Zebra ZQ500 Installation Manual

ZQ500 Series

Mobile Battery Eliminator Kit

Installation Guide

© 2014, ZIH Corp.

P1071365-001
August 2014

P1071365-001 pg. 3

Contents

Special Notices..............................................................3

General Warnings and Cautions.....................................3

Vehicle Installation Safety.............................................3

Electrical Information....................................................4

Regulatory Information..................................................4

Regulatory Markings.....................................................4

Radio Frequency Interference Regulations....................4

Notification of Canadian Requirements.........................4

Agency Approvals and Regulatory Information

.............4

Introduction..................................................................5

Installing the DC Transfer Pack.....................................6

RAM Mount Installation for a ZQ500 Series Printer..................8

Desktop Installation..................................................................9

Technical Support.......................................................10

U.S. Only.................................................................................10

All Others................................................................................10

Special Notices

The following notices emphasize cer tain information in the guide. Each ser ves a special purpose

and is displayed in the format shown:

Note: Note is used to emphasize any significant information.

Caution: Indicates i nformation that, if not followed, c an result in damage to softwar e, hardware, or

data.

Warning: This warning sym bol indicates an imminent ly hazardous situation wh ich, if not avoided will

result in death or s erious injury. Before you work on any e quipment, be aware of the haza rds involved
with electrical ci rcuitry and be familiar wit h standard practices for preventing ac cidents

General Warnings and Cautions

Cauti on: Read the followin g installation inst ructions before you conne ct the system to its power sou rce.

Note: Zebra Technologies Corporation i s not liable for person al injury or damage t o any equipment

caused by the imprope r installation of this equipmen t to any power source.

Vehicle Installation Safety

Caution: Only trai ned and qualified pers onnel should be allowed to i nstall, replace, or s ervice this

equipment.

Caution: DO NOT USE THE PRINTER WH ILE DRIVING, as this may resu lt in property damage o r personal

injury. Zebra Technologies Cor poration. does not promote t he use of these products e xcept when parked
or stationar y, and is not respons ible for any loss resulting from the u se or misuse of our products.

Caution: Do not inst all the batter y eliminator kit whe re it will be exposed to pre cipitation, ex treme

temperatures or excessive condensation.

Caution: Do not insta ll the battery elim inator kit in a location tha t will affect vehicle sa fety or drivabilit y.

Caution: Never instal l or remove the equipment from the vehicl e’s electrical system wh ile the vehicle

is running. This may r esult in permanent damage to the equi pment.

Warning: It is very imp ortant to ensure that you ma ke the correct cable to power source con nections,

because electrical e nergy from a vehicle’s power system can harm equi pment and people.

Mobile Battery Eliminator Kits