Yamaha AG03 Technical specification

MIXING CONSOLE

Technical Specifications

General Specifications

0 dBu = 0.775 Vrms, O utput impedance of signal generator (Rs) = 150 Ω

All level controls are nominal if not specified.

Frequency Response

Total Harmonic Distortion *1
(THD+N)

Hum&Noise *2
(20 Hz to 20 kHz)

Crosst alk (1 kHz) *3 -80 dB

Input Channels

Output Channels

Bus Stereo: 1

Input Channel Function
(CH1)

Level Meter USB Output Level 2x2 point LED meter [PE AK, SIG]

USB Audio 2 IN / 2 OUT USB Audio Class 2.0 compliant, Sampling Frequency: Max 192 kHz, Bit Depth: 24-bit

Phantom Power Voltage +48 V

FOOT SW EFFECT Mute on/off

Power Requirements DC 5 V, 500 mA

Power Consumption Max. 2.5 W

Dimensions (WxHxD) 129 mm x 63 mm x 202 mm (5.1” x 2.5” x 8.0”)

Net Weight 0.8 kg (1.8 lbs)

Included Accessory

Optional Accessory Foot Switch: FC5, Mic Stand Adaptor: BMS-10A

Operating Temperature 0 to +40°C

*1 THD+N is measured with 22 kHz LPF.

*2 Noise is measured with A-weighting filter.

*3 Crosstalk is measured with 1 kHz band pass filter.

Input (M IC) to MONITOR OUT
via USB IN/OUT

Input to MONITOR OUT

Equivalent Input Noise -128 dBu (Mono Input Channel, Rs: 150 Ω, GAIN knob: Max)

Residual Output Noise -103 dBu (MONITOR OUT, MONITOR knob: Min)

PAD 26 dB

DSP COMP/EQ, EFFECT (SPX Reverb)

PEAK LED LED turns on when the signal reaches 3 dB below clipping level.

+0.5 dB/-1.5 dB (20 Hz to 48 kHz @ Fs = 192 kHz),
refer to the nominal output level @ 1 kHz, GAIN knob: Min, TO PC: DRY CH1-2G

0.05% @ 0 dBu (20 Hz to 20 kHz), GAIN knob: Min

0.01% @ +4 dBu (1 kHz), GAIN knob: Min

Mono (MIC/LINE): 1 including HE ADSE T MIC (Plug-in Power)
(CH1 MIC and HEADSE T MIC cannot be used simultaneously.),
Stereo (LINE) / Mono (GUITAR) :1, USB IN:1, AUX IN:1

MONITOR OUT: 2, PHONES: 2 including HEADSET PHONES
(PHONES and HEADSET PHONES cannot be used simultaneously.)

USB Cable (1.5 m), CUBASE AI DOWNLOAD INFORMATION, Owner’s Manual,
Technical Specifications (this leaflet)

ZN43270

Analog Input Characteristics

0 dBu = 0.775 Vrms

Input Jack

MIC/LINE 1

HEADSET MIC

GUITAR 2G -

LINE 2/3 -

AUX - - 10 kΩ 600 Ω Lines

*1 Sensitivity is the lowest level that will produce an output of +0 dBu (0.775 V) or the nominal output level when the unit is set to ma ximum gain.
(All level controls are at their ma ximum position.)

*2 1&Sleeve = GND, 2&Tip = HOT, 3&Ring = COL D

*3 Tip = Signal, Sleeve = GND

*4 For CH1, HEADS ET MIC

PAD

26 dB

OFF

ON

GAIN
Trim/SW
Position

10

0

10

0

HIGH

LOW

HIGH

LOW

Actual

Load

Impedance

3 kΩ

1.5 kΩ*4

1 MΩ -

10 kΩ 600 Ω Lines

For Use

with

Nominal

50–600 Ω

Mics/Lines

Sensitivity *1 Nominal

-72 dBu

(0.195 mV)

-26 dBu

(38.84 mV)

-46 dBu

(3.884 mV)

0 dBu

(775.0 mV)

-32 dBu

(19.5 mV)

-12 dBu

(194.7 mV)

-20 dBu

(77.5 mV)

-10 dBu

(245.1 mV)

-14 dBu

(154.6 mV)

Input Level

-60 dBu

(0.775 mV)

-14 dBu

(154.6 mV)

-34 dBu

(15.46 mV)

+12 dBu

(3.085 V)

-20 dBu

(77.5 mV)

0 dBu

(775.0 mV)

-8 dBu

(308.5 mV)

+2 dBu

(975.7 mV)

-8 dBu

(308.5 mV)

Max. Before

Clip

-50 dBu

(2.451 mV)

-4 dBu

(489.0 mV)

-24 dBu

(48.90 mV)

+22 dBu
(9.757 V)

-10 dBu

(245.1 mV)

+10 dBu
(2.451 V)

+2 dBu

(973.7 mV)

+12 dBu

(3.085 V)

+2 dBu

(975.7 mV)

Connector

Combo jack *2

(Balanced)

3.5 mm Phone jack
for HEADSET MIC

(Plug-in-Power/

Unbalanced)

Phone jack *3
(Unbalanced)

Phone jack *3
(Unbalanced)

Stereo mini jack

Analog Output Characteristics

0 dBu = 0.775 Vrms

Output Terminal

MONITOR OUT [L, R] 150 Ω 10 kΩ Lines 0 dBu (0.775 V) +10 dBu (2.451 V)

PHONES 120 Ω 40 Ω Phones 1.5 mW + 1.5 mW 6 mW + 6 mW

*5 Tip = HOT, Ring = COL D, Sleeve = GND

Actual Source

Impedance

For Use with Nominal

Nominal Max. Before Clip

Output Level

Connecter

Phone jack *5

(Impedance Balanced)

RCA pin

(Unbalanced)

Stereo phone jack

Stereo mini jack

Digital Input / Output Characteristics

Terminal Format Data Length Sampling Frequency Connector

USB USB Audio Class 2.0/ Yamaha Steinberg USB Driver 24-bit 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz, 192 kHz USB Standard-B

The contents of this manual apply to the latest specifications as of the printing date. Since Yamaha makes co ntinuous improvements to the product, this manual may not apply to the
specifications of your par ticular product. To obtain the latest manual, access the Yamaha website then download the manual file. Since specifications, equipment or separately sold
accessories may not be the same in every locale, please check with your Yamaha dealer.

