Xerox 5760/5765 (MajestiK Color Series) Digital Color Copier / Printer
COPY VOLUME RANGE
COPY VOLUME RANGE
- This product was designed to provide “benchmark”
image quality. To maximize Customer Satisfaction this
product should be operated below 10,000 copies per
month 80 - 90% of which are color copies. Usage
above this range may result in a higher service
frequency (see chart below).
PERFORMANCE AT MATURITY
PERFORMANCE AT MATURITY
A C
v a
g l
l
S s
e /
r M
v o
i n
c t
e h
3
2
1
0
0246810
Average Monthly Copy Volume (000)
SPEED
SPEED
- 6 copies per minute (cpm) (4 color) for 8.5x11 Long Edge
Feed (LEF)
- 7 cpm (3 color) for 8.5 x 11 LEF
- 36 cpm (B/W) for 8.5x11LEF
- 18 cpm (B/W) 8.5 x 11, 8.5x14, 11x17 Short Edge Feed
(SEF)
- 4.5 cpm (3 or 4 color) for 8.5x11, 8.5x14, 11x17 SEF
- 4.4 cpm (B/W) Transparencies/ Heavy Paper Mode*
- 1.8 cpm (3 or 4 color) Transparencies / Heavy Paper
Mode*
*Note: Up to 8.5 x 11” paper only. (Long or short edge feed)
INPUT
INPUT
- Document Glass Mode - up to 11x17
- Automatic Document Feeder (ADF) is not a field upgrade
- 50 sheet maximum
- 16 - 28 # paper weight
- 5.5 x 8.5 to 11x17 originals
- Copies between service calls on a digital color copier is
dependent on customer expectation levels of quality,
volume, applications and thruput materials. Trained
operators can minimize service calls.
XEROX CUSTOMER SUPPORT CENTER - DOCUMENT #100225
- Film Projector Mode
- 35mm negative or positive slide in film holder
- 35mm negative or positive on platen
- 4” x 5” slide on platen
- Up to 60mm x 60mm positive films or 60mm x 90mm
with system administration adjustment.
Revised November 1995
Xerox 5760/5765 (MajestiK Color Series) Digital Color Copier / Printer
THRUPUT
THRUPUT
- Attempts to feed greater than 90# index or
Tray Size* Capacity** Specified
Weights
1 8x10 to
11x17
2 8x10 to
11x17
3 8x10 to
11x17
Bypass 8x10 to
11x17
250 16-24#
250 16-24#
250 16-24#
50 16-32 #,
90# Index***
* Cassette size is adjustable by the Xerox technical
representative at install and is not customer adjustable.
** 20# paper
*** MajestiK cannot feed or fuse heavy weight papers
(32 lb. bond to 90 lb. index) that are larger than 8.5 x
11.
- Recommended paper to maximize copy quality is Xerox
Image Series LX 24# (smooth bright white paper). This
paper is specifically designed to maximize image quality
and machine performance over a wide range of
environmental conditions.
- Recommended 90# index or equivalent (8.5 x 11 only)
can be run satisfactorily. However, it is not to be
expected to match the performance of Xerox Image
Series LX 24#
XEROX CUSTOMER SUPPORT CENTER - DOCUMENT #100225
recommended equivalent (7 PT) may cause machine
damage.
- Xerox coated stock 32 # bond (3R5093) and 60# bond
(3R5095), which were designed for the xerographic
process, can be run satisfactorily. Coated papers are
NOT to be expected to match the performance of
regular bond paper.
Coated stock MUST be run through the Bypass Tray in
the Heavy Weight Paper Mode.
- Recommended AB-X image transfer material (3R4982
for 8.5 x 11 and 3R4983 for 11 x 17) can be run
satisfactorily.
- All papers heavier than 28 lb. bond (including coated)
MUST be run from the Bypass Tray in Heavy Weight
Paper Mode.
- Sorter option:
- 20 bin sorted or stacked sets of the above thruput
sizes and weights at 50 sheets/bin.
- Sorter top tray will handle all above thruput sizes
and weights up to 99 sheets.
- Output tray will handle all above thruput sizes up to 250
sheets.
Note: For more detailed information on thruput materials, please
refer to the Xerox Materials Usage Guide for MajestiK
(701P90152)
Revised November 1995
Xerox 5760/5765 (MajestiK Color Series) Digital Color Copier / Printer
COPY QUALITY
COPY QUALITY
- Color quality is subjective and could be impacted by lighting, environment,
and / or thruput materials (paper and other).
- Like any color reproduction process there will be some variances in copy
quality over time.
- Copy Quality is strongly influenced by paper.
- Key Applications should be copied on the 5760/5765 and reviewed with
the customer.
- Transparencies are non absorbent and may exhibit non uniform density
streaks in large solid areas from the fuser agent film.
CUSTOMER SUPPORT
CUSTOMER SUPPORT
- The Xerox Customer Support Center Helpline, 1-800-821-2797, is
provided for all service calls and available for Customer APPLICATION
questions.
- The Supplies Marketing Center is available at 1-800-822-2200 for order of
paper and thruput materials.
- Fee-based training courses or hourly sessions are available through
Xerox Document Management Training Representatives.
DUPLEX COPYING
DUPLEX COPYING
-Duplex copies should only be run from bypass tray for the second side.
-The black and white or lower density image side should be run first.
-Feeding reliability may be improved by rotating the paper orientation 90
degrees before copying the second side.
- The MajestiK will not be replaced free of charge for unsatisfactory
duplex operation because a replacement unit will have similar
performance.
CONFIGURATION LIMITATIONS
CONFIGURATION LIMITATIONS
- The ADF is not a field upgradeable unit. It can only be purchased at
initial order.
