UVP GelCam 310 Camera User Manual

GelCam 310 Camera

Ultra-Violet Products Ltd.

Installation and User Instructions

UVP, LLC

2066 W. 11th Street
Upland, CA 91786
Phone: [phone]
Fax: [phone]

Web Site: www.uvp.com

Unit 1, Trinity Hall Farm Estate,

Nuffield Road, Cambridge CB4 1TG UK

Phone: [phone]

Fax: [phone]

81-0302-01 Rev A

GelCam 310 2

This configuration comes with:

Introduction

The high sensitivity, non-cooled CCD GelCam 310 Camera is designed for use with a variety of UVP’s Imaging
Systems. The instruction manual covers as sem bly of the ca mera on the darkroom and inst allat ion of software.

Refer to the system (manual for additional system information and the VisionWorksLS Software Manual or Help Files
for software information.

Components

Specifications GelCam 310 Camera

Type Monochrome
Resolution 1600 x 1200
Megapixels 2.0
Bit Depth 12/16-bit
PC Interface USB 2.0

The camera/lens kit components and camera bracket are assembled at the UVP factory. Refer to the packing list.

Installation

GelDoc-It with Manual Lens

 GelCam 310 Camera
 Manual lens
 +2 diopter
 Bracket
 Base (typically shipped on system)
 USB Cable

GelCam 310 3

1. Align the holes of the gasket and base. Attach

Photo to the right shows the center hole for the

the base and gasket to the darkroom using the
screws provided. Position the bracket on the
mounting base aligning the holes on the base.
Using the four thumb screws provided, secure the
bracket to the base.

2. Place the camera and lens assembly into the
camera bracket. Push the lens through the center
hole in the gasket. The gasket forms a seal
around the lens. Insert and tighten the
knob/washer to secure the camera to the bracket.
Be sure to position the knob in the central hole in
the camera (refer to the photo callout below).

3. Plug the 90 degree cable into the top of the
camera. Leave the other end unplugged until
ready to install the Visionworks disk.

knob connection.