TANDBERG RX8310, RX8315, RX8330 User Manual

ST.US.E10274.1

USER GUIDE

RX8310/RX8315/RX8330

Distribution Receiver

Software Version 1.3.0

RX8310/15/30

Distribution Receivers

ENGLISH (UK)

www.tandbergtv.com

RX8310/RX8315/RX8330 Distribution Receiver

Trademarks

Dolby® / Dolby® Digital / AC-3® are registered trademarks of Dolby Laboratories Licensing
Corporation.

Customer Services

Europe, Middle East Tel: [phone]
and Africa: Fax: [phone]
[e-mail]

Americas: Tel: [phone] (US and Canada)
Tel: [phone] (Outside of mainland US)
[e-mail]

China: Tel: [phone] (Beijing)
Tel: [phone] (Hong Kong)
[e-mail]

Australia/NZ: Tel: [phone]
[e-mail]

Internet Address: http://www.tandbergtv.com

Technical Training

International: Tel: [phone]
Fax: [phone]
[e-mail]

2

This document and the information contained in
it is the property of TANDBERG Television Ltd
and may be the subject of patents pending and
granted. It must not be used for commercial
purposes nor copied, disclosed, reproduced,
stored in a retrieval sys tem or transmitted in
any form or by any means (electronic,
mechanical, photocopying, recording or
otherwise), whether in whole or in part, without
TANDBERG Television’s prior written agreement.

© 2009 TANDBERG Television Ltd.
All rights reserved.

Issue 1 first published in 2009 by:

TANDBERG Television Ltd

Registered Address:
Unit 2 Strategic Park, Comines Way,
Hedge End, Southampton,
Hampshire,
SO30 4DA
United Kingdom

Registered Company Number 03695535

RX8310/RX8315/RX8330 Distribution Receiver

Contents

1 Who Should Use This User Guide? ...........................................................................5

1.1 What Equipment is Covered by This User Guide?........................................................5

1.2 Hardware and Software Options....................................................................................5

2 Installing the Equipment .............................................................................................7

2.1 Introduction ....................................................................................................................7

2.2 Operating Voltage..........................................................................................................7

2.3 Power Cable and Earthing.............................................................................................7

2.4 Rear Panel Connectors..................................................................................................7

2.5 Connecting the Receiver to the Power Supply............................................................10

3 Operating the Equipment From the Front Panel.....................................................11

3.1 Introduction ..................................................................................................................11

3.2 Receiver Front Panel ...................................................................................................11

3.3 Using the Front Receiver Panel Menu System............................................................11

4 Operating the Equipment From A Web Browser....................................................13

4.1 Introduction ..................................................................................................................13

4.2 Receiver Web Browser Interface.................................................................................13

4.3 Using the Receiver Web Browser Interface.................................................................14

4.4 Page Structure.............................................................................................................14

5 Quick Start Guide - Using the Front Panel Control................................................17

5.1 Making Signal Connections to the Unit........................................................................17

5.2 Configuring the Inputs..................................................................................................17

5.3 Selecting a Decode Service (Program) .......................................................................18

5.4 Configuring the Video Output.......................................................................................19

5.5 Configuring the Audio Outputs.....................................................................................19

5.6 Configuring for Single-service Decryption ...................................................................19

5.7 Configuring for Multi-service Decryption......................................................................19

6 Equipment Packaging ...............................................................................................20

6.1 Packaging Statement...................................................................................................20

6.2 Packaging Markings.....................................................................................................20

7 Materials Declarations...............................................................................................22

7.1 Overview ......................................................................................................................22

7.2 For the European Union...............................................................................................22

7.3 For China .....................................................................................................................22

3

RX8310/RX8315/RX8330 Distribution Receiver

8 Disposal of this Equipment.......................................................................................23

8.1 General.........................................................................................................................23

8.2 For the European Union...............................................................................................23

9 Recycling ....................................................................................................................24

List of Figures

Figure 2.1: Rear Panel Connectors (RX8310/BAS)................................................................8

Figure 2.2: Rear Panel Connectors (RX8315/BAS with RX83XX/HWO/IP) ...........................8

Figure 2.3: Rear Panel Connectors (RX8330/BAS with RX83XX/HWO/IP) ...........................9

Figure 3.1: Front Panel LEDs and Pushbuttons....................................................................11

Figure 4.1: Example Status Tab - Web Control for an RX8310 Receiver.............................14

List of Tables

Table 1.1: Equipment Model Descriptions...............................................................................5

Table 1.2: RX8310/RX8315/RX8330 Hardware Options........................................................5

Table 1.3: RX8310/RX8315/RX8330 Software Option............................................................6

Table 1.4: RX8310/RX8330 Specific Software Options..........................................................6

Table 1.5: RX8315/RX8330 Specific Software Options..........................................................6

Table 2.1: Types of Connector................................................................................................9

Table 2.2: Fuse Type and Rating..........................................................................................10

4

RX8310/RX8315/RX8330 Distribution Receiver

1 Who Should Use This User Guide?

This User Guide is written for operators/users of the RX8310, RX8315 and
RX8330 Distribution Receivers to assist in installation and operation.

WARNING

Do not remove the covers of this equipment. Hazardous voltages are
present within this equipment and may be exposed if the covers are
removed. Only TANDBERG Television trained and approved service
engineers are permitted to service this equipment.

CAUTION

Unauthorised maintenance or the use of non-approved replacements
may affect the equipment specification and invalidate any warranties.

1.1 What Equipment is Covered by This User Guide?

Table 1.1: Equipment Model Descriptions

Model Number Marketing Code Description

RX8310 RX8310/BAS Distribution Receiver. DVB-S2,

RX8315 RX8315/BAS Distribution Receiver. DVB-S2, Common

RX8330 RX8330/BAS Distribution Receiver. DVB-S2, Common

Director V5 CA, ac mains voltage input.

Interface CA, Director V5 CA, ac mains
voltage input.

Interface CA, Director V5 CA, SDI output,
ac mains voltage input.

1.2 Hardware and Software Options

Table 1.2: RX8310/RX8315/RX8330 Hardware Options

Marketing Code Description

RX83XX/HWO/IP/OUT Dual gigabit IP output card

5

RX8310/RX8315/RX8330 Distribution Receiver

Table 1.3: RX8310/RX8315/RX8330 Software Option

Marketing Code Description

RX83XX/SWO/DVBS2/QPSK DVB-S2 QPSK License key
RX83XX/SWO/DVBS2/8PSK DVB-S2 8PSK License key
RX83XX/SWO/DVBS2/LSYM DVB-S2 Low Symbol Rate License Key
RX83XX/SWO/PW Password Protection for Web Browser
RX83XX/SWO/MPEG2/SD MPEG-2 SD decoding
RX83XX/SWO/MPEG2/HD MPEG-2 HD decoding and MPEG-2 HD down

RX83XX/SWO/MPEG4/SD MPEG-4 AVC SD decoding
RX83XX/SWO/MPEG4/HD MPEG-4 AVC SD decoding and MPEG-4 AVC HD

RX83XX/SWO/AC3

conversion

down conversion
Dolby Digital ® decoding / downmixing

Table 1.4: RX8310/RX8330 Specific Software Options

Marketing Code Description

RX83XX/SWO/DIR5/MSD TANDBERG Director 5 Multi-Service License key

Table 1.5: RX8315/RX8330 Specific Software Options

6

Marketing Code Description

RX83XX/SWO/MSD TANDBERG Common Interface Multi-Service License

key

RX8310/RX8315/RX8330 Distribution Receiver

2 Installing the Equipment

2.1 Introduction

Use this User Guide for guidance on installation and operation. Only use
installation accessories recommended by the manufacturers.

2.2 Operating Voltage

CAUTION

This product should be operated only from the type of power source
indicated on the marking label. If you are not sure of the type of power
supply to your business, consult a qualified electrical engineer or your
local power company.

AC Models
AC models are fitted with a wide-ranging power supply. It is suitable for supply

voltages of 100-240 V ac -10% +6% at 50/60 Hz nominal.

2.3 Power Cable and Earthing

Check that the power cable is suitable for the country in which the Receiver is to
be used.

WARNINGS

1. The Technical Earth is not a protective earth for electric
shock protection.

2. This unit must be correctly earthed through the moulded
plug supplied. If the local mains supply does not have an
earth conductor do not connect the unit. Before connecting
the unit to the supply, check the supply requirements.
Contact Customer Services for advice.

2.4 Rear Panel Connectors

Always use the specified cables supplied for signal integrity and compliance with
EMC requirements (see Reference Guide).

7

RX8310/RX8315/RX8330 Distribution Receiver

A

A

A

A

A

A

A

A

A

RF IN 1,2,3,4

SI INPUT

SI OUT

CVBS

ETHERNET 1 & 2

Figure 2.1: Rear Panel Connectors (RX8310/BAS)

RF IN 1,2,3,4 IP OUT 1 & 2

UDIO OUT 1 & 2

LARM

UDIO OUT 1 & 2

TECHNICAL

EARTH

TECHNICAL

EARTH

8

CONDITIONAL ACCESS INTERFACE

SI OUT CVBS

SI INPUT

ETHERNET 1 & 2
or
CONTROL 1 & 2

LARM

Figure 2.2: Rear Panel Connectors (RX8315/BAS with RX83XX/HWO/IP)

CONDITIONAL

CCESS

INTERFACE