Block and Level Diagrams Dimensions

Unit: mm

INPUT 1

[MIC/LINE]

PAD=off: -60 ~ -14dBu
PAD=on: -34 ~ +12dBu

HEADSET

(Mic)

[MIC (Plug in power)]

INPUT 2/3

[GUITAR]
-20dBu/+0dBu

[LINE]
-8dBu/+2dBu

GUITAR

(L/MONO)

(R)

OFF⇔ON

L

+48V

+48V

L

R

R

MONITOR MUTE

MONITOR

129

PAD

26dB

OFF⇔ON

GAIN

PEAK

HA

LEVEL

COMP/EQ

HPF/COMP/EQ

PUSH

EFFECT

PUSH

[MONITOR MUTE]
CH1-2G MUTE

MONITOR
OUT (L/R)

[MONITOR OUT L/R]

Nominal Output: 0dBu (@10kΩ)
Maximum Output: +10dBu (@10kΩ)

63

2.3

56

REVERB

TO PC

AMP

SIM

GAIN

GUITAR

Hi-Z

HIGH⇔LOW

HIGH⇔LOW

HIGH⇔LOW

LEVEL

[TO PC]

TOP: DRY CH1-2G
MID: INPUT MIX
BOT: LOOPBACK

[METER]

PEAK
SIG

PHONES

METER

L R

PHONES

(L/R)

HEADSET

(Phones)

[PHONES L/R]

Nominal Output: 1.5mW (@40Ω)
Maximum Output: 6.0mW (@40Ω)

201

202

28

28

FOOT SW

[FOOT SW]
Fx On-Off

AUX INPUT

[LINE]
-8dBu

L / R

+30dBu

+20dBu

+10dBu

0dBu

-10dBu

-20dBu

-30dBu

-40dBu

-50dBu

-60dBu

Maximum Input Level: [+22dBu]

MONO INPUT LINE: [+12dBu] @GAIN=min

Maximum Input Level: [-4dBu]

MONO INPUT MIC: [-14dBu] @GAIN=min

MONO INPUT LINE: [-34dBu] @GAIN=max MONO INPUT LINE: [-34dBu] @GAIN=max

MONO INPUT MIC: [-60dBu] @GAIN=max

USB

[USB AUDIO]

LEVEL

from PC

L

R

USB AUDIO

IN OUT

L

R

POWER

POWER

5V DC

DETECT

USB 2.0

+30dBu

+20dBu

+10dBu

0dBu

-10dBu

-20dBu

-30dBu

-40dBu

-50dBu

+10dB

-2dB

Maximum Input Level: [+12dBu]

STEREO INPUT LINE:
[+2dBu] @GAIN=LOW

-2dB

Maximum Input
Level: [+2dBu]

AUX INPUT: [-8dBu]

Clip Level: [+10dBu]

-26dB

Maximum Input Level: [+2dBu]

+14dB

STEREO INPUT LINE:

STEREO INPUT LINE:

[-8dBu]@GAIN=HIGH

[-8dBu] @GAIN=HIGH

+60dB

-26dB

+8dB

Maximum Input Level:
[+10dBu] @GAIN=LOW

Hi-Z: [+0dBu]
@GAIN=LOW

Maximum Input Level:
[-10dBu] @GAIN=HIGH

Hi-Z: [-20dBu] @GAIN=HIGH

Clip Level: [+10dBu]

-6dB +6dB

+20dB

Level Control

USB Audio
from PC: [+7dBu]

Clip Level: [+10dBu]

-10dB

USB Audio Level Control

-2dB

+3dB

-16dB

PHONES Level Control

+20dB

Maximum Output Level: [6mW] @40Ω

-12dB

PHONES: [1.5mW] @40Ω

-6dB +6dB

MONITOR Level Control

Maximum Output Level: [+10dBu]

MONITOR OUTPUT: [0dBu]

Jack and Plug List

Jacks and Plugs Polarities

Balanced/

Unbalanced

Pin 1: Ground

MIC/LINE

Pin 2: Hot (+)

Balanced

Pin 3: Cold (-)

MIC/LINE*
MONITOR OUT*

Tip: Hot (+)
Ring: Cold (-)
Sleeve: Ground

Balanced

Tip: Signal

HEADSET MIC

Ring: -

Unbalanced

Sleeve: Ground

PHONES
AUX

LINE 2/3
GUITAR

Tip: L
Ring: R
Sleeve: Ground

Tip: Signal
Sleeve: Ground

-

Unbalanced

* These jacks also can be connected with TS phone plugs. If you use TS phone plugs, the connection will
be unbalanced.

Congurations

XLR Jack

INPUT

TRS Phone Plug

Ring

TipSleeve

TS Phone Plug

TipSleeve

-60dBu

Manual Development D epartment

©2015 Yamaha Corporation

Published 01/2015 MWZC*.*-01A0

Printed in Ind onesia