GSI 4453 C AL
Whirlpool GSI 4453 C AL, GSIP 6988 IN, GSI 6988 C-IN, GSI 4321 WS, GSIK 6453 AL User Manual
...
10
Instructions for use
Before using the dishwasher/Connections
Electrical connection
Precautions and general recommendations
How to fill the salt container
How to fill the rinse aid dispenser
How to fill the detergent dispenser
Care and Maintenance
11
Before using the dishwasher/Connections
1. Removing the packaging
and controls:
After unpacking, make sure
that the dishwasher is
undamaged and that the door
closes correctly. If in doubt,
contact a qualified technician
or your local retailer.
•
Keep the packaging
materials (plastic bags,
polystyrene parts, etc.) out of
reach of children, as they are
potentially dangerous.
2. Water and electrical
connections:
All water and electrical
connections must be carried
out by a qualified technician
in compliance with the
manufacturer's instructions
(refer to the enclosed
installation booklet) and
current local safety
regulations.
The appliance must only be
used in the household for
the prescribed uses.
Do not use the dishwasher if it
has been damaged in transit.
Consult your local retailer or
our After-Sales Service.
(Refer to the separate
installation instructions
booklet)
3. Water inlet and drain:
•
Observe any special
regulations issued by your
local Water Board.
Water supply pressure:
0.3 - 10 bar.
•
Make sure the inlet and drain
hoses are kink-free and are
not crushed.
•
If the hose length is not
sufficient, please contact
your local dealer or our
After-Sales Service.
•
The inlet hose must be
securely clamped to the
water tap to prevent leaks.
•
The inlet water temperature
varies according to the model
installed. Inlet hose marked
“25° C Max”: maximum
temperature 25° C.
All other models: maximum
temperature 60° C.
•
When installing the
appliance, make sure the
drain water discharges
correctly (if necessary,
remove the wire gauze from
the sink siphon).
•
Fix the drain hose to the
spigot with a clamp to
prevent it from coming off
during operation.
•
For appliances with water-
stop system only: If the water
connections are made
correctly, the water-stop
system safeguards your home
against damage caused by
flooding.
4. Electrical connection:
•
Closely adhere to local
Electricity Board regulations.
Voltage information is shown
on the rating plate mounted
inside the door on the right
hand side.
•
The appliance must be
earthed as prescribed by law.
•
Do not use extension leads or
multiple adapters.
•
Before carrying out
maintenance, disconnect the
mains plug.
•
The power cable must only be
replaced by authorized
personnel.
Warning for models
provided with LCD display:
The mains plug must be
positioned in an easily
accessible place.
• For Austria:
if the apparatus
is series connected to a fault
current switch, this must be
sensitive to the pulsating
current.
12
Electrical connection
1) For Great Britain only
Warning - this appliance
must be earthed
Fuse replacement
If the mains lead of this
appliance is fitted with a
BS 1363A 13amp fused plug,
to change a fuse in this type
of plug use an A.S.T.A.
approved fuse to BS 1362
type and proceed as follows:
1.
Remove the fuse cover (
A
)
and fuse (
B
).
2.
Fit replacement 13A fuse into
fuse cover.
3.
Refit both into plug.
Important:
The fuse cover must be
refitted when changing a
fuse and if the fuse cover is
lost the plug must not be
used until a correct
replacement is fitted.
Correct replacement are
identified by the colour
insert or the colour
embossed in words on the
base of the plug.
Replacement fuse covers are
available from your local
electrical store.
2) For the Republic of
Ireland only
The information given in
respect of Great Britain will
frequently apply, but a third
type of plug and socket is also
used, the 2-pin, side earth type.
3) Socket outlet / plug
(valid for both
countries)
If the fitted plug is not suitable
for your socket outlet, Please
contact Whirlpool Service for
further instruction. Please do
not attempt to change plug
yourself. This procedure needs
to be carried out by a qualified
Whirlpool technician in
compliance with the
manufactures instructions and
current standard safety
regulations.
13
Precautions and general recommendations
1. Packing:
•
The packing box may be fully
recycled as confirmed by the
recycling symbol.
2. Energy and water saving
tips:
•
Do not rinse crockery under
running water.
•
Always fully load the
dishwasher before switching
on or set the wash
programme to Half Load/
Multizone (if available) if
one
rack only is loaded.
•
If ecological energy sources
are available such as solar
panel heating, heat pumps or
centralised heating systems,
the appliance may be
connected to the hot water
mains up to a maximum
temperature of 60° C. Make
sure the water inlet hose is of
the correct type. Refer to the
“Connections” chapter in
these user instructions.
3. Disposal:
The appliance is built from
reusable materials.
If you decide to scrap the
dishwasher, it must be
disposed of in compliance
with local waste disposal
regulations.
•
Before scrapping, cut off the
power cable so that the
appliance cannot be
connected to the mains.
4. Child safety:
•
Children must not be allowed
to play with the dishwasher.
•
Store the detergent, rinse aid
and salt in a dry place out of
the reach of children.
5. General
recommendations:
•
The open dishwasher door
can only support the weight
of the loaded rack when
pulled out. Do not rest objects
on the open door or sit or
stand on it:
the appliance
may topple over!
•
Do not use solvents inside the
dishwasher:
risk of
explosion!
•
Only use detergents, rinse
aids and regeneration salts
specially recommended for
use in domestic dishwashers.
•
Before cleaning or carrying
out maintenance, switch off
the appliance, disconnect the
mains plug and turn off the
water tap.
•
If a fault occurs, switch off
the appliance and turn off
the water tap.
•
If necessary, the power cable
may be replaced with one the
same obtained from our
After-Sales Service. The
power cable must only be
replaced by a qualified
technician.
•
On completion of the
programme switch off the
dishwasher and turn off the
water tap.
6. For appliances with water
stop system:
The water inlet hose and
plastic casing contain
electrical components.
Do not therefore cut the
hose or immerse the plastic
casing in water. If the hose is
damaged switch off the
appliance immediately.
EC Declaration of
conformity:
This appliance has been
designed, constructed and
distributed in compliance
with the safety requirements
of EC Directives:
•
73/23/EC
•
89/336/EC
•
93/68/EC
Load capacity:
12 place settings.
Loading...