AcuRite Indoor or Outdoor Clock Instruction Manual

Instruction Manual

Indoor or Outdoor Clock

with Temperature & Humidity

Remove the Weather-Resistant Cover

1

Access the battery compartment by pulling off the weather-resistant cover.

•

Be careful not to damage the cover during removal.

Set the Time

2

Turn the set knob on the back of the clock in either direction.

•

Install or Replace Batteries

3

AcuRite recommends high quality alkaline or lithium batteries for the

•

best product performance. Heavy duty or rechargeable batteries are not
recommended.

The clock requires lithium batteries in low temperature conditions. Cold
temperatures can cause alkaline batteries to function improperly. Use
lithium batteries in the clock for temperatures below -4ºF / -20ºC.

Insert 1 x AA alkaline or lithium battery into the battery compartment,
as shown. Follow the polarity (+/-) diagram in the battery compartment.
Replace the weather-resistant cover.

DO NOT HANG IN DIRECT SUNLIGHT!

For the most accurate temperature readings choose a location that will not be
exposed to direct sunlight or other direct heat sources.

Placement for Maximum Accuracy

AcuRite sensors are sensitive to surrounding environmental conditions. Proper placement
of both the display unit and the sensor are critical to the accuracy and performance of this
product.

LOCATE AWAY FROM HEAT SOURCES

Position clock away from heaters, air conditioners, chimneys, exhaust vents, asphalt and
concrete (surfaces that radiate heat).

LOCATE AWAY FROM HUMIDITY SOURCES

Avoid installing the clock near pools, spas, or other bodies of water. Water sources may
impact humidity accuracy.

Set the Time

2

Remove the
Weather-Resistant

1

Cover

Install Battery

3

1 AA battery

Care & Maintenance

Clock Care

• A soft cloth may be used to clean the clock, as needed.

• Do not use corrosive cleaners or chemicals on the clock.

• Always store the clock without a battery when not in use.

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.

be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of
used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries

in re, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT

recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to