Toyota Hilux, PZ464-00132 User Manual

Vehicle Security System VSS3 - Hilux
Owner’s manual
Read this manual thoroughly before using the VSS3.
Always keep this owner’s manual in the vehicle.
Dear Customer,
Please read this manual to get the full benefit of the system. We suggest that you keep this manual in the car. It will be easier for you to find the information in the event of emergency. Your authorised retailer will be pleased to clarify any queries you may have with the system or its operation if you cannot find the information you need in this manual or in the chapter ‘Troubleshooting guide’.
Immunity information
- If any loss is caused by fire, action of a third party, or other accidents, or the user’s deliberate or accidental misuse, incorrect use, or use under abnormal conditions, repair of the product will be charged to the user.
- Toyota Motor Europe NV/SA is not liable for any incidental loss caused by the use or non-use of this product.
- Toyota Motor Europe NV/SA is not liable for any damages or incidents consequent to intentional misuse, accidental misuse, or third party use of the device.
- The alarm system will not prevent the car from being stolen.
VSS3 1
Content
1. PIN code ................................................................................................................ 4
2. Arm / Disarm ........................................................................................................ 5
2.1. To ARM the alarm system .......................................................................................... 5
2.2. To DISARM the alarm system ..................................................................................... 6
2.3. Stop the siren sounding ........................................................................................... 6
2.4. Arm without intrusion sensor .................................................................................... 7
2.5. Arm without additional sensors ................................................................................. 8
2.6. Automatic re-arming ............................................................................................... 8
2.7. Alarm status light (LED) ............................................................................................ 9
2.8. Back-up battery ........................................................................................................ 9
3. Features .................................................................................................................. 10
3.1. Door ajar warning .................................................................................................... 10
3.2. Alarm override ......................................................................................................... 10
3.3. Ignition Controlled door lock .................................................................................... 11
3.4. Passive arming .......................................................................................................... 11
3.5. Alarm memory ........................................................................................................ 12
3.6. Alarm without car horn sound .................................................................................. 12
3.7. Garage mode ........................................................................................................... 12
3.8. Arming buzzer .......................................................................................................... 13
3.9. Buzzer volume adjustment ........................................................................................ 13
4. Technical Specifications ........................................................................................ 14
5. Troubleshooting guide ......................................................................................... 15
6. Glossary ................................................................................................................ 16
2 VSS3
Introduction
This alarm system is operated by the original high security remote control described in the car’s owner’s manual. To programme extra remote controls consult your Toyota authorised retailer.
The alarm system can only be armed and disarmed with the original car remote control. The protection of your car is assured by interior movement and perimetric sensors. The alarm system is self-protected against system attack.
During an alarm, the alarm siren, and the vehicle horn, and the blinkers are activated.
Product functions
The Alarm system performs the following functions:
• Perimetricprotection(doors,boot,andbonnet)
• Interiorandwindowbreakageprotection(byultrasoundsensor)
• Alarmsystemtamperingprotection
• Protectionagainstunauthorisedstartingoftheengine
• Self-poweredalarmsystem
• Acousticandvisualalarmsignalization
• Alarmsystemstatusanddiagnosticindicationlight(LED)
• Additionalprotectionfeaturescanbeadded(inclinationsensormodule,…).
Alarm operation
The alarm is activated in the following situations:
• Alockeddoororbootisopenedinanywayotherthanusingthealarmsystemremotecontrol.
• Thebonnetisopenedwhilethecarislocked.
• Theintrusionsensorisactivated:whenthesensordetectssomethingmovinginsidethecar,or
a window is broken.
• Thebatteryterminalisdisconnectedwhilethealarmsystemisactivated.
Remarks
The intrusion sensor may be triggered by any of the following:
• Danglingaccessories
• Automaticorhighpressurecarwashes
• Theimpactofhail,lightningstrikes,orotherkindsofimpactorcontinuousvibrations
• Anyopenwindoworslidingroof.
As you will see from paragraph 2.4., the intrusion sensor can be deactivated.
VSS3 3
1. PIN code
Vehicle security system
Please do not leave this card in your vehicle
If the alarm system has been installed in your vehicle, you did receive from the authorized retailer a card (credit card size) with a PIN code (Personal Identification Number) consisting of 4 numbers.
The PIN code is used to deactivate the alarm system in case the remote control stops working. It will also be used by your authorised dealer to change your system configuration.
You should keep this card always with you. Do not leave it in your car.
If you have lost your PIN code, take contact with your authorized retailer.
1 Press the button on the LED push button the number of times that corresponds to the first
digit of the PIN Code, with a maximum 1.5 second delay between one press and the next. If the LED is already on when the button is pressed, it will go out.
2 Wait for the LED to flash indicating that the next digit can be entered.
3 Repeat the process for all four digits.
4 VSS3
To enter the PIN code
2. Arm / Disarm
LOCK (Arm)
UNLOCK
(Disarm)
The alarm system will be armed when you lock the car, and disarmed when you unlock the car using the remote key.
2.1. To ARM the alarm system
Important:
To prevent false alarm, check that there is no one in the car, and that all windows and sliding roofs are closed before locking the car (see how to deactivate the interior intrusion sensor in paragraph 2.4).
Action Hazard light indication
Remote control: Press the
lock button once.
Note:
– The car LED blinks to inform you that the immobiliser is set (not linked to alarm system) – If any door is not securely closed, 10 short beeps will sound (car will not be locked, but alarm
system will be armed) and the switch will be deactivated until door is closed properly.
– The system will be armed 30 seconds after the lock button is pressed (pre-arm time). – If your remote key is not working, you can arm the system by PIN code (see chapter 3.2).
Flashes once. ON for 30 seconds, then
Alarm status light (LED)
starts flashing.
VSS3 5
Loading...
+ 12 hidden pages