Xantrex Technology 976-0212-01-01 User Manual

Errata to the RV Series Remote

Errata

Control Owner’s Manual

This errata applies to the RV Series Remote Control Owner’s Manual (Document
Part Number 975-0210-01-01 Revision A).

The following correction applies throughout the manual:

• The Charge and Batt. Full LED indicators are orange (not yellow).

Inverter

Charge

Batt. Full

Error

Charge LED Indicator

The Charge LED indicator table on page 27 has the following corrections:

• The Charge LED indicator is solid during absorption and float charging (not
flashing).

• The Charge LED indicator is flashing during equalize charging (not fast
flashing).

Green
Orange
Orange
Red

RC/GS

976-0212-01-01 Rev A

RC/GS

Charge LED
Indicator Other LED Indicators or Devices Meaning

Solid Bulk charging

Solid

Solid Batt. Full LED indicator solid Float charging

Flashing Equalize charging

Off No charging

a.The Batt. Full LED indicator will be solid when the battery state-of­charge (SOC) is between 90 and 100% according to the inverter/
charger's estimate. See “Absorption Charging” on page 3 and in the
owner’s manual.

Batt. Full LED Indicator

The Batt. Full LED indicator table on page 28 has the following correction:

Absorption charging

a

• The Batt. Full indicator LED is solid when the battery is charged 90% or
higher (not flashing).

Batt. Full LED
Indicator Other LED Indicators or Devices Meaning

Solid Battery fully charged (100%)

Solid Charge LED indicator solid Battery charged 90% or higher

Off Battery below 90% charge

Inverter Mode Messages

The “Note” callout on page 34 of this section has the following correction:

• The LED indicator does not flash during the charge mode if the inverter is
turned on.

Note:

is turned on. The Inverter LED indicator turns off if the inverter is turned off.

The Inverter LED indicator does not flash during the charge mode if the inverter

2 976-0212-01-01

Charger Mode Messages

The following subsections of “Charger Mode Messages” have corrections.

Absorption Charging

“Absorption Charging” on page 35 has the following corrections:

• In Absorption mode, the Charge LED indicator is solid (not flashing).

• When the battery reaches 90% state-of-charge, the Batt. Full LED indicator
will be solid (will not flash).

The following text replaces the paragraph under “Absorption Charging” on
page 35.

When the charger is charging in Absorption mode, the screen displays Absorption
Chg, and the Charge LED indicator is solid. In addition, the Batt. Full LED

indicator will be solid when the battery state-of-charge (SOC) is between 90 and
100% according to the inverter/charger's estimate.

Float Charging

“Float Charging” on page 36 has the following correction:

• In Float mode, the Charge LED indicator is solid (not flashes quickly).

The following text replaces the paragraph under “Float Charging” on page

36.

When the charger is in Float mode, the screen displays Float Charging, and the
Charge LED indicator is solid. At this point the batteries are fully charged (100%)
and the Batt. Full LED indicator is solid.

Errata

Equalizing Charging

The paragraph under “Equalizing Charging” on page 36 has the following
correction:

• In equalize mode, the Charge LED indicator flashes approximately two times
per second (not 8 times).

976-0212-01-01 3

RC/GS

The following text replaces the first paragraph under “Equalizing Charging”
on page 36.

To activate Equalize mode, press and hold the Settings button (right arrow) until
the screen clears and Equalizing appears (approximately 6 seconds). The Charge
LED indicator flashes approximately two times per second in equalize mode. The
equalize charge will continue for 3 hours, and then automatically change back to
float charging.

Trademarks Xantrex and XPower are trademarks of Schneider Electric Services International sprl, registered in the U.S. and other

countries. Other trademarks, registered trademarks, and product names are the property of their respective owners and are used herein
for identification purposes only.

Notice of Copyright Errata to the RV Series Remote Control Owner’s Manual © February 2009 Xantrex Technology Inc. No part

of this document may be reproduced in any form or disclosed to third parties without the express written consent of:
Xantrex Technology Inc.
161-G South Vasco Road
Livermore, California USA 94551

Xantrex Technology Inc. reserves the right to revise this document and to periodically make changes to the content hereof without

obligation or organization of such revisions or changes unless required to do so by prior arrangement.

All warranty, disclaimer and safety information is contained within the primary documentation received with your unit. Please ensure

you are familiar with that information before proceeding.

Date and Revision February 2009 Rev A Part Number 976-0212-01-01

Contact Information

Telephone: [phone] (toll free North America) 1 408 987 6030 (direct) +34 93.433.8350 (Europe)

Fax: [phone] (toll free North America) 1 604 422 2756 (direct) +34 93.433.8351 (Europe)

Email: [e-mail] Web: www.xantrex.com

4 976-0212-01-01