3
2
Gradie nte r
Never put your hand(s) into the Wash/SpinTub while the
washer is operating.
·The laundry in swirling water may twist around your
finger(s) even at a slow rotation.This is very dangerous.
·Wait until the machine has completely stopped before
opening the lid.
·If the Wash/Spin Tub dose not stop within
15 seconds after the Washer Lid is opened,
turn the washer off immediately and call
a service person.
Be sure to connect Power Plug and Power
Cord properly.
·Be sure to plug the Power Cord into a
proper socket-outlet for the washer.
·An improperly attached plug may
catch fire.
·Never disconnect by pulling the cord. Hold
the plug as you pull it out.
·Never use a damaged Power Cord.
·Never connect and/or disconnect the Power
Plug with wet hands, it may cause an electric
shock.
·If the washer is not used for a long time please pull
out the plug.
·
benzine, kerosene, thinner or
gasoline. It may cause a risk
of fire or explosion.
·Never wash water-proofed. Sheets and
impermeable such as raincoat etc.
Never wash items stained with
Do not install the washer
in the bathroom or very humid place. or
outdoors as exposed to sun or rain.
·It may cause a
malfunction or an
electric shock.
·Direct sunlight
which may deform
the plastic or lose color.
Do not allow children to play on
or in the washer.
·If a child accidentally falls
into the Wash/Spin Tub,
serious injury could occur.
Be sure not to splash or pour
water on the Control Panel.
·It may cause a malfunction
or an electric shock.
Do not allow your washer to be repaired
by an unqualified service person.
·It may cause a risk of accidental
fire.
·If the washer operates abnor mally, it may cause injury.
Keep your washer away from fire. Be sure
not to bring any type of flame near the
washer or put lit cigarettes or volatile
materials on the top of the
washer.
·It may deform the washer
or catch fire, because this
washer has a large number
of plastic parts.
Clean washing machine
dirt on the surface of the washer.
●Do not spray water directly
to the washer body. Doing so
may cause a short circuit
and /or electric chock.
●Detergent, propellant and
other chemicals are not
allowed to use to avoid the
damages on the surface.
Use soft clothing to wipe off the water or
Clean the water inlet Valve
After long time use, The water inlet
mesh bag may be blocked with crud,
please load off the water inlet hose,
take out the water inlet mesh bag
from the water inlet valve, clean
the mesh bag, then assemble
the mesh bag in the valve and
load the water inlet hose.
(Suggest clean it every 6 months)
Clean lint filter
(Suggest clean it every time)
1.Take out the lint filter.
2.Pull out the scraps and wash
the lint filter in the water.
3.Install the Filter ( aim the
frame claw to the groove
below).
( Lint Filter is easily destroyed parts).
NAME OF PARTS
ACCES SOR IES
Was her Lid
Lint Fil ter
Adjust abl e Leg
Contro l Pan el
Frame
Pulsat or
Power Co rd
Wat er Supply H ose
Deterg ent Tr ay
(One)
Soften er Di spen ser
Was h/Spin Tub
Liquid d ete rgen t/B leach
WARNINGS
CARE AND MAINTENANCE