Whirlpool WFG550S0HB, WFG525S0HV User Manual

30" (76.2 cm) Freestanding Gas Range

PRODUCT MODEL NUMBERS		PRODUCT DIMENSIONS
WFG20S0FS	WFG525S0H	WFG550S0H

ELECTRICAL REQUIREMENTS

A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is required. A time-delay fuse or circuit breaker is also recommended. It is recommended that a separate circuit serving only this range be provided.

GAS SUPPLY REQUIREMENTS

Type of gas

Natural gas:

A

■■ This range is factory set for use with Natural gas. See “Gas

Conversions” section. The model/serial rating plate located on the

oven frame behind the top left side of the oven door has information

on the types of gas that can be used. If the types of gas listed do not

F

C

include the type of gas available, check with the local gas supplier.

B

Propane gas conversion:

Conversion must be done by a qualified service technician. No attempt

shall be made to convert the appliance from the gas specified on the

model/serial rating plate for use with a different gas without consulting

the serving gas supplier. See “Gas Conversions” section.

GAS SUPPLY LINE

E

■■ Provide a gas supply line of 3/4" (19 mm) rigid pipe to the range

D

location. A smaller size pipe on longer runs may result in insufficient

gas supply. With Propane gas, piping or tubing size can be 1/2"

(13 mm) minimum. Usually, Propane gas suppliers determine the

size and materials used in the system.

A. 277/8" (70.8 cm) max. depth with handle

NOTE: Pipe-joint compounds that resist the action of Propane gas

B. 36" (91.4 cm) cooktop height (max.) with leveling legs screwed all the

must be used. Do not use TEFLON®† tape.

way in*

Flexible metal appliance connector:

C. 467/8" (119.1 cm) overall height (max.) with leveling legs screwed all

■■ If local codes permit, a new CSA design-certified, 4 to 5 ft (122 to

the way in*

D. 297/8" (75.9 cm) width

152.4 cm) long, 1/2" (13 mm) or 3/4" (19 mm) I.D., flexible metal

E. 257/16" (64.6 cm) depth. Back of range to front of cooktop**

appliance connector may be used for connecting range to the gas

F. Model/serial rating plate (located on the oven frame behind the

supply line.

top left side of the oven door)

IMPORTANT: Range must be level after installation. Follow the

instructions in the “Level Range” section. Using the cooktop as a

reference for leveling the range is not recommended.

■■ A 1/2" (13 mm) male pipe thread is needed for connection to the

* Range can be raised approximately 1" (2.5 cm) by adjusting the

female pipe threads of the inlet to the appliance pressure regulator.

leveling legs.

■■ Do not kink or damage the flexible metal tubing when moving the

** Front of door and drawer may extend further forward, depending on

range.

styling.

■■ Must include a shutoff valve:

The supply line must be equipped with a manual shutoff valve. This

valve should be located in the same room but external to the range

opening, such as an adjacent cabinet. It should be in a location that

allows ease of opening and closing. Do not block access to shutoff

valve. The valve is for turning on or shutting off gas to the range.

B

A

C

A.Gas supply line

B.Shutoff valve “open” position

C.To range

†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.

Page 1 of 2

Because Whirlpool Corporation includes a continuous commitment to improve our	Dimensions are for planning purposes only. For complete details, see Installation	Ref. W10545337B
products, we reserve the right to change materials and specifications without notice.	Instructions packed with product. Specifications subject to change without notice.	04/19/2017