposed to:
• Direct sun and heat • Excessive dust
• High humidity • Excessive vibrations
Characteristics of LCD Panel
• After turning the system off, a slight ghost of the image
will remain temporarily. This is an effect peculiar to LCD
technology and is normal.
• Under cold temperature conditions, the screen may lose
contrast temporarily. After a short warm-up period, it will
return to normal.
• The LCD panel is manufactured using an extremely high
precision manufacturing technology. Its effective pixel ratio
is over 99.99%. This means that 0.01% of the pixels could be
either always ON or OFF.
Using Wireless Headphones
If ACC or the monitor's power source is turned off, a loud noise is
produced through the headphones. Be sure to remove the wireless
headphones from your ears before you turn the monitor off.
• 10.2 inch Wide VGA TFT Active Matrix Color LCD
(800 x 480)
• 3 AUX In / 1 AUX Out
• 1 Remote In / 2 Remote Out
• Front Panel Controls (OHM / DVD / DVD-HU / TV
Tuner)
• Visual EQ (FLAT, NIGHT MOVIE, SOFT, SHARP,
CONTRAST)
• Independent parameter setting on each AUX input
(Picture/Visual EQ/Audio Input Level/Display
Mode)
• 3 Level Dimmer (HIGH/MID/LOW)
• CH Selectable IR Transmitter for IR Headphones
(A/B/OFF)
• DVD Power Control
• Customized OSD Source Name
• White LED Dome Light
LCD Monitor Panel
This is a 10.2 inch, Wide VGA, Active Matrix LCD. In
addition, an Infrared Wireless Headphone Transmitter is
located on top of the LCD panel.
• The power state of the monitor is memorized when
Ignition/ACC is turned off. When Ignition/ACC is
turned back on, the monitor returns to the power state
memorized (either ON or OFF).
Monitor Open Button
Press Monitor Open Button to release the Monitor Panel.
The Panel will drop down slightly allowing you to fully
open to its 90 degree or greater position. To close, fi rmly
press the LCD Monitor Panel back up into the housing
until a click is heard.
White LED Dome Light
White LED Dome Light connection has polarity. Be
cautious when installing the monitor. Refer to Dome Light
Connection (Page 16).
Back-Lit Function Buttons
Blue, back-lit function button illuminates when the
overhead monitor main power is on. Overhead monitor,
DVD player, DVD-HU and TV tuner can be controlled by
using these buttons.
Overhead Monitor
White LED Dome Light
Infrared Wireless
Headphone
Transmitter
LCD Monitor Panel
Back-Lit Function
Button
Aux 3 Input
Monitor Open Button
Dome Light Switch
Remote Control
TMX-R1000P Overhead
Monitor Control
ALPINE DVD Player
Control
(Refer to DVA-5210
or DVE-5207 Owner’s
Manual)
ALPINE TV-Tuner Control
(Refer to ALPINE TVTuner Owner’s Manual)
When you use Remote Control for the fi rst time, pull the
plastic tape before using the remote control.