Whirlpool ADG 934 IX INSTRUCTION FOR USE
GB
ADG 934
Quick Reference Guide
Further indications are given in the pages to follow and in the user instructions.
Programme progress indicator
Pre-rinse / Pre-wash
Programme selector
Washing
Drying
Programme end
Programme Symbol
and Temperature
Pre-wash
Rapid 50° C
Normal 65° C
1) Values may vary in relation to usage, e.g.: different loads, water
temperatures - above or below 15° C - as well as water hardness and power supply voltage, etc.
2) Reference programme for Test Institute and energy-label.
2)
Crockery to be washed later.
Normally or heavily soiled crockery with dried-on food.
Heavily soiled pans and saucepans.
Programme selection and
recommended load type
Start button
Indicator lamp lit while the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.
Place the detergent in the:
small
compartment
--5.00.029
X X 12.5 0.90 65
X X 20.0 1.63 98
large
compartment
Water
(Litres)
Consumption
Normal load
Energy
(kWh)
1)
Time
(Min.)
5019 100 91313
(We reserve the right to make technical modifications)
How to use the dishwasher
1. After loading the dishwasher, close the
door properly and open the water
supply tap.
2. The programme selector knob comes
out by pressing and then releasing it.
The dishwasher switches on
automatically as soon as the
programme selector knob is turned.
3. Turn the selector knob to select the
desired programme.
corresponding indicator lamp lights
If required, select options
up.
(if supplied).
4. The programme selector knob goes in
by pressing it right in and then releasing
it. Whether or not the programme
selector knob is pressed does not
influence operation of the dishwasher in
any way.
5. Press the Start button to start the se lected
wash programme.
indicator lamp switches on.
the programmed data cannot be altered
by turning the programme selector knob.
once the Start button has been
Note:
pressed, the dishwasher memorises
the last programme selected. This
information remains in the memory
even during interruption of the power
supply.
To change the selected programme,
press the Start button for about 5
seconds. The Start indicator lamp will
switch off. Select a new programme
and press the Start button.
if the dishwasher is switched off
Note:
during a wash programme, when
switched on again it will resume the
wash cycle from where it was
interrupted.
Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.
The
The corresponding
Once set,
6. To indicate the end of the programme,
the Start indicator lamp switches off
and
the End indicator lamp (if fitted)
lights up
7. Once the Start indicator lamp has
8. Open the door (warning: beware of hot
(for about 30 min.)
switched off, pull the programme
selector knob out and turn it to the
initial position to switch the dishwasher
off. The programme selector knob can
be pressed in again.
lamps switch off.
steam). Unload the lower rack before
the upper one. Close the water tap.
.
All the indicator
Upper rack
Rack height adjustment:
(The dishwasher is delivered with the upper
rack in the top position). The rack height
can also be changed when loaded.
Please read the user instructions carefully.
Upper and lower rack
• To lower: pull out the
handles and gently lower the rack.
• To raise: pull up the
until the rack clicks into place.
• The rack must be level on both
sides.
Crockery holders:
• Down: cups and long-stemmed
glasses.
•
Up: plates.
Glass holder:
two
two
side
side handles
Lower rack
A
A
C
Plate holders:
•(A) may be lowered to increase
available space.
Cutlery basket:
• The cutlery basket can be removed
to increase (C) available space.
C
Loading...