Texas Instruments LP339DR, LP339D, LP339N, LP2901N, LP2901DR Datasheet
...
LP239, LP339, LP2901
LOW-POWER QUAD DIFFERENTIAL COMPARATORS
SLCS004A – OCTOBER 1987 – REVISED MA Y 1988
D
Ultralow Power Supply Current
Drain ...60 µA Typ
D
Low Input Biasing Current...3 nA
D
Low Input Offset Current...±0.5 nA
D
Low Input Offset Voltage . . . ±2 mV
D
Common-Mode Input Voltage Includes
Ground
D
Output Voltage Compatible With MOS and
CMOS Logic
D
High Output Sink-Current Capability
(30 mA at V
D
Power Supply Input Reverse-Voltage
= 2V)
O
D, J, OR N PACKAGE
(TOP VIEW)
1OUT
2OUT
2IN –
2IN +
1IN –
1IN +
1
2
V
3
CC
4
5
6
7
14
13
12
11
10
9
8
3OUT
4OUT
GND
4IN +
4IN –
3IN +
3IN –
Protected
D
Single-Power-Supply Operation
D
Pin-for-Pin Compatible With LM239, LM339,
LM2901
description
The LP239, LP339, LP2901 are low-power quadruple differential comparators. Each device consists of four
independent voltage comparators designed specifically to operate from a single power supply and typically to
draw 60-µA drain current over a wide range of voltages. Operation from split power supplies is also possible
and the ultralow power supply drain current is independent of the power supply voltage.
Applications include limit comparators, simple analog-to-digital converters, pulse generators, squarewave
generators, time delay generators, voltage controlled oscillators, multivibrators, and high-voltage logic gates.
The LP239, LP339, LP2901 were specifically designed to interface with the CMOS logic family. The ultralow
power supply current makes these products desirable in battery-powered applications.
The LP239 is characterized for operation from – 25°C to 85°C. The LP339 is characterized for operation from
0°C to 70°C. The LP2901 is characterized for operation from – 40°C to 85°C.
AVAILABLE OPTIONS
PACKAGE
T
A
0 °C to 70 °C ±5 mV LP339D LP339N LP339J
– 25 °C to 85 °C ±5 mV LP239D LP239N LP239J
– 40 °C to 85 °C ±5 mV LP2901D LP2901N LP2901J
The D package is available taped-and-reeled. Add R suffix to device type when ordering (e.g., LP339DR).
VIOmax AT 25°C
SMALL OUTLINE PLASTIC DIP CERAMIC DIP
(D) (N) (J)
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
Copyright 1988, Texas Instruments Incorporated
1
LP239, LP339, LP2901
LOW-POWER QUAD DIFFERENTIAL COMPARATORS
SLCS004A – OCTOBER 1987 – REVISED MA Y 1988
schematic diagram (each comparator)
V
CC
IN +
IN –
0.2 µA
5 µA
0.2 µA
6 µA
OUT
GND
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)
Supply voltage, V
Differential input voltage, V
Input voltage range, V
Input current, V
Duration of output short-circuit to ground (see Note 4) Unlimited. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Continuous total dissipation (see Note 5) See Dissipation Rating Table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operating free-air temperature range, T
Storage temperature range – 65°C to 150°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Lead temperature range 1,6 mm (1/16 inch) from case for 10 seconds: D or N package 260°C. . . . . . . . . . .
Lead temperature range 1,6 mm (1/16 inch) from case for 60 seconds: J package 300°C. . . . . . . . . . . . . . . .
†
Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated in the recommended operating conditions is not implied.
Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. All voltage values, except differential voltages, are with respect to the network ground.
2. Differential voltages are at IN+ with respect to IN –.
3. This input current only exists when the voltage at any of the inputs is driven negative. The current flows through the collector-base
junction of the input clamping device. In addition to the clamping device action, there is lateral n-p-n parasitic transistor action. This
action is not destructive and normal output states are re-established when the input voltage returns to a value more positive than
– 0.3 V at TA = 25°C.
4. Short circuits between outputs to VCC can cause excessive heating and eventual destruction.
5. If the output transistors are allowed to saturate, the low bias dissipation and the on-off characteristics of the outputs keep the
dissipation very small (usually less than 100 mW).
(see Note 1) 36 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CC
I
≤ – 0.3 V (see Note 3) – 50 mA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
I
(see Note 2) ±36 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ID
(either input) – 0.3 V to 36 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
: LP239 – 25°C to 85°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
A
LP339 0°C to 70°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
LP2901 – 40°C to 85°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
†
DISSIPATION RATING TABLE
PACKAGE
D
J
N
2
TA ≤ 25°C
POWER RATING
950 mW
1025 mW
1150 mW
DERATING FACTOR
ABOVE TA = 25°C
7.6 mW/°C
8.2 mW/°C
9.2 mW/°C
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
TA = 70°C
POWER RATING
608 mW
656 mW
736 mW
TA = 85°C
POWER RATING
494 mW
533 mW
598 mW
UNIT
VICCommon-mode input voltage
VIInput voltage
VIOInput offset voltage
CC
,
O
,
mV
IIOInput offset current
nA
IIBInput bias current
See Note 7
nA
V
g
Single suppl
V
O
,
V
I
0
Output leakage current
I+
,
TTL logic swing, V
V
s
LOW-POWER QUAD DIFFERENTIAL COMPARATORS
SLCS004A – OCTOBER 1987 – REVISED MA Y 1988
recommended operating conditions
LP239 LP339 LP2901
MIN MAX MIN MAX MIN MAX
V
Supply voltage 5 30 5 30 5 30 V
CC
p
p
T
Operating free-air temperature – 25 85 0 70 – 40 85 °C
A
electrical characteristics, VCC = 5 V, TA = 25°C (unless otherwise noted)
PARAMETER TEST CONDITIONS T
V
p
p
p
Common-mode input voltage
ICR
range
Large-signal differential voltage
A
VD
amplification
Output sink current
p
V
Differential input voltage VI ≤ 0 (or VCC – on split supplies) 36 V
ID
I
Supply current RL = ∞ all comparators 60 100 µA
CC
†
Full range is –25°C to 85°C for the LP239, 0°C to 70°C for the LP339, and –40°C to 85°C for the LP2901.
NOTES: 6. VIO is measured over the full common-mode input voltage range.
7. Because of the p-n-p input stage, the direction of the current is out of the device. This current is essentially constant (i.e., independent
of the output state). No loading change exists on the reference or input lines as long as the common-mode input voltage range is
not exceeded.
8. The output sink current is a function of the output voltage. These devices have a bimodal output section that allows them to sink
(via a Darlington connection) large currents at output voltages greater than 1.5 V, and smaller currents at output voltages
less than 1.5 V.
= 5 V to 30 V, V
RS = 0,
pp
VCC = 15 V, RL = 15 kΩ 500 V/mV
VI – = 1 V,
+ =
V = 1 V,
VI – = 0
VCC = 5 V 0 3 0 3 0 3 V
VCC = 30 V 0 28 0 28 0 28 V
VCC = 5 V 0 3 0 3 0 3 V
VCC = 30 V 0 28 0 28 0 28 V
†
A
= 2 V,
See Note 6
y
V
= 2 V,
See Note 8
VO = 0.4 V 25°C 0.2 0.7
VO = 5 V 25°C 0.1 nA
VO = 30 V Full range 1 µA
25°C ±2 ±5
Full range
25°C ±0.5 ±5
Full range ±1 ±15
25°C – 2.5 – 25
Full range – 4 – 40
25°C
Full range
25°C 20 30
Full range 15
LP239, LP339, LP2901
MIN TYP MAX UNIT
±9
0 to
VCC – 1.5
0 to
VCC – 2
mA
switching characteristics, VCC = 5 V, TA = 25°C, R
Large-signal response time
Response time
connected to 5 V through 5.1 kΩ
L
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
= 1.4
ref
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
1.3
8
µ
3
Loading...