VTech VSP600 Quick Start Manual

Quick Start Guide

VSP600

DECT SIP Cordless Base Station
with Cordless Handset

Important Safety Information

This symbol is to alert you to important operating or servicing instructions
that may appear on the product or in this user’s manual. Always follow
basic safety precautions when using this product to reduce the risk of

injury, re, or electric shock.

Important Safety Instructions

When using your telephone equipment, basic safety precautions should always be

followed to reduce the risk of re, electric shock and injury, including the following:

1. This product should be installed by a qualied technician.

2. This product should only be connected to the host equipment and never directly
to the network such as Public Switch Telephone Network (PSTN) or Plain Old
Telephone Services (POTS).

3. Read and understand all instructions.

4. Follow all warnings and instructions marked on the product.

5. Unplug this product from the wall outlet before cleaning. Do not use liquid or
aerosol cleaners. Use a damp cloth for cleaning.

6. Do not use this product near water such as near a bath tub, wash bowl, kitchen
sink, laundry tub or swimming pool, or in a wet basement or shower.

7. Do not place this product on an unstable table, shelf, stand or other unstable
surfaces.

8. Slots and openings in the back or bottom of the base station and handset are
provided for ventilation. To protect them from overheating, these openings must
not be blocked by placing the product on a soft surface such as a bed, sofa or
rug. This product should never be placed near or over a radiator or heat register.
This product should not be placed in any area where proper ventilation is not
provided.

9. This product should be operated only from the type of power source indicated
on the marking label. If you are not sure of the type of power supplied at the
premises, consult your dealer or local power company.

10. Do not allow anything to rest on the power cord. Do not install this product
where the cord may be walked on.

2

11. Never push objects of any kind into this product through the slots in the base
station or handset because they may touch dangerous voltage points or create
a short circuit. Never spill liquid of any kind on the product.

12. To reduce the risk of electric shock, do not disassemble this product, but take it
to an authorized service facility. Opening or removing parts of the base station

or handset other than specied access doors may expose you to dangerous

voltages or other risks. Incorrect reassembling can cause electric shock when
the product is subsequently used.

13. Do not overload wall outlets and extension cords.

14. Unplug this product from the wall outlet and refer servicing to an authorized

service facility under the following conditions:

A. When the power supply cord or plug is damaged or frayed.

B. If liquid has been spilled onto the product.

C. If the product has been exposed to rain or water.

D. If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the
operation instructions. Improper adjustment of other controls may
result in damage and often requires extensive work by an authorized
technician to restore the product to normal operation.

E. If the product has been dropped and the telephone base and/or
handset has been damaged.

F. If the product exhibits a distinct change in performance.

15. Avoid using a telephone (other than cordless) during an electrical storm. There
is a remote risk of electric shock from lightning.

16. Do not use the telephone to report a gas leak in the vicinity of the leak. Under
certain circumstances, a spark may be created when the adapter is plugged
into the power outlet, or when the handset is replaced in its cradle. This is a
common event associated with the closing of any electrical circuit. The user
should not plug the phone into a power outlet, and should not put a charged
handset into the cradle, if the phone is located in an environment containing

concentrations of ammable or ame-supporting gases, unless there is
adequate ventilation. A spark in such an environment could create a re or
explosion. Such environments might include: medical use of oxygen without

adequate ventilation; industrial gases (cleaning solvents; gasoline vapors; etc.);
a leak of natural gas; etc.

3

17. Only put the handset of your telephone next to your ear when it is in normal talk
mode.

18. The power adapters are intended to be correctly oriented in a vertical or oor
mount position. The prongs are not designed to hold the plug in place if it is

plugged into a ceiling, under-the-table or cabinet outlet.

19. Use only the power cord indicated in this manual.

20. In wall mounting position, make sure to mount the telephone base on the wall
by aligning the eyelets with the mounting studs of the wall plate. Then slide the
telephone base down on both mounting studs until it locks into place. Refer to the
full installation instructions in the User Guide.

21. CAUTION: Keep small metallic objects such as pins and staples away from the
handset receiver.

SAVE THESE INSTRUCTIONS

4

Compliance

FCC part 15

This device complies with Part 15 of the FCC rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may
cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the

user will be required to correct the interference at the user’s expense.

Privacy of communications may not be ensured when using this phone.

Warning: Changes or modications to this equipment not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

Caution: To maintain the compliance with the FCC’s RF exposure guideline, place the

base unit at least 20 cm from nearby persons.

For body-worn operation, this handset has been tested and meets the FCC RF exposure

guidelines when used with the accessories supplied or designated for this product. Use of

other accessories may not ensure compliance with FCC RF exposure guidelines.

This Class A digital apparatus complies with Canadian requirements:
CAN ICES-3 (A)/NMB-3(A).

Cet appareil numérique de la classe A est conforme à la norme CAN ICES-3 (A)/NMB-

3(A) du Canada.

This device complies with Industry Canada license-exempt RSS standard(s).

Industry Canada

Operation is subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation of the device.

Privacy of communications may not be ensured when using this telephone.

The term ‘’IC:‘’ before the certication/registration number only signies that the
Industry Canada technical specications were met.

This product meets the applicable Industry Canada technical specications.

5

About this Guide

This quick start guide provides a reference for the external features of the base

station and handset and basic installation instructions.

Please refer to the VSP600/VSP601 User Guide for complete installation and
operation instructions. You can download the guide from

businessphones.vtech.com.

For customer service or product information, visit our website at

businessphones.vtech.com or call 1 [phone].

Parts Checklist

Your package contains the following items. Save your sales receipt and
original packaging in the event warranty service is necessary.

Quick start guide

Quick Start Guide Handset charger

Base Station Base Station

Base Station
DC adapter

wall-mounting plate

Handset

DC adapter

Handset battery and
battery compartment
cover

6

Ethernet cable

Handset charger