For your safety and correct operation of the appli-
ance, read this manual carefully before installation
and use. Always keep these instructions with the appliance even if you move or sell it. Users must fully know
the operation and safety features of the appliance.
Correct use
• The appliance is designed exclusively for domestic
use.
• Only use the appliance to clean household utensils that
are applicable for dishwashers.
• Do not put solvents in the appliance. Risk of explosion.
• Put the knives and all items with sharp points in the
cutlery basket with their points down. If not, put in a
horizontal position in the upper basket.
• Use only branded products for dishwashers (detergent,
salt, rinse aid).
• If you open the door while the appliance is in operation,
hot steam can escape. Risk of skin burns.
• Do not remove dishes from the dishwasher before the
end of the washing programme.
• When the washing programme is completed, discon-
nect the mains plug from the mains socket and close
the water tap.
• Only an authorised service engineer can repair this
appliance. Use only original spare parts.
• Do not do repairs yourself to prevent injury and dam-
age to the appliance. Always contact your local Service
Force Centre.
General safety
• Persons (including children) with reduced physical
sensory, mental capabilities or lack of experience and
knowledge must not use the appliance. They must have
supervision or instruction for the operation of the appliance by a person responsible for their safety.
• Obey the safety instructions from the manufacturer of
the dishwasher detergent to prevent burns to eyes,
mouth and throat.
• Do not drink the water from the dishwasher. Detergent
residues can stay in your appliance.
• Always close the door when you do not use the appliance to prevent injury and not to stumble over the open
door.
• Do not sit or stand on the open door.
Child safety
• Only adults can use this appliance. Children must get
supervision to make sure that they do not play with the
appliance.
• Keep all the packaging away from children. There is a
risk of suffocation.
• Keep all detergents in a safe area. Do not let children
touch the detergents.
• Keep children away from the appliance when the door
is open.
Installation
• Make sure that the appliance is not damaged because
of transport. Do not connect a damaged appliance. If
necessary, contact the supplier.
• Remove all packaging before first use.
• A qualified and competent person must do the electrical installation.
• A qualified and competent person must do the plumbing installation.
• Do not change the specifications or modify this product. Risk of injury and damage to the appliance.
• Do not use the appliance:
– if the mains cable or water hoses are damaged,
– if the control panel, worktop or plinth area are dam-
aged, that you can get access to the inner side of
the appliance.
Control panel
Contact your local Service Force Centre.
• Do not drill into the sides of the appliance to prevent
damage to hydraulic and electrical components.
Warning! Carefully obey the instructions for
electrical and water connections.
The indicator light comes on when the washing programme is completed. Auxiliary functions:
• Level of the water softener.
• Activation/deactivation of the audible signals.
• An alarm if the appliance has a malfunction.
Programme selection/cancel button
Use the programme selection/cancel button for these operations:
• To set the washing programme. Refer to the chapter
'Setting and starting a washing programme'.
• To set the water softener. Refer to the chapter 'Setting
the water softener'.
• To deactivate/activate the audible signals. Refer to the
section 'Audible signals'.
• To cancel a washing programme in progress. Refer to
the chapter 'Setting and starting a washing programme'.
3
Setting mode
The appliance is in setting mode when all the programme
indicator lights are off and the end indicator light flashes.
The appliance must be in setting mode for these operations:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible signals.
If a programme indicator light is on, cancel the programme to go back to the setting mode. Refer to the
chapter "Setting and starting a washing programme".
Programme indicator lights A and B
Apart the selection of the corresponding washing programme, these lights have an auxiliary functions:
• The adjustment of the water softener level.
• Deactivation/activation of the audible signals.
Audible signals
You can hear an audible signal:
• At the end of the washing programme.
• When the appliance has a malfunction.
The activation of the audible signals is set at the factory.
Do these steps to deactivate the audible signals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold the programme selection/cancel but-
ton until programme indicator light A flashes and
programme indicator light B comes on.
4. Press the programme selection/cancel button again.
– Programme indicator light A comes on.
– Programme indicator light B starts to flash.
5. Wait until programme indicator light A goes off.
– Programme indicator light B continues to flash.
– The end indicator light comes on.
The audible signals are activated.
6. Press the programme selection/cancel button again.
– The end indicator light goes off.
The audible signals are deactivated.
7. Switch off the appliance to save the operation.
Do these steps to activate the audible signals:
1. Do the above procedure until the end indicator light
comes on.
Washing programmes
Washing programmes
ProgrammeDegree of soilType of loadProgramme description
Prewash
Normal soil
1)
2)
Normal or light
soil
Normal soil
Crockery, cutlery,
pots and pans
Crockery and cut-
lery
Crockery and cut-
lery
Main wash up to 65°C
2 intermediate rinses
Final rinse
Drying
Main wash up to 65°C
Final rinse
Prewash
Main wash up to 50°C
1 intermediate rinse
Final rinse
Drying
4
ProgrammeDegree of soilType of loadProgramme description
Partial load (to be
Any
1) This is the perfect daily programme to clean a not fully load. Ideal for a family of 4 persons who only want to load breakfast and
dinner crockery and cutlery.
2) Test programme for test institutes. Please refer to separate leaflet supplied, for test data.
completed later in
the day)
1 cold rinse (to avoid food scraps from sticking).
This programme does not require the use of
detergent).
Consumption values
ProgrammeProgramme duration
(in minutes)
105-1151,5-1,723-25
300,99
130-1401,0-1,214-16
120,15
The pressure and temperature of the water, the variations of power supply and the quantity of dishes
can change these values.
Energy consumption
(in kWh)
Water consumption
(in litres)
Use of the appliance
Refer to the following instructions for each step of procedure:
1. Make a check if the water softener level is correct for
the water hardness in your area. If necessary set the
water softener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dishwasher.
Setting the water softener
The water softener removes minerals and salts from the
water supply. Minerals and salts can have bad effect on
the operation of the appliance.
Water hardness is measured in equivalent scales:
• German degrees (dH°).
• French degrees (°TH).
5. Set the correct washing programme for the type of
load and soil.
6. Fill the detergent dispenser with the correct quantity
of detergent.
7. Start the washing programme.
If you use detergent tablets, refer to the chapter 'Use
of detergent'.
• mmol/l (millimol per litre - international unit for the
hardness of water).
•Clarke.
Adjust the water softener to the water hardness in your
area. If necessary, contact your local water authority.
5
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.