Ubiquiti AM-9M13-120 Quick Start Guide

900 MHz 2x2 MIMO
BaseStation
Sector Antenna

Model: AM-9M13

Introduction

Thank you for purchasing the Ubiquiti Networks™ airMAX™

900MHz 2x2 MIMO BaseStation Sector Antenna. This Quick
Start Guide is designed to guide you through the installation
of the antenna. This Quick Start Guide also includes the
warranty terms and is for use with the airMAX Sector Antenna,
model AM-9M13.

Package Contents

Antenna Antenna Bottom

M12x180 Bolts

(Qty. 2)

M12 Serrated

Flange Nuts

(Qty. 8)

Products may be different from pictures and are subject to change without notice.

TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet
cable and earth grounding must be used as conditions of product warranty. TOUGHCable is
designed for outdoor installations. It is the customer’s responsibility to follow local country
regulations, including operation within legal frequency channels, output power, and Dynamic
Frequency Selection (DFS) requirements.

Cover

M12x130 Bolts

(Qty. 2)

M8 Serrated
Flange Nuts

(Qty. 4)

U-Brackets

(Qty. 2)

M8x25 Bolts

(Qty. 4)

Bushing Quick Start

V-Brackets

(Qty. 3)

M3x8 Tapping

Screw

900 MHz 2x2 MIMO
BaseStation
Sector Antenna

Model: AM-9M13

Guide

Installation Requirements

• Rocket™M900 (sold separately)

• Two adjustable wrenches or a combination of two 19 mm,

one 14 mm, and one 13 mm wrenches

• One #2 Phillips screwdriver

• Shielded Category 5 (or above) cabling should be used for

all wired Ethernet connections and should be grounded
through the AC ground of the PoE.

We recommend that you protect your networks from the

most brutal environments and devastating ESD attacks
with industrial-grade shielded Ethernet cable from Ubiquiti
Networks. For more details, visit www.ubnt.com/toughcable

Hardware Installation

1. Remove the Port Cover by lifting the release latch on the
bottom of the RocketM900 and sliding the Port Cover off.

Port Cover

2. Route an Ethernet cable through the hole on the Antenna
Bottom Cover and connect it to the Ethernet Port.

Antenna Bottom Cover

3. Replace the Port Cover.

4. Attach the two Antenna RF Connectors to the connectors
labeled Chain 0 and Chain 1 on the RocketM900. Place the
RocketM900 in the bottom of the antenna.

Antenna RF Connectors

UBIQ U IT I N ET W OR KS

5. To install the Antenna Bottom Cover:
a. Insert the cover's tabs into the notches of the antenna

bottom.
b. Press the cover and snap it into place.
c. Secure the cover to the bottom of the antenna using

the M3x8 Tapping Screw.

Antenna Bottom Cover

6. Wrap the Bushing around the Ethernet cable and then push
it into place in the Antenna Bottom Cover.

Antenna Bottom Cover

M3x8 Tapping Screw

UBIQ UI T I N ET WO R KS

Bushing