Vaisala Veriteq vNet
Spacer Label
Installing this spacer label will help align the logger on the
vNet device to prevent bending or breaking of pins when
securing a logger. Follow these quick and easy installation
instructions to permanently adhere the spacer label to the
IMPORTANT: Before proceeding, remove the logger from the
vNet device by pressing the button on the left side of the vNet
device with a pen and pulling up on the left side of the logger.
vNet device.
Step 1 Peel the adhesive paper strip off the spacer.
Step 2 Place the spacer face down with the sticky side up.
Slide it against the wall of the vNet device so that edges of
the spacer t between the two tabs.
See Reverse
Step 3 Lift the spacer from its horizontal position and place
it vertically against the wall of the vNet device (side view is
indicated below).
Step 4 Press the spacer rmly against the wall so that it
adheres in place.
Step 5 Before re-attaching the logger to the vNet device,
inspect the vNet connector for any misaligned or bent pins. If
you nd misaligned or bent pins, contact support as per the
information below.
For support or information, call
1-866-861-3388 (or 604-273-
6850) 8am-4pm PST Monday to
Friday, or email veriteqsupport@
vaisala.com
PI215199-A ©Vaisala 2011
This material is subject to copyright protection, with all
copyrights retained by Vaisala and its individual partners. All
rights reserved. Any logos and/or product names are trademarks
of Vaisala or its individual partners. The reproduction, transfer,
distribution or storage of information contained in this brochure
in any form without the prior written consent of Vaisala is strictly
prohibited. All specications — technical included — are
subject to change without notice.