AIPTEK AV100 SC1, AV100, DIGIPORTEC, DIGIPROTEC User Manual
Specifications and Main Features
- Type of Camera: Color CMOS sensor
- Camera Resolution: 300,000 pixels
- Transmit frequency: 2.400 GHz ~ 2.483 GHz (4 channels)
- Frequency Deviation: +100KHz (10 degree celsius to 50 degree celsius)
- Modulation type: FM
- RF output power: 10dBm (Vcc = 5V, output impedance = 75 ohm)
- Antenna Type: DIPOLE (85mm)
- Minimum illumination: 3 Lux (at F2.8)
- built in microphone: yes
- Camera Power Source: 6V DC 1A
- Temperature Range: 10 degree celsius to 50 degree celsius
- Operation Humidity: 5% to 85%
- Transmission Range: 30 meters (open space)
- Monitor Type: 1.8inch TFT LCD
- channels frequency: 2.400 GHz to 2.483 GHz (4 CHANNELS)
- Monitor power source: 6v DC 1A or 4 x AA NI-MH rechargeable batteries
- Power consumption: 2.3W
- Environmental Condition: 10 degree celsius – 50 degree celsius
- Dimension of Monitor: 72mm x 108 mm x 34 mm (WxHxD)
Frequently Asked Questions
Q1: What to do when the image and or sound is not very clear ?
A1: Indicate on the camera and also the LCD monitor the other channels (say from CH1 to CH4), try to change the antenna to another position and try rotating the camera and LCD monitor slowly and check if locating other 2.4GHz electronic products cause radio interference.
Q2: What Steps Should I Follow if There Is No Image On the LCD Monitor?
A2: Validate if the batteries have been correctly fitted, the AC power adapter is plugged in, or the batteries need replacement. Make sure that both the camera and monitor have been set on the same channel and the Power On/Off switch is turned on. Also, check if the LCD monitor is currently in the powe saving mode.
Q3: What Is the Time Required to Charge the Batteries For The First Time?
A3 Please wait for about 10 hours before reusing the batteries as this is the first attempt to charge them.
Q4: What Changes When the Power Saving Mode Is Activated?
A4: When the power mode is engaged, the monitor will reactivate automatically when the camera pickup sounds within the preset area.
Q5: What Procedure Should I Follow To Turn Off Power Saving Mode?
A5: Simply depress the Wake Up button for three seconds until the battery status LED is turned on once and it will automatically disable the Power Saving mode.
User Manual
Loading...