INSTRUCTION BOOKLET |
GAS HOB MODEL |
TBG 640 |
Please read this instruction booklet before using the appliance |
2 |
Important Safety Information
You MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department
on 08705 950950
Installation
●This hob must be installed by qualified personnel, according to the manufacturer’s instructions and to the relevant British Standards.
●Any gas installation must be carried out by a registered CORGI installer.
●Remove all packaging before using the hob.
●Ensure that the gas and electrical supply complies with the type stated on the rating plate, located near the gas supply pipe.
●Do not attempt to modify the hob in any way.
Child Safety
●This hob is designed to be operated by adults. Do not allow children to play near or with the hob.
●The hob gets hot when it is in use. Children should be kept away until it has cooled.
●Children can also injure themselves by pulling pans or pots off the hob.
During Use
●This hob is intended for domestic cooking only. It is not designed for commercial or industrial purposes.
●When in use a gas cooking hob will produce heat and moisture in the room in which it has been installed. Ensure there is a continuous air supply, keeping air vents in good condition or installing a cooker hood with a venting hose.
●When using the hob for a long period time, the ventilation should be improved, by opening a window or increasing the extractor speed.
●Do not use this hob if it is in contact with water. Do not operate the hob with wet hands.
●Ensure the control knobs are in the ‘OFF’ position when not in use.
●When using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the cooking appliance.
●Unstable or misshapen pans should not be used on the hob as unstable pans can cause an accident by tipping or spillage.
●Never leave the hob unattended when cooking with oil and fats.
●Never use plastic or aluminium foil dishes on the hob.
●Perishable food, plastic items and areosols may be affected by heat and should not be stored above or below the hob unit.
Service
●This hob should only be repaired or serviced by an authorised Service Engineer and only genuine approved spare parts should be used.
Environmental Information
●After installation, please dispose of the packaging with due regard to safety and the environment.
●When disposing of an old appliance, make it unusable, by cutting off the cable.
Keep this instruction book for future reference and ensure it is passed on to any new owner.
3
Contents
For the User |
|
|
For the Installer |
|
|
Description |
|
|
Technical Data |
Page 12 |
|
of the Hob |
Page |
5 |
Important Safety |
|
|
Operation |
Page |
6 |
Requirements |
Page 13 |
|
Maintenance |
|
|
Installation |
Page 14 |
|
and Cleaning |
Page |
7 |
Gas Connection |
Page 14 |
|
Something Not |
Page |
8 |
Building In |
Page 15 |
|
Working? |
Electrical Connection |
Page 16 |
|||
Service and |
|
|
|||
|
|
Wiring Diagram |
Page 17 |
||
Spare Parts |
Page |
9 |
|||
Fault Finding |
Page 18 |
||||
Guarantee Conditions |
Page |
9 |
|||
Commissioning |
Page 20 |
||||
|
|
|
|||
|
|
|
Conversion from |
|
|
|
|
|
natural gas to LPG |
Page 21 |
Guide to Use the instructions
The following symbols will be found in the text to guide you throughout the Instructions:
Safety Instructions
Step by step instructions for an operation
i |
Hints and Tips |
This appliance is manufactured according to the following EEC directives:
73/23 EEC - 90/683 EEC - 93/68 EEC - 89/336 EEC - 90/396 EEC,
current edition.
4
Description of the Hob
|
|
3 |
1 |
2 |
3 |
|
|
5
4 |
6 |
|
7 |
|
8 |
|
9 |
1.Hob Top
2.Rapid Burner
3.Semi-rapid Burners
4.Auxiliary Burner
5.Control knob for back right burner (semi-rapid)
6.Control knob for back left burner (semi-rapid)
7.Control knob for front left burner (rapid)
8.Control knob for front right burner (auxiliary)
9.Electric Ignition Push Button
INSTALLATION
Any gas installation must be carried out by
a registered CORGI installer, and in accordance with existing rules and regulations.
The relevant instructions are to be found in the second section of this manual.
Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the event of a breakdown.
WHEN THE HOB IS FIRST INSTALLED
Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory.
5
Operation
HOB BURNERS
To light a burner, push down the relevant control knob and turn anticlockwise to maximum position. At the same time push the electric ignition button which is marked with a little spark. Then adjust the flame as required.
If the burner does not ignite, turn the control knob to zero, and try again.
When switching on the mains, after
i installation or a power cut, it is quite normal for the spark generator to be activated automatically.
To ensure maximum burner efficiency, you should only use pots and pans with a flat bottom fitting the size of the burner used (see table).
Burner |
minimum |
maximum |
|
diameter |
diameter |
|
|
|
Large (rapid) |
180 mm. |
260 mm. |
Medium (semi-rapid) |
120 mm. |
220 mm. |
Small (Auxiliary) |
80 mm. |
160 mm. |
|
|
|
If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the vessel, causing the handle to overheat.
As soon as a liquid starts boiling, turn down i the flame so that it will barely keep the
liquid simmering.
Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite.
If the control knobs become difficult to turn, please contact your local Tricity Bendix Service Centre.
6
Maintenance and Cleaning
Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply.
The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool.
The HobTop
Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which a little washing up liquid has been added. Avoid the use of the following:
- household detergent and bleaches;
- impregnated pads unsuitable for non-stick saucepans;
-steel wool pads;
-bath/sink stain removers.
Should the hob top become heavily soiled, it is recommended that a cleaning product such as Hob Brite or Bar Keepers Friend is used.
Pan Supports
The pan supports are dishwasher proof. If washing them by hand, take care when drying them as the enamelling process occasionally leaves rough edges. If necessary, remove stubborn stains using a paste cleaner.
The Burners
The burner caps and crowns can be removed for cleaning.
Wash the burner caps and crowns using hot soapy water, and remove marks with a mild paste cleaner. A well moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove.
After cleaning, be sure to wipe dry with a soft cloth.
7
Loading...