Thomson THT504PLUS User Manual
THT504+
Digital
Terrestrial
HD Receiver
User Manual
Bedienungsanleitung
Manuel d’utilisation
Manuale utente
Manual del usuario
Manual do Utilizador
Instrukcja obsługi
Ръководство на
потребителя
Felhasználói kézikönyv
Návod k obsluze
Evolution. Emotion. Passion.
www.thomsonstb.net
THOMSON is a trademark of TECHNICOLOR S.A. used under license to STRONG Europe
Represented by STRONG Ges.m.b.H. • Franz-Josefs-Kai 1 • 1010 Vienna • Austria
Email: support_at@thomsonstb.net
12 Mar 2015 10:49
LICENSES
ANY USE OF THIS PRODUCT IN ANY MANNER OTHER THAN PERSONAL USE THAT COMPLIES
WITH THE MPEG-2 STANDARD FOR ENCODING VIDEO INFORMATION FOR PACKAGED MEDIA
IS EXPRESSLY PROHIBITED WITHOUT A LICENSE UNDER APPLICABLE PATENTS IN THE MPEG-2
PATENT PORTFOLIO, WHICH LICENSE IS AVAILABLE FROM MPEG LA, LLC, 6312 S. Fiddlers Green
Circle, Suite 400E, Greenwood Village, Colorado 80111 U.S.A.
THIS PRODUCT IS LICENSED UNDER THE AVC PATENT PORTFOLIO LICENSE FOR THE PERSONAL
AND NONCOMMERCIAL USE OF A CONSUMER TO (i) ENCODE VIDEO IN COMPLIANCE WITH
THE AVC STANDARD (“AVC VIDEO”) AND/OR (ii) DECODE AVC VIDEO THAT WAS ENCODED
BY A CONSUMER ENGAGED IN A PERSONAL AND NON-COMMERCIAL ACTIVITY AND/OR WAS
OBTAINED FROM A VIDEO PROVIDER LICENSED TO PROVIDE AVC VIDEO. NO LICENSE IS GRANTED
OR SHALL BE IMPLIED FOR ANY OTHER USE. ADDITIONAL INFORMATION MAY BE OBTAINED FROM
MPEG LA, L.L.C. SEE HTTP://WWW.MPEGLA.COM
This product contains one or more programs protected under international and U.S. copyright
laws as unpublished works. They are confidential and proprietary to Dolby Laboratories. Their
reproduction or disclosure, in whole or in part, or the production of derivative works therefrom
without the express permission of Dolby Laboratories is prohibited. Copyright 2003-2009 by Dolby
Laboratories. All rights reserved.
English
P1
TABLE OF CONTENT
1.0 INTRODUCTION 3
1.1 Safety Instructions 3
1.2 Storage 3
1.3 Equipment Set-up 4
1.4 Accessories 4
1.5 Usage of external USB devices 4
2.0 YOUR RECEIVER 5
2.1 DEFAULT PIN: 1234 5
2.2 Front Panel 5
2.3 Rear Panel 5
2.4 Remote control 5
2.5 Installing the batteries 6
2.6 Using the remote control 6
3.0 CONNECTION 7
3.1 Connecting to a terrestrial antenna 7
3.2 Connecting to TV with HDMI cable 7
3.3 Connecting to TV with SCART cable 7
3.4 Connecting to a Digital Audio Amplifier
with S / PDIF 7
3.5 Connecting to a digital audio amplifier
and TV using HDMI 7
3.6 Connecting to an analogue Audio
Amplifier 8
3.7 Connecting a USB storage device 8
THOMSON declares that this item complies with the basic requirements and other relevant regulations of
directives 2004/108/EC and 73/23/EC, RoHS 2002/95/EC
Subject to alterations. In consequence of continuous research and development technical specifications, design and
appearance of products may change. HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks
or registered trademarks of HDMI Licensing LLC in the United States and other countries. Manufactured under license
from Dolby Laboratories. Dolby and the double-D symbol are registered trademarks of Dolby Laboratories. All other
product names are trademarks or registered trademarks of their respective owners.
© THOMSON 2015. All rights reserved.
P2
4.0 STARTING UP FOR THE FIRST TIME 8
5.0 QUICK GUIDE TO USING YOUR RECEIVER 9
6.0 OPERATION 9
6.1 Changing channels 9
6.2 Info Banner 10
6.3 Selection of audio language 10
6.4 Teletext 10
6.5 Subtitles 10
6.6 Timeshift 11
6.7 EPG (Electronic Programme Guide) 11
6.8 Instant Recording 11
7.0 MAIN MENU 11
7.1 Edit Channel 12
7.2 Installation 14
7.3 System Setup 15
7.4 Tools 17
7.5 Games 19
7.6 Media 19
8.0 TROUBLESHOOTING 22
9.0 TECHNICAL SPECIFICATIONS 23
1.0 INTRODUCTION
1.1 Safety Instructions
DO NOT INSTALL YOUR RECEIVER:
In a closed or poorly ventilated cabinet; directly on top of or under any other equipment; on a
surface which might obstruct the ventilation slots.
DO NOT EXPOSE THE RECEIVER OR ITS ACCESSORIES:
• To direct sunlight or any other equipment that generates heat; to rain or intense moisture; to
intense vibration and to any shock which may cause permanent damage to your receiver or to any
magnetic objects, such as loudspeakers, transformers, etc.