- A Sorter OR Film Projector can be added to any of the configurations,
but both cannot be installed on the same unit.
- An Edit kit is available as an accessory to upgrade a non-edit machine
with an ‘off-line’ edit pad. This can be installed on a machine either with
or without an ADF.
INSERTION OF COPIES INTO HIGH
INSERTION OF COPIES INTO HIGH
VOLUME COPIERS
VOLUME COPIERS
- Insertion of 5760/5765 copies in 5090/5390/ DocuTech 135 requires
Customer Business Unit validation.
- Do not use 5760/5765 inserts in 5100 due to incompatibility with the
fuser.
- MajestiK 5760/65 is recommended for duplex applications.
- As with any full color copier, duplex performance is not expected to match
the performance for single sided copying. Paper jam rates will be higher
than the rate you will experience for the same thruput material in single
sided mode. Extensive duplex operation may have a secondary effect on
performance and copy quality of single sided jobs
- MajestiK should provide reasonable duplex performance when operated
within the specified paper weight range (8.5 x 11, 16-28 lb. only) and
utilizing the following recommended procedure:
.
XEROX CUSTOMER SUPPORT CENTER - DOCUMENT #100225
TRANSPARENCIES
TRANSPARENCIES
- Transparencies for this product are restricted to 3R3108, 3R5765 and
3R5775 and can only
correct manner. The 3R5765 premium transparency is specifically
designed to provide optimum copy quality including more vivid colors.
- Use of other transparencies may cause machine damage. Continued
use of transparencies other than those recommended may result in
customer being placed on time and materials. Please see customer
documentation for additional information.
be supported out of the bypass tray if fed in the
Revised November 1995
Xerox 5760/5765(MajestiK Color Series) Digital Color Copier / Printer
SUPPLIES
SUPPLIES
Reorder # Units / Carton Net Wt. /CTN
Dry Ink
- Black 6R718 2 Cartridges 600 g.
- Cyan 6R719 2 Cartridges 600 g.
- Yellow 6R720 2 Cartridges 600 g.
- Magenta 6R721 2 Cartridges 600 g.
Developer
- Black 5R319 1 Pouch 650 g.
- Cyan 5R320 1 Pouch 650 g.
- Yellow 5R321 1 Pouch 650 g.
- Magenta 5R322 1 Pouch 650 g.
Fuser Agent 8R3993 1 Bottle Liter
Waste Toner Bottle 8R4032 4 Bottles -
Note: Dry Ink and Developer consumption will vary depending on actual area coverage.
XEROX CUSTOMER SUPPORT CENTER - DOCUMENT #100225
Revised November 1995
Xerox 5760/5765 (MajestiK Color Series) Digital Color Copier / Printer
ENVIRONMENTAL AND ELECTRICAL REQUIREMENTS
ENVIRONMENTAL AND ELECTRICAL REQUIREMENTS
Min Max
Temperature 50 ºF (10 ºC) 90 ºF (32 ºC)
Humidity 10% 85%
Power Consumption: POWER (VA)
Warm-up 1400
Standby peak 360
Standby average 263
Run mode (4 Color)
Peak 960
Average 864
Specifications:
Ground Fault Interrupter
Single phase = 2 Wire plus ground
Service = 15 AMP or 20 AMP (Sole use not required, but recommended)
Line to neutral = 115 Volts (+6/-10%)
Frequency = 60 HZ (+/- 2%)
XEROX CUSTOMER SUPPORT CENTER - DOCUMENT #100225
Revised November 1995
Xerox 5760/5765 (MajestiK Color Series) Digital Color Copier / Printer
Moveabl
e
Yes
72”
Yes
72”
No
72”
Stationary
ONLY
88”
Yes
103”
Yes
103”
No
103”
Stationary
ONLY
119”
Space Requirements
Space Requirements
Configurations
Width (inches)
Standalone
w/Fiery
5760 w/ Catch Tray OR 5765 w/ Catch Tray OR
5760 w/ ADF w/ Catch Tray
on a floor
5760 w/ Catch Tray OR 5765 w/ Catch Tray OR
5760 w/ ADF w/ Catch Tray
on a mobility- plate.
5760 w/ Catch Tray OR 5765 w/ Catch Tray OR
5760 w/ ADF w/ Catch Tray
at a stationary install.
5760 w/ Sorter OR 5765 w/ Sorter OR
5760 w/ ADF w/ Sorter
at a stationary install.
5760 w/ ADF w/ Catch Tray & Edit Pad Option
on a floor.
5760 w/ ADF w/ Catch Tray & Edit Pad Option
on a mobility - plate
5760 w/ ADF w/ Catch Tray & Edit Pad Option
at a stationary install
5760 with ADF w/ Sorter & Edit Pad Option
at a stationary install.
Notes: -In order to conform to US National fire codes, there must be 44” minimum clearance in front of units
installed in aisles / hallways
-Minimum floor to ceiling height requirement for all installations is 78”.
-Any configuration which includes a sorter requires a stationary install.
XEROX CUSTOMER SUPPORT CENTER - DOCUMENT #100225
90” 71” *
90” 75” *
90” 91” *
106” 91” *
121” 71” *
121” 75” *
121” 91” *
137” 91” *
Depth
(Inches)
Standalone
or w/Fiery
Revised November 1995
Xerox 5760/5765 (MajestiK Color Series) Digital Color Copier / Printer
Primary Customer MajestiK 5760/5765 applications
Special Considerations or performance limitation identified by Xerox and agreed to by the customer.
I have reviewed and understand these product specifications.
Customer
Xerox Sales Representative
Xerox Customer Service Engineer
Xerox Color Network Marketing Executive
XEROX CUSTOMER SUPPORT CENTER - DOCUMENT #100225
Revised November 1995
Loading...