TP Link CPE220V3 User Manual
Installation Guide
Outdoor CPE
CPE210 / CPE220 / CPE510 / CPE520
Contents
Overview 01
Hardware Connection 04
Site Consideration 04
Connection and Installation 06
Lightning & ESD Protection 08
Software Conguration 10
Logging in to the PharOS 10
Typical Application Conguration 12
Antenna Alignment 14
Specications 15
FAQ 16
Overview
TP-Link's Pharos series outdoor CPEs are dedicated to outdoor wireless
network solutions. This guide is applicable to products including CPE210,
CPE220, CPE510 and CPE520.
• Package Contents
Power Cord
Pharos CPE
Passive PoE
Adapter
Mounting Bracket
Plastic Wall Anchors (Qty.2)
Self-tapping Screws (Qty.2)
• LED Explanation
The following picture takes CPE520 as an example.
AP/AP Router mode:
All four LEDs remain solid.
Client/Bridge/Repeater/AP Client Router mode:
That the more LEDs lit will indicate better wireless signal strength.
On: A device is connected to this port, but there is no activity.
POWERLAN0LAN1
Flashing: A device is connected to this port, and is active.
On: The CPE is powered on.
Pole Mounting
Straps
Installation Guide
Outdoor CPE
CPE210 / CPE220 / CPE510 / CPE520
Installation Guide
01
• Panel Layout
Pharos CPE220/CPE520:
Grounding
Terminal
Shielded Ethernet
Port LAN0 (Passive
PoE in)
Pharos CPE210/CPE510:
Grounding
Terminal
Port LAN1
Shielded Ethernet Port
LAN (Passive PoE in)
RESETShielded Ethernet
RESET
02
Passive PoE Adapter:
Remote Reset
Press and hold for 8 seconds to
reset the CPE to its factory defaults.
Power LED
The Power LED is on when the
passive PoE adapter is working
normally.
03
Hardware Connection
1. Site Consideration
• Mounting Height
Ensure a clear line of sight between the wireless devices for an optimum
performance. An elevated location is recommended as obstacles like
trees, buildings and large steel structures will weaken the wireless signal.
See 'Q2' in 'FAQ' for details about how to calculate the minimum mounting
height of the devices.
Line of Sight
Side View
04
• Orientation
Install the CPE devices with the front facing the intended signal receiving
devices. You can orient the devices with the assistance of Google Maps,
GPS and some landmarks according to the horizontal beamwidth listed
below.
Models CPE210 CPE220 CPE510 CPE520
Horizontal Beamwidth 65° 60° 45° 45°
shenzhen
A
Line of Sight
05
Horizontal
Beamwidth
B
2. Connection and Installation
Connect and mount the CPE and power adapter as shown below. The
following introduction takes CPE520 as an example.
• Connecting CPE and Power Adapter
Connect the CPE and power adapter as shown in the gure below.
LAN0
Ethernet cable length up to 60m
Slide to replace the cover
of the CPE when all
connections are nished.
PoE
You should prepare an adequate
Ethernet cable to connect the CPE
and the passive PoE adapter.
Shielded CAT5e (or above) cable
with ground wire is recommended
(refer to the next section).
LAN
Connect to a computer,
router or switch.
(Depending on your
intended usage and/or
network topology.)
06
Loading...