Alcatel-Lucent OmniAccess AP80 User Manual

The Alcatel-Lucent OmniAccess AP80M is the ideal wireless solution for harsh outdoor environments where conven-

tional Wi-Fi access points cannot be deployed. The OmniAccess AP80M is a dual-radio 802.11a/b/g access point that

also supports wireless air monitoring capability. Designed for extreme, all-weather deployment (such as extreme heat,

cold, rain), the OmniAccess AP80M operates as a “thin” AP, fully controlled and managed by an OmniAccess WLAN

switch. The OmniAccess AP80M’s flexible design supports a variety of attachable antennas and supports an integrated

PPP over Ethernet client for remote deployments over service provider networks.

Network Configuration

• Wireless access point (802.11a/b/g)

• Air monitor (802.11a/b/g)

Antennas

• None. External N-type antenna interfaces
provided (see Electrical Enterfaces section)

Radio Specs - 5GHZ - IEEE 802.11a

• Frequency bands supported
¬ 5.150 ~ 5.250 GHz (low band),

country specific

¬ 5.250 ~ 5.350 GHz (mid band),

country specific
¬ 5.470 ~ 5.725 GHz (Europe), country specific
¬ 5.725 ~ 5.825/5.850 GHz (high band),

country specific

• Radio technology: orthogonal frequency
division multiplexing (OFDM)• Modulation
type – BPSK, QPSK, 16-QAM, 64-QAM

• Transmit power – configurable by system
administrator/professional installer

• MAC – CSMA/CA with ACK

• Operating channels:
¬ US, Canada - 13
¬ ETSI - up to 19
¬ Japan - disabled

• Data rates: 6, 9, 12, 18, 24, 36, 48, 54
Mbps per channel

• Radio band selectable via software

• Multi-mode radio band 802.11a or 802.11b/g
selectable via software

Radio Specs – 2.4GHZ - IEEE 802.11b

• Frequency bands supported
¬ 2.400 ~ 2.4835/2.497 GHz, channels

country specific

• Radio technology – direct sequence spread
spectrum (DSSS)

• Modulation type – CCK, BPSK, QPSK

• Transmit power – configurable by system
administrator

• MAC – CSMA/CA with ACK

• Operating channels:
¬ US, Canada - 11
¬ ETSI – up to 13
¬ Japan - 14

• Data rates: 1, 2, 5.5, 11 Mbps per channel

• Radio band selectable via software

• Multi-mode radio band 802.11a or 802.11b/g
selectable via software

Radio Specs – 2.4GHZ - IEEE 802.11g

• Frequency bands supported
¬ 2.400 ~ 2.4835 GHz, channels country specific

• Radio technology: orthogonal frequency
division multiplexing (OFDM)

• Modulation type – BPSK, QPSK, 16-QAM,
64-QAM

• Transmit power – configurable by system
administrator

• MAC – CSMA/CA with ACK

• Operating channels:
¬ US, Canada - 11
¬ ETSI – up to 13
¬ Japan - 13

TECHNICAL SPECIFICATIONS

Alcatel-Lucent OmniAccess AP80

DUAL-RADIO 802.11A/B/G ACCESS POINT

www.alcatel-lucent.com

Alcatel, Lucent, Alcatel-Lucent and the Alcatel-Lucent logo are trademarks of Alcatel-Lucent. All other
trademarks are the property of their respective owners. Alcatel-Lucent assumes no responsibility for the
accuracy of the information presented, which is subject to change without notice.
© 2007 Alcatel-Lucent. All rights reserved. P/N 031883-00 Rev. E 8/07

ORDERING INFORMATION

PART NUMBER DESCRIPTION

OAW-AP80M Alcatel-Lucent OAW-AP80M outdoor wireless access point. Includes one OAW-AP80M (simultaneous 802.11 “A”+ “B/G”) with dual N-type

detachable antenna interfaces (1 x 2.4Ghz band and 1 x 5Ghz band), 1 x 10/100 BaseT (8Pin DIN) Ethernet interface (supports high power­over-Ethernet, integral power lightening arrester and ground point), 1 x RSSI DC alignment interface, pole / mast mounting hardware and
Installation Guide. Also includes: indoor use only auto-sensing 110/240VAC to 48VDC power-over-Ethernet injector suitable for use with the
OAW-AP80M wireless access points and 100 foot outdoor Ethernet cable (8Pin DIN to 10/100BaseT RJ-45). External antennas and antenna
lightning arrestor shall be purchased separately.

OAW-AP-LAR-1 Outdoor antenna lightning arrestor. Lightning surge arrestor for the OAW-AP80 access point: Single, in-line lightening arrester with N-type

male to N-type female interface. Supports RF frequency pass through of 2Ghz – 6Ghz.

External antenna: Alcatel-Lucent offers a wide variety of outdoor rated detachable antenna types certified for use with the OmniAccess AP80M. Please contact your
local sales representative for details.

• Data rates: 6, 9, 12, 18, 24, 36,
48, 54 Mbps per channel

• Radio band selectable via
software

• Multi-mode radio band 802.11a
or 802.11b/g selectable via
software

Manageability

• Management of all 802.11
parameters as AP

• Network-wide AP management
via:

¬ CLI
¬ Web GUI
¬ SNMP

• Access point profiles

• Management by:
¬ Geographical location
¬ BSSID
¬ Radio type

• Encryption support (AP and
WLAN switch)

¬ 40-bit / 64-bit / 128-bit / 152-

bit WEP, TKIP, AES, WPA, WPA2

Interfaces-Electrical

• 1 x 10/100 Base-TX auto-sensing
Ethernet interface (IP67 8-pin
male (pole) M12 circular DIN
connector (Au) contacts):

¬ Auto-sensing MDI/MDX
¬ PoE 48V DC / 1.2A (30W)

power over Ethernet (non­standard 802.3af)

¬ Integral lightning arrester

• 1 x 2.4 Ghz N-type female
antenna Interface

• 1 x 5 Ghz N-type female anten-

na Interface

• 1 x electrical ground / safety
terminal

• 1 x Integral ENET lightening
arrester

Power Adapter Interfaces

Access point (AP) port

• 1 x 10/100 Base-TX auto-sensing
Ethernet (RJ-45) network (AP)
interface:

¬ Auto-sensing MDI/MDX
¬ PoE 48V DC / 1.2A power over

Ethernet (non-standard 802.3af)

Network (ENET) Port

• 1 x 10/100 Base-TX auto-sens­ing Ethernet (RJ-45) network
(ENET), auto-sensing MDI/MDX
Ethernet interface supplied with
8-Pin DIN to RJ-45 CAT-5 shield­ed Ethernet cable (164 ft / 50 m)

Interfaces-Mechanical

• 4 x mounting bracket points

• Ruggedized pole or mast mount
hardware provided
(articulating in horizontal and
vertical planes)

• Ruggedized wall mount hard­ware as an available option.

Visual Indicators (LEDS)

• (Ready) power on/off (provided
on power Injector)

Power Requirements

• Access point power draw - 48V
DC / 1.2A (30W) power-over­Ethernet (non-standard 802.3af)

• External power injector, auto­sensing 100-240V AC Input,

1.5A output 48 VDC, 1.2A
(30W) (provided)

Device Dimensions H/W/D

• 7.80 x 7.80 x 2.76in. (198 x 198
x 70mm)

• Weight - 3.53Ibs (1.6Kilo)

Shipping Dimensions
H/W/D

• 19.7 x 11.8 x 6.7in. (500 x 300 x
170mm)

• Gross weight - 13.22lbs (6Kilos)

Environmental

• Temperature
¬ Operating: -22 to 131 ºF (-30

to 55 ºC)

¬ Storage: -40 to 176 ºF (-40 to

80 ºC)

• Humidity 0% - 95% (non-con­densing)

• Survival wind speed: 201Km/hr /
125mph

External Power Adapter

• Temperature
¬ Operating: 32 to 140 ºF (0 to

60 ºC)

¬ Storage: -58 to 158 ºF (-50 to

70 ºC)

• Humidity 0% - 95% (non-con­densing)

Mounting Options

• Pole or mast mount
(hardware included)

• Wall mount (optional hardware)

Standards

• Ethernet IEEE 802.3 / IEEE

802.3u

• Wireless IEEE 802.11a/b/g

• PPP over Ethernet RFC2516

Radio Approvals

• FCC DOC Part 15 Class B
(digital portion)

• FCC Part 15 subpart C 15.247

• FCC Part 15 subpart E 15.407

• ICES-003 Class B

• RSS 210 (Canada)

• VCCI Class B (Japan)

• Telec 2.4, Channel 14 and 5 GHz
approved (Japan)

• CE marked with NB letter of
opinion for RTTE

¬ ETS 300 328 2.4 GHz
¬ ETS 301 893 5.4 GHz
¬ ETS 301 489 EMC

• MIC Korea

• SRRC (China)

• AS/NZS 3548 Class B

• AS/NZS4771 (C-tick)

Safety Approvals

• cULus listed

• PSE Mark (AC power supply)

• IEC 60950 CB certificate and
report

• UL Listed (UL60950)

• UL Listed (Canadian Electrical
Code/CSA 22.2 No. 60950)

• EN60950 / IEC60950