Preparing
NOTE 1: These dimensions and templates assume
a door thickness or 1-3/4.” For doors of other thickness, the factory should be consulted.
NOTE 2: CL* denotes vertical centerline of strike within 1/64” of deadlatch centerline.
8400 Mortise Exit Device
Installation Instructions
Phoenix, AZ 85044
Tel: 1-800-872-3267
Mon-Fri: 6:00am - 4:00pm PDT
Fax: 1-800-232-7329
www.adamsrite.com
Mounting the Push Bar
1. DEPRESS latch bolt.
NOTE: The square key on plug must align with square notch on side plate.
2.INSERT bar assembly cam plug thru side plate.
3.INSTALL self-tapping screws on both ends and securely TIGHTEN.
4.TIGHTEN cam plug set screw.
5.INSTALL faceplate.
6.INSTALL end caps (dogging socket at latch end).
|
|
|
|
|
|
|
|
|
|
|
Backset |
|
Door Opening Width |
|
|||
|
|
30” |
|
36” |
42” |
48” |
|
|
|
|
|
|
|
||||
|
|
31/32” or |
26.84 |
|
32.84 |
38.84 |
44.84 |
|
|
Dimension A |
1-1/8” |
|
|
||||
|
|
|
|
|
|
|
||
|
|
1-1/2” |
25.57 |
|
31.57 |
37.57 |
43.57 |
|
|
|
|
|
|
|
|
|
|
Installing the Strike
NOTE: Both strike cup and strike plate must be installed properly to meet code requirements.
1. INSTALL cast strike cup with #10-32 flat head screws.
2. INSTALL strike plate with #10-32 flat head screws.
Installing the Deadlatch
1. ADJUST mounting post to length required to flush faceplate with nose of stile.
2. TIGHTEN lock case securely using #10-32 screws.
IMPORTANT NOTE
Installation must be in accordance to all applicable building and life safety codes.
80-0180-38, Revision H