Ubiquiti AM-M-V5G-TI Quick Start Guide
5 GHz 2x2 MIMO
BaseStation Antenna
with VariableBeamwidth
Model: AM-M-V5G-Ti
Introduction
Thank you for purchasing the Ubiquiti Networks® airMAX®
Titanium Sector. This Quick Start Guide is designed to guide
you through the installation of the antenna. This Quick Start
Guide also includes the warranty terms and is for use with the
airMAX Sector Antenna, model AM-M-V5G-Ti.
Package Contents
Antenna Protective
Carriage Bolts
(M8x135, Qty. 4)
Products may be different from pictures and are subject to change without notice.
TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet
cable and earth grounding must be used as conditions of product warranty. TOUGHCable is
designed for outdoor installations. It is the customer’s responsibility to follow local country
regulations, including operation within legal frequency channels, output power, and Dynamic
Frequency Selection (DFS) requirements.
Shroud
Flange Bolts
(M8x20, Qty. 4)
U-Brackets
Serrated
(Qty. 2)
Pole Brackets
Serrated
Flange Nuts
(M8, Qty. 8)
(Qty. 2)
RF Cables
(Qty. 2)
Pole Clamps
(Qty. 2)
5 GHz 2x2 MIMO
BaseStation Antenna
with VariableBeamwidth
Model: AM-M-V5G-Ti
Quick Start
Guide
Installation Requirements
• Rocket™M5, RocketM5 GPS, or RocketM5 Titanium
(sold separately)
• 3 mm hex key driver
• 12 mm and 13 mm wrenches
• Shielded Category 5 (or above) cabling should be used for
all wired Ethernet connections and should be grounded
through the AC ground of the PoE.
We recommend that you protect your networks from the
most brutal environments and devastating ESD attacks
with industrial-grade shielded Ethernet cable from Ubiquiti
Networks. For more details, visit www.ubnt.com/toughcable
Hardware Overview
Mounting
Adjustable
Beamwidth
Deflectors
Lugs
Bubble Level
RF Connectors
Rocket Mount
Rocket/Shroud
Release Lever
Mounting
Lugs
BackFront
Hardware Installation
1. Set the desired beamwidth by adjusting the Beamwidth
Deflectors. Use a 3 mm hex key driver to loosen the four hex
head screws enough to move the Beamwidth Deflectors,
but do not remove the screws.
2. Carefully move the Beamwidth Deflectors to the desired
angle, as indicated by the screw slots.
120° Beamwidth
90° Beamwidth
60° Beamwidth
Important: Both deflectors must be set to the
sameangle.
3. Tighten the four hex head screws.
4. Attach the U-Brackets to the antenna:
a. Secure the slotted U-Bracket to the upper Mounting Lugs
of the antenna using two Serrated Flange Nuts.
b. Secure the other U-Bracket to the lower Mounting Lugs
of the antenna using two Serrated Flange Nuts.
Note: Orient both U-Brackets as shown below.
5. Attach the RF Cables to the connectors labeled Chain 0 and
Chain 1 on the Rocket.
6. Attach the Rocket to the Rocket Mount.
a. Align the mounting tabs on the back of the Rocket with
the four mounting slots on the bracket.
b. Slide the Rocket down until it locks into place.
Loading...