• Do not use a damaged power cord. It may cause a fire or an electric shock. Do not touch a power
cord with wet hands. It may cause an electric shock.
• When the receiver is not used for a long period of time, you should unplug the power cord from
the wall socket.
• Do not use alcohol or ammonia based liquids to clean the receiver. If you wish, you may clean
your receiver with a soft lint-free cloth slightly made damp with a mild soap solution, and only
after disconnecting from the mains voltage supply. Make sure no foreign objects fall through the
ventilation slots because this could cause fire or an electric shock.
• Do not place any objects on top of the receiver because this might prevent proper cooling of the
components inside.
Safety Precautions
• Never try to open the receiver. It is dangerous to touch the inside of the receiver due to high
voltages and possible electrical hazards. Opening the receiver will void the warranty of the
product. Refer all maintenance or servicing to suitably qualified personnel.
• When you are connecting cables, be sure that the receiver is disconnected from the mains supply
voltage. Wait a few seconds after switching off the receiver before you move the receiver or
disconnect any equipment.
• It is a necessity that you only use an approved extension and compatible wiring that is suitable
for the electrical power consumption of the installed equipment. Please ensure that the electrical
power supply corresponds with the voltage on the electrical identification plate at the back of the
receiver.
If the receiver does not operate normally even after strictly following the instructions in the user
manual, it is recommended to consult your dealer or the appropriate service for your country.
1.2 Storage
Your receiver and its accessories are stored and delivered in a packaging designed to protect
against electric shocks and moisture. When unpacking it, make sure that all the parts are included
and keep the packaging away from children. When transporting the receiver from one place to
another or if you are returning it under warranty conditions, make sure to repack the receiver in its
original packaging with its accessories. Failing to comply with such packaging procedures could
damage the product and void your warranty.
INTRODUCTION
English
P3
1.3 Equipment Set-up
We recommend you consult a professional installer to set up your equipment. Otherwise, please
follow the instructions below:
• Refer to the user manual of your TV and, if applicable, your antenna.
• Make sure that the HDMI cable and, if applicable, outdoor components are in a good condition.
• If you use TV SCART connection, use then well shielded SCART cable.
This manual provides complete instructions for installing and using this receiver. The following
symbols will serve as follow.
Warning Indicates warning information.
Tips Indicates any other additional important or helpful information.
MENU Represents a button on the remote control or the receiver. (Bold characters)
Move to Represents a menu item within a window. (Italic characters)
1.4 Accessories
• Quick installation guide
• 1 remote control
• 2x batteries (AAA type)
WARNING: The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries. If rechargeable
accumulators instead of batteries are going to be used (e.g. NiMH), we
recommend using types with low self-discharge to ensure long time operation
of your remote control.
1.5 Usage of external USB devices
• It is recommended to use USB 2.0 storage devices or higher. If your device is not compatible to
USB 2.0 specifications, recording, playback and other multimedia functions of the receiver might
not work properly.
• To ensure best performance of your USB storage device please format it via your receiver (through
the menu “Media”) to FAT32 system. Other file systems are not supported by the receiver.
However, it is possible to use already NTFS formatted disks.
• THOMSON cannot guarantee compatibility with all types of USB storage devices.
• If you are going to use external USB HDDs (Hard Disk Drives), please consider that power
specifications may exceed the supported output of your receiver (max.5 V/800 mA). If so, please
connect your USB HDD to an according external power adapter.
• It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver.
THOMSON will not take responsibility for any loss of information or circumstances caused by loss
of information.
P4
INTRODUCTION
2.0 YOUR RECEIVER
2.1 DEFAULT PIN: 1234
2.2 Front Panel
1. IR sensor Point your remote control towards this sensor.
2. 4 digits display: Indicates current time in STANDBY mode
Indicates current channel number in OPERATING mode
3. Mode indicator RED indicates that the receiver is in STANDBY mode.
GREEN indicates that the receiver is in OPERATING mode.
4. USB Connector for USB storage devices.
2.3 Rear Panel
1. ANT IN To connect to your antenna for reception of broadcasted signals.
2. ANT OUT To connect the terrestrial antenna signal to your TV set. This
3. S / PDIF Coaxial: To connect your receiver to a digital home theatre, AV receiver or
4. HDMI To connect your receiver with your TV set using an HDMI cable.
5. TV SCART To connect your receiver with your TV set using a SCART cable.
6. Audio L/R To connect your receiver to an analogue audio amplifier.
7. Power cord Your receiver requires a supply voltage of 220 – 240 V AC
connection will allow you to watch digital terrestrial programmes
depending on the tuner of your TV and local broadcast
conditions
digital audio amplifier.
(Auto-selectable), 50/60Hz ±5%. Please ensure the local power
specification meets these requirements before connecting your
receiver to the wall outlet.
2.4 Remote control
1. q Switches the receiver On/Standby
2. Mutes all audio outputs of the receiver
3. PG+/PG- Page up/down in all list modes
4. DTV/VCR No function
5. INFO Opens the current channel information; 2x opens the current
6. VOL+/VOL- Increases/decreases the volume level
7. MENU Opens the main menu, in a menu you will get one step back
8. EXIT Exits from the menu or sub-menu
9. pq Menu Off: Change channel to next/previous.
event information and 3x the signal information
Menu On: Moves the cursor up/down.
YOUR RECEIVER
English
Fig. 1
Fig. 2
Fig. 3
P5
Loading...