Tascam TM-ST1 User Manual

Description

The TASCAM TM-ST1 is configured
with an M/S stereo pattern for excellent
imaging and natural ambience.

The microphone pattern can be switched
to 90 for narrower coverage, such as a
solo instrument or voice, or 120 for
orchestra, choir or stage performance.

The TM-ST1 is suitable for digital
recordings of concerts, meetings and
events.

Inserting Battery Steps

1. Unscrew the microphone rear cover.

2. Remove the body shell to expose the battery holder.

3. Insert the battery according to the polarity markings.

Power Switch

When powering on the microphone, the Power LED
flashes once then goes off to extend battery life. When the
light no longer turns on, you need to change the battery.

Features

! M/S stereo space, for natural and clear stereo sound

image.

! Coverage can be switched between 90 and 120

! 3.5mm stereo plug.

! Light weight body with professional clip, convenient

for carrying and set-up.

Specifications

Type:

Polar pattern:

Frequency response:

Sensitivity:

Nominal Impedance:

Min load impedance:

Single point stereo (Mid-Side
arrangement), electret
condenser microphones

Cardioid for Mid, and figure of 8
for Side. Coverage at 90 or 120

100~15,000Hz

-45dBV/Pa @120 setting.
Channel difference within 3dB

1k ohm 20% at 1kHz

2k ohm

The AA battery generally provides approximately 200
hours of use under normal circumstances. This can vary
from user to user.

Precautions

1. Insert the battery correctly

2. Do not charge the battery

3. Remove the battery if the microphone will not be used
for a long period of time.

4. If the battery leaks, clean the battery holder before
inserting a new battery.

Connection

Switch off the microphone and insert the 3.5mm stereo
plug into the microphone input of your recording device.

Max. SPL:

Dynamic range:

Power Source:

Power consumption:

Battery lifetime:

Output connector:

Weight:

110dB

85dB

1.5V Battery (AA)

4mA

approx. 200 hours

3.5mm stereo plug

110g(including battery)

Accessories

The TM-ST1 includes a microphone clip and tabletop
stand. To use the clip with a microphone stand, the mic
clip comes with 3/8" and 5/8" adapter screws. A
windscreen is also provided to reduce breath or wind
noise.