Vaddio IR Remote Master Users Guide

User Guide for the

Vaddio IR Remote Master

August 2022

998-2105-000 (Worldwide)

Installing the Batteries

The remote uses two AAA batteries.

1. Remove the cover from the back of the remote. You may need to press down on the
upper edge while sliding it off.

2. Install the batteries as shown in the diagram in the battery opening.

3. Slide and snap the cover back into place.

Tips for Using the Remote

Presets: The remote provides access to camera presets. Your camera’s web interface
may provide access to additional camera presets.

Camera selection: The remote has three IR channels, so it can control up to three
cameras independently. Check your camera’s manual for information on setting it as
camera 1, camera 2, or camera 3. By default, Vaddio cameras respond as camera 1.

Troubleshooting tip: If the camera does not respond to the remote, press the Camera 1 button and try
again. If that doesn’t fix the problem, try the other camera selection buttons.

Autoframing cameras: Autoframing pauses when you press any button that affects the shot (arrows,
home, zoom, presets).

Document Number 411-0058-41 Rev B – August 2023

User Guide for the Vaddio IR Remote Master

IR Remote Master Quick Reference

The remote may have controls for capabilities that your camera does not have. Some
buttons behave in different ways depending on the camera’s capabilities.

Power button and indicator – Set the camera to standby mode, or
return to full-power mode.

Arrow buttons – Pan and tilt.

Home button – Function depends on the model of camera. For

Autoframing cameras, press to resume auto-framing.

Network button – Display the camera's IP address on the video
output(s).

Backlight button – Adjusts for excess light behind the camera’s
subject.

Mute button – Mute connected or built-in microphone(s).

Volume +/– button – Increase or decrease the volume from the

connected or built-in speaker.

Focus +/– buttons – Adjust the focal distance in or out, when Manual
focus mode is selected.

Zoom +/– button– Increase or decrease the zoom.

Focus Auto/Man buttons – Select automatic or manual focus.

Pan Dir buttons – Set pan direction relative to the person using the

remote. Std is from the camera’s perspective. Rev is from the
perspective of a person facing the camera.

Set, Clr, and Preset buttons – Set, clear, or select preset shots.

2

User Guide for the Vaddio IR Remote Master

Storing and Clearing Presets

Depending on the camera, presets may store zoom, pan/tilt location, color settings, or some combination
of these.

Your camera may have additional presets available through its web interface.

To store a preset:

Set up the shot. Then hold down the Set button and press one of the numbered preset buttons.

To clear a preset:

Press and hold the Clr button while pressing the number of the preset you want to clear.

Vaddio is a brand of Legrand AV Inc. · www.legrandav.com · Phone [phone] · Fax [phone] · Email
Europe, Middle East, Africa: [e-mail] · All other regions: [e-mail]

Vaddio is a registered trademark of Legrand AV Inc. All other brand names or marks are used for identification purposes and are
trademarks of their respective owners. All patents are protected under existing designations. Other patents pending.

©2023 Legrand AV Inc.