Ubiquiti AM-V2G-TI Quick Start Guide

2.4 GHz 2x2 MIMO
BaseStation Antenna
with Variable Beamwidth

Model: AM-V2G-Ti

Introduction

Thank you for purchasing the Ubiquiti Networks® airMAX®
Titanium Sector. This Quick Start Guide is designed to guide
you through the installation of the antenna. This Quick Start
Guide also includes the warranty terms and is for use with the
airMAX Sector Antenna, model AM-V2G-Ti.

Package Contents

Antenna Protective

Carriage Bolts

(M8x135, Qty. 4)

Products may be different from pictures and are subject to change without notice.

TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet
cable and earth grounding must be used as conditions of product warranty. TOUGHCable is
designed for outdoor installations. It is the customer’s responsibility to follow local country
regulations, including operation within legal frequency channels, output power, and Dynamic
Frequency Selection (DFS) requirements.

Shroud

Serrated

Flange Bolts

(M8x20, Qty. 4)

U-Brackets

(Qty. 2)

Serrated

Flange Nuts

(M8, Qty. 8)

Pole Brackets

(Qty. 2)

RF Cables

(Qty. 2)

Pole Clamps

(Qty. 2)

2.4 GHz 2x2 MIMO
BaseStation Antenna
with Variable Beamwidth

Model: AM-V2G-Ti

Quick Start

Guide

Installation Requirements

• Rocket™M2 Titanium or RocketM2 (sold separately)

• 12 mm and 13 mm wrenches

• Shielded Category 5 (or above) cabling should be used for
all wired Ethernet connections and should be grounded
through the AC ground of the PoE.

We recommend that you protect your networks from the
most brutal environments and devastating ESD attacks
with industrial-grade shielded Ethernet cable from Ubiquiti
Networks. For more details, visit www.ubnt.com/toughcable

Hardware Overview

Adjustable Beamwidth Deflectors

Mounting Lugs

Bubble Level

RF Connectors

Rocket Mount

Rocket/Shroud

Release Lever

Mounting Lugs

Back

Hardware Installation

1. Set the desired beamwidth by adjusting the Beamwidth

Deflectors. Loosen the four hex head screws enough
to move the Beamwidth Deflectors, but do not remove

thescrews.

2. Carefully move the Beamwidth Deflectors to the desired

angle, as indicated by the screw slots.

120° Beamwidth

90° Beamwidth

60° Beamwidth

Important: Both deflectors must be set to the same

angle.

3. Tighten the four hex head screws.

4. Attach the RF Cables to the connectors labeled Chain 0 and

Chain 1 on the Rocket.

5. Attach the Rocket to the Rocket Mount.

a. Align the mounting tabs on the back of the Rocket with

the four mounting slots on the bracket.

b. Slide the Rocket down until it locks into place.

6. Connect the other ends of the RF Cables to the RF

Connectors on the antenna.

7. Slide the Protective Shroud down over the Rocket until it

locks onto the Rocket Mount.

Note: If you have trouble locking the shroud into

place, try adjusting the placement of the RF Cables.