tekmar 007 User Manual

- Data Brochure

D 007

Adaptor Plate 007

The Adaptor Plate 007 allows for installation of a small enclosure Room Temperature Unit (RTU) or Indoor Sensor or Thermostat on to a 2” x 4” electrical box. The adapter plate can be mounted vertical or horizontal and is designed to allow wiring to feed through in any position. Included with the adaptor plate are surface painted screws for mounting to the 2” x 4” electrical box and screws to mount the RTU / Indoor Sensor to the plate.

05/07

Installation - Adaptor Plate 007

STEP ONE

Check the contents of this package. If any of the contents listed are missing or damaged, please contact your wholesaler or tekmar sales representative for assistance.

Type 007 includes: • One Adaptor Plate 007 • Two electrical cover screws • Two 5/16” screws • One Data Brochure D 007

STEP TWO

The Adaptor Plate is mounted onto a standard 2” x 4” electrical box using the supplied screws. Ensure the electrical box is properly insulated and protected from cold drafts. All required RTU or Indoor sensor wiring must be pulled through the existing top left hand hole of the adaptor plate. The adaptor plate may be mounted horizontally or vertically using the electrical cover screws provided.

STEP THREE

Insert the wiring through the hole provided in the back of the sensor or RTU enclosure, and connect them to the wiring terminals as described in the applicable Sensor / RTU Data Brochure. Attach the sensor or RTU to the adaptor plate using the supplied 5/16” screws.

Do not over tighten screws as the plastic molding may strip.

GETTING READY

MOUNTING THE PLATE

MOUNTING THE SENSOR / RTU ————————

Installation - Adaptor Plate 007

Thermostat

Base

007 Adaptor

Plate

Stud

Switch Box

3 1/4”

(83 mm)

+ 2 hidden pages