STOP!
BEFORE INSTALLING OR CONNECTING IK-WB02A TO
YOUR PC, READ THIS QUICK START GUIDE
THANK YOU
Quick Start Guide
Quick Start Guide for Network connection
The following software must be downloaded and installed
before installing the IK-WB02A:
• Internet Explorer
http://www.microsoft.com/windows/ie
• Toshiba Camera Finder software
The software is included on the supplied mini CD-ROM.
1) Connect the IK-WB02A to your network using a Cat5/
Ethernet cable BEFORE powering on your camera.
Repeat this step for any additional cameras.
Obtained IP address
depends on DHCP
or
Static IP address
192.168.0.30
TM
Version 6.0 or later
Network camera
Internet
Personal computer
Hub
Ethernet cable ( straight-through cable)
Ethernet cable (straight-through cable)
2) Power on your devices in the following order: cable or
DSL modem, router or hub, PCs.
3) Power on the IK-WB02A.
Quick Start Guide (Cont.)
4) Run the Toshiba Camera Finder software to
automatically detect your cameras. Refer to the
Operations Manual for more details.
5) If the camera is not found, power off the camera and
repeat the above steps. (The camera takes
approximately 30 seconds to start.)
6) Click on User.
If you do not have a static IP address for your Internet
connection, Toshiba offers DDNS service that will allow
you to have an Internet address for your camera.
1) Register for Toshiba's DDNS service by clicking on
the link IK-WB02A settings under Configuration >
DDns Settings.
2) Follow the instructions to set up your account.
Quick Start Guide for Direct* PC connection
* A Cat5 Crossover cable is required.
The following software must be downloaded and installed
before installing the IK-WB02A:
• Internet Explorer
http://www.microsoft.com/windows/ie
• Toshiba Camera Finder software
The software is included on the supplied mini CD-ROM.
1) Connect the IK-WB02A to your PC using a Cat5
Crossover cable BEFORE powering on your camera.
Static IP address
192.168.0.30
TM
Version 6.0 or later
Network camera
Static IP address
192.168.0.50
Personal computer
Ethernet cable ( crossover cable)